Correlation of the loss in photovoltaic module performance with the ageing behaviour of the backsheets used

The influence of the type of backsheet on the electrical performance of test modules was evaluated before and after increasing time of accelerated ageing (damp heat [DH] exposure). Besides the measurement of the electrical power of the modules and the performance of the cells by electroluminescence, the ageing‐induced changes within the polymeric encapsulate and backsheets were investigated by means of vibrational spectroscopy and by thermo analytical methods. In addition, the permeability of the backsheets in the original and aged state was determined. This wide set of test parameters and methods allowed for the detection of correlations between (i) physical and chemical properties as well as their ageing‐induced changes of the materials and (ii) the module performance. A clear dependence of the relative loss in power output upon exposure under DH conditions for 2000 h could be observed for a set of identical test modules varied in composition only in the type of back cover used. While the modules containing gas‐tight backsheets and glass experienced only little loss in the relative power output, some modules with permeable backsheets showed a significant relative decrease in the power output and fill factor in dependence of the backsheet type used. Cell degradation could be visualised by recording electroluminescence images before and after the accelerated ageing test. The permeation properties of the backsheet used and their ageing‐induced changes seem to have an influence on the module performance. However, the absolute values neither of the water vapour transmission rate (WVTR) nor of the oxygen transmission rate (OTR) are directly linked to the loss in power output upon accelerated ageing under DH conditions. It could be shown that the ageing‐induced changes (relative transmission rates) between WVTR and OTR can be correlated with the module performance. These ageing‐induced changes in the permeation behaviour of the backsheets can be explained by (i) physical changes (e.g. post‐crystallisation, changes in the crystal structure or the crystalline microstructure) and (ii) chemical ageing effects such as a decrease in the molecular mass of the polyester (PET) polymer chains because of hydrolytic polymer degradation leading to a change in the crystallisation behaviour of PET. Hydrolytic degradation (= chemical ageing) of the PET core layer was observed (with varying extent) for all PET‐based backsheets and can, thus, not be directly correlated with the loss in performance of the corresponding test modules. The physical ageing effects, however, were detected only for those backsheets showing (i) strong deviating changes in the relative permeation rates for oxygen and water vapour upon accelerated ageing and (ii) a clear loss in electrical performance. Copyright © 2015 John Wiley & Sons, Ltd.     

Lineament mapping for groundwater resource assessment: A comparison of digital Synthetic Aperture Radar (SAR) imagery and stereoscopic Large Format Camera (LFC) photographs in the Red Sea Hills,Sudan

The results of a comparative investigation of lineament mapping from stereoscopic Large Format Camera (LFC) photographs and from SIR-C L- and C-band Synthetic Aperture Radar (SAR) data are described. The lineament patterns are used to test a model developed by Koch (1993) of groundwater flow in the arid Red Sea Hills area of Sudan. Initial results show that the LFC imagery is most useful for mapping detailed fracture patterns while the combination of the L- and C-bands of the SIR-C Synthetic Aperture Radar is helpful in the location of major deep-seated fracture zones. The lineament patterns derived from LFC and SIR-C show strong N-S and E-W orientations, which correspond to the current tectonic configuration of the Red Sea rift system. The longer E-W trending features may be important from a regional hydro-geological point of view, whereas the shorter features are significant in that they interconnect the major faults.     

Submicron droplet formation in the human lung

The exhaled breath of humans contains droplets originating from the lung lining fluid. An analysis of these droplets for non-volatile proteinaceous biomarkers holds potential as a non-invasive diagnosis of lung diseases. To ease the interpretation of the diagnostic results, the source strength of the particles should be known und therefore an understanding of the particle generation process is required. It is assumed that during reopening of a collapsed terminal airway a liquid bridge of the lung lining fluid ruptures and droplets are generated. The objective of our experimental and theoretical study was to clarify the mechanisms of droplet generation for quiet breathing patterns by investigating in detail the number flux and the particle size distribution in the exhaled breath. The process of liquid film rupture is modelled by computational fluid dynamics analysis from which the droplet size distribution is calculated. In addition the number emission flux and the droplet size distribution are systematically measured in the exhaled breath of healthy volunteers. The strong increase of the particle emission flux with tidal volume and the good agreement between measured and calculated droplet number distribution both showing droplets primarily in the submicron range confirm the present hypothesis that reopening of collapsed airway structures associated with the rupture of a surfactant film is the physical mechanism of droplet generation. This was hypothesized previously in the literature.     

