评定飞航导弹单发命中概率的方法研究

通过对抽样检验方法的研究,确立了区间估计的下限公式,用来在已知样本值的情况下确定导弹单发命中概率出现在该区间内的置信水平和精确度。     

Mixed waste ferrite as a novel sorbent for carbon dioxide derived from flue gases

Ferrite is a potential sorbent for flue gases such as CO₂, H₂S and SO₂. This paper discusses the adsorption and decomposition of CO₂ into carbon by hydrogen-activated waste ferrites prepared from Berkeley Pit acid mine water (Butte, MT). The decomposition effectiveness of these waste ferrites was studied at 300 °C and compared with the synthetic magnetite obtained from ferrous sulfate solution in our laboratory. The decomposition was measured by two methods: indirectly by measuring the adsorption rate of CO₂ and directly by analysing the carbon deposited on the samples. The results indicated that the mixed waste ferrite had good affinity for the adsorption and decomposition. The CO₂ decomposition data of both sorbents fitted the first-order reaction kinetics. Even though the surface area of the magnetite was higher than that of waste ferrite, the CO₂ decomposition rate of the waste ferrite was estimated to be 2.5 times higher than that of magnetite under identical conditions. The carbon analysis deposited on the sample indicated that the CO₂ was 100% decomposed into carbon and other carbon/hydrogen compounds by the waste ferrite, whereas the conversion was 43% by the magnetite. In terms of specific adsorption of carbon, ferrite was three to five times more efficient than magnetite.     

岩石爆破的逾渗模型

本文在分析几种典型的岩石爆破损伤模型的基础上，发现岩石爆破损伤演化具有明显的逾渗效应。采用逾渗来描述岩石爆破损伤断裂这一动态过程是可行的，并提出了进一步可能的研究途径。     

An alternative approach to weight function evaluation for an orthotropic crack

The use of the analytically decoupled near-tip displacement solutions as an alternative approach, is presented in this paper for the efficient finite element evaluation of the decoupled weight functions for an orthotropic 2-D crack. This alternative approach has been validated by directly comparing the prior weight function results with a symmetric mesh approach in the crack-tip neighborhood, and indirectly by comparing the calculated stress intensity factors (K_I(II)) values using the computed weight functions with available K_I(II) solutions of the 2-D mixed mode orthotropic cracks. In addition, this approach with analytically decoupled near-tip displacement solutions for calculating weight functions at all locations, can facilitate further extension of weight function evaluations to a more general 2-D anisotropic crack.     

低压铝箔交流腐蚀研究

在３０Ｈｚ频率下，通过铝箔在ＨＣｌ＋Ｈ２ＳＯ４＋ＨＮＯ３＋Ｈ３ＰＯ４体系中的交流腐蚀，研究腐蚀液组成中腐蚀主体及缓蚀剂对铝箔腐蚀的作用，探讨腐蚀过程中电源频率、腐蚀液温度、电流密度及腐蚀时间对铝箔腐蚀的影响。腐蚀液组成的配比恰当，有利于比容的提高。在特定的频率下采用合适的腐蚀液温度、适宜的电流密度和腐蚀时间可以提高铝箔的静电容量。     

光孤子相互作用对压缩态的影响

在线性近似条件下，量子化了非线性薛定谔方程，用后向传播法数值求解了光孤子相互作用对压缩比的影响。数值结果表明，在碰撞距离附近，压缩比显著增加。     

Study on the dispersion characteristic of the plasma-loaded relativistic BWO

The dispersion characteristic of the plasma-loaded relativistic backward wave oscillator has been analyzed. The theoretical model has been established and the numerical calculations accord with the experimental results, which provides some useful suggestions on the designing of slow-wave structure of BWO.     

LaCrMnNiO系热敏陶瓷的微观结构控制

通过对不同配方、工艺下的ＬａＣｒＭｎＮｉＯ系热敏陶瓷的微观结构研究，指出材料的相组成对其宏观电性能的影响，并提出了通过复合工艺利用“过渡相”的形成，对材料的“最终相”加以控制的方法。文中列出了使用ＸＲＤ及ＸＰＳ手段对材料微观结构的分析结果及有关电性能的测试数据。