Formation of high-purity organic thin films by gas flow deposition and the effect of impurities on device characteristics

A gas flow deposition (GFD) system was developed to manufacture large-scale organic light-emitting diodes (OLEDs). A N,N′-di(1-naphthyl)-N,N′-diphenylbenzidine (α-NPD) thin film with a high purity of 99.97% was obtained using the GFD system. The film properties such as morphology, and electrical and optical characteristics were almost the same as those of films made by conventional vacuum thermal evaporation.     

Passive piezoelectric single-side MEMS DC current sensor with five parallel PZT plates applicable to two-wire DC electric appliances without using cord separator

A passive (power-less), non-contact macro-scale piezoelectric bimorph DC current sensor to satisfy the increasing needs of DC power supply for monitoring the electricity consumption by either one-wire or two-wire appliance cord was proposed at our laboratory previously. In present study however, a MEMS-scale piezoelectric single-side DC current sensor, comprised of five parallel PZT plates, was further proposed and micro-fabricated for preliminarily examination. A micro magnet was fixed by manipulator onto the PZT cantilever tip to the theoretically pinpointed position of the center plate. Different from the results of the macro-scale piezoelectric bimorph DC current sensor, impulsive piezoelectric output voltages accompanying with a gradual decrease in decay were detected when the applied DC electric current was varied from 0.5 to 2.5 A. A linear relationship between the detected peak value of the impulse output voltage and the applied DC electric current was also obtained but with a higher slope compared to the result of the macro-scale piezoelectric bimorph DC current sensor.     

Observations of bound Tween80 surfactant molecules on single-walled carbon nanotubes in an aqueous solution

The slow diffusion of Tween80 surfactant molecules in a single-walled carbon nanotube (SWCNT) aqueous dispersion was directly observed using the pulsed field gradient nuclear magnetic resonance method. The slow diffusion of Tween80 molecules was attributed to the strongly adsorbed molecules on the SWCNTs in the aqueous dispersion. The amount of bound Tween80 molecules was estimated to be approximately 12% of the total amount of Tween80 molecules, contributing to the stability of the SWCNT aqueous dispersion. Using dynamic light scattering and total organic carbon measurements, this SWCNT/Tween80 aqueous dispersion was found to be very stable for at least 3 weeks. The observed zeta potentials of this SWCNT dispersion are between −10 and 0 mV, indicating that the stability of the SWCNTs in the Tween80 solution was maintained by steric interactions between the small amount of adsorbed Tween80 molecules on the SWCNTs, while the effect of electrostatic interactions between adsorbed Tween80 was minimal. This proposed method to investigate the amount of bound Tween80 molecules on SWCNTs has potential benefits in the field of the production of functional materials and nano-toxicity assessments.     

Hydrothermal Corrosion of Alumina Ceramics

The corrosion behavior and strength degradation of alumina ceramics with 99%, 99.9%, and 99.99% Al₂O₃ were studied in water at 300°C and 8.6 MPa for 1 to 10 d. The weight loss in alumina ceramics was mainly attributed to the dissolution of SiO₂ and Na₂O grain-boundary impurities. Intergranular corrosion proceeded in the alumina ceramics by preferential attack at the grain boundaries. The extent of the strength reduction for corroded alumina ceramics was related to the impurity level in the alumina ceramics.     

Health-monitoring technologies for alumina-fiber-reinforced plastics

Transmitted light could detect matrix cracks that occurred in the early stages of fracture of alumina-fiber-reinforced plastics (alumina-FRPs); these cracks could not be detected by acoustic emission (AE). An optical-fiber Bragg grating (FBG) sensor could detect the matrix cracks but it must be embedded in the FRPs. To determine which wavelength is sensitive to the defects in the FRP, the spectra of the transmitted and reflected light were measured. The intensity of the transmitted light, especially in the visible region (wavelength: 400–800 nm), decreased as the bending stiffness of the test piece decreased. It is thus concluded that to monitor the decrease in bending stiffness of FRPs, a simple sensor using a visible ray is good enough. And this transmitted-light NDE technique can work in the strong electromagentic field associated with a superconductor. It will therefore be useful for detecting defects in the FRP of the load-support system in service.     

Geochemical study on mineral precipitation from geothermal waters at the fushime field, Kyushu, Japan

The fluids in the Fushime geothermal system, Kyushu, Japan, are hot and saline, and most likely originate from seawater-rock interaction. The type of scale precipitated from the waters differs according to its location in the flow test facilities. Galena and sphalerite are commonly the predominant minerals in the scale coating the insides of the two-phase lines and amorphous silica tends to be dominant in the sections further downstream. Anhydrite has been found to precipitate in a specific zone of a production well where relatively cool sulfate-rich water is believed to mix with ascending hot sulfate-depleted water.     

Relationship between Expression of Onco-Related miRNAs and the Endoscopic Appearance of Colorectal Tumors

Accumulating data indicates that certain microRNAs (miRNAs or miRs) are differently expressed in samples of tumors and paired non-tumorous samples taken from the same patients with colorectal tumors. We examined the expression of onco-related miRNAs in 131 sporadic exophytic adenomas or early cancers and in 52 sporadic flat elevated adenomas or early cancers to clarify the relationship between the expression of the miRNAs and the endoscopic morphological appearance of the colorectal tumors. The expression levels of miR-143, -145, and -34a were significantly reduced in most of the exophytic tumors compared with those in the flat elevated ones. In type 2 cancers, the miRNA expression profile was very similar to that of the exophytic tumors. The expression levels of miR-7 and -21 were significantly up-regulated in some flat elevated adenomas compared with those in exophytic adenomas. In contrast, in most of the miR-143 and -145 down-regulated cases of the adenoma-carcinoma sequence and in some of the de novo types of carcinoma, the up-regulation of oncogenic miR-7 and/or -21 contributed to the triggering mechanism leading to the carcinogenetic process. These findings indicated that the expression of onco-related miRNA was associated with the morphological appearance of colorectal tumors.     

Effect of Surface Treatment on the Selective Photocatalytic Oxidation of Benzyl Alcohol into Benzaldehyde by O2 on TiO2 Under Visible Light

The photocatalytic oxidation of benzyl alcohol into benzaldehyde proceeded with high conversion and selectivity on a TiO₂ photocatalyst by O₂ under visible light irradiation. Surface complex formed by the interaction of benzyl alcohol with the Ti sites and/or surface OH groups of TiO₂ play an important role in the absorption of visible light and unique selective photocatalytic reaction.