Dual-plane ultrafast limited-angle electron beam x-ray tomography

Electron beam x-ray tomography is an imaging technique, which can provide cross-sectional images of an object of interest with about 1 mm spatial resolution at frame rates of up to 10,000 frames per second. As a non-intrusive method it is especially suited for studying multiphase flows. For this purpose we devised an experimental limited-angle scan setup which utilizes linear beam deflection to generate radiographic projections. This setup was employed in the study of gas–liquid flow in an experimental flow loop operated at different liquid and gas flow rates. Electron-beam tomography images were compared with image data of a wire-mesh sensor. The latter is a fast but intrusive imaging device which is commonly used in gas–liquid flow imaging and achieves comparable frame rates but at lower spatial resolution. As a novelty we implemented a dual-plane limited-angle electron beam x-ray tomography which allows us to gain information about the phase velocities using cross-correlation data analysis.     

Impact of the coating process on the molecular structure of starch‐based barrier coatings

Molecular analysis of starch structure can be used to explain and predict changes in physical properties, such as water vapor and oxygen barrier properties in packaging materials. Solution casting is a widely used technique to create films from starch formulations. This study compared the molecular properties of these standard films with those of experimental coatings applied to paper in laboratory‐scale and pilot‐scale trials, with all three techniques using the same starch formulation. The results revealed large differences in molecular structure, i.e., cross‐linking and hydrolysis, between films and coatings. The main differences were due to the shorter drying time allowed to laboratory‐scale coatings and the accelerated drying process in pilot trials owing to the high energy output of infrared dryers. Furthermore, surface morphology was highly affected by the coating technique used, with a rougher surface and many pinholes occurring in pilot‐scale coatings, giving lower water vapor permeability than laboratory‐scale coatings. © 2014 Wiley Periodicals, Inc. J. Appl. Polym. Sci. 2014 , 131, 41190.     

Mechanistic Insights into Cyclic Peptide Generation by DnaE Split-Inteins through Quantitative and Structural Investigation

Inteins carry out protein-splicing reactions, which are used in protein chemistry, protein engineering and biotechnological applications. Rearrangement of the order of the domains in split-inteins results in head-to-tail cyclisation of the target sequence, which can be used for genetic encoding and expression of libraries of cyclic peptides (CPs). The efficiency of the splicing reaction depends on the target sequence. Here we used mass spectrometry to assess in vivo cyclic peptide formation from different hexameric target sequences by the DnaE split-inteins from Synechocystis sp. and Nostoc punctiforme, revealing a strong impact of the target sequence and of the intein on the intracellular peptide concentration. Furthermore, we determined the crystal structures of their pre-splicing complexes, which allowed us to identify F-block Asp17 as crucial for the DnaE-mediated splicing reaction.     

Quantification of the Alternaria mycotoxin tenuazonic acid in beer

Tenuazonic acid (TA) is a major water soluble Alternaria mycotoxin. In the present work, a method for the quantification of TA in beer by liquid chromatography–ion-trap multistage mass spectrometry after derivatization with 2,4-dinitrophenylhydrazine is described. The method is based on a rapid workup procedure and features a LOD of 2 μg/kg without preconcentration using 400 mg of sample. Validation was performed for a working range of 8–500 μg/kg.     

CommunityMirrors als Informationsstrahler in Unternehmen

Informations- und Kooperationssysteme nutzen heute meist Desktoparbeitspl?tze oder Laptops als prim?re Schnittstelle zu Benutzern. Dies führt zu Problemen bei der Integration in den sozialen Kontext realer Arbeitsumgebungen sowie zu Defiziten bei der Versorgung mit Information, nach der nicht aktiv gesucht wird. Mit dem Konzept der CommunityMirrors stellen wir eine Erg?nzung zu heutigen (modularen und anpassbaren) Informationssystemen vor, die eine Integration in reale Arbeitsumgebungen erlaubt und so verschiedene Potenziale bezüglich der Sichtbarkeit von Information und der Kollaboration rund um Information realisiert. Die Grundidee von CommunityMirrors besteht darin, in IT-Systemen enthaltene Information jenseits klassischer Desktoprechner sichtbar, greifbar und erlebbar zu machen und so eine in den sozialen Kontext eingebettete Benutzungsschnittstelle als ,,Informationsstrahler“ bereitzustellen. Neben der Vorstellung des Grundkonzeptes und der Potenziale dieser Idee pr?sentieren wir im Folgenden auch erste Erkenntnisse und Anregungen zur Umsetzbarkeit in der Praxis, die in verschiedenen Feldtests in den vergangenen Jahren gewonnen wurden.