Convergence analysis of hybrid bi-directional associative memory neural networks with discrete delays

In this paper, the dynamical characteristics of hybrid bi-directional associative memory (BAM) neural networks with constant transmission delays are investigated. Without assuming the symmetry of synaptic connection weights and the monotonicity and differentiability of activation functions, the Lyapunov functionals are constructed and Halanay-type inequalities are respectively employed to derive the delay-independent sufficient conditions under which the networks converge exponentially to the equilibria associated with temporally uniform external inputs. Some examples are given to illustrate that the results are less conservative and less restrictive than the previously known results.     

A PLL clock generator with 5 to 10 MHz of lock range formicroprocessors

A microprocessor clock generator based on an analog phase-locked loop (PLL) is described for deskewing the internal logic control lock to an external system lock. This PLL is fully generated onto a 1.2-million-transistor microprocessor in 0.8-μm CMOS technology without the need for external components. It operates with a lock range from 5 to 110 MHz. The clock skew is less than 0.1 ns, with a peak-to-peak jitter of less than 0.3 ns for a 50-MHz system clock frequency     

Degradation Behaviors of Metal-Induced Laterally Crystallized n-Type Polycrystalline Silicon Thin-Film Transistors Under DC Bias Stresses

Device degradation behaviors of typical-sized n-type metal-induced laterally crystallized polycrystalline silicon thin-film transistors were investigated in detail under two kinds of dc bias stresses: hot-carrier (HC) stress and self-heating (SH) stress. Under HC stress, device degradation is the consequence of HC induced defect generation locally at the drain side. Under a unified model that postulates, the establishment of a potential barrier at the drain side due to carrier transport near trap states, device degradation behavior such as asymmetric on current recovery and threshold voltage degradation can be understood. Under SH stress, a general degradation in subthreshold characteristic was observed. Device degradation is the consequence of deep state generation along the entire channel. Device degradation behaviors were compared in low V_d-stress and in high V_d-stress condition. Defect generation distribution along the channel appears to be different in two cases. In both cases of SH degradation, asymmetric on current recovery was observed. This observation, when in low V_d-stress condition, is tentatively explained by dehydrogenation (hydrogenation) effect at the drain (source) side during stress     

A transmit/receive IF chip set for WCDMA mobiles in 0.35 /spl mu/m CMOS

An implementation of the IF section of WCDMA mobile transceivers with a set of two chips fabricated in an inexpensive 0.35-/spl mu/m two-poly three-metal CMOS process is presented. The transmit/receive chip set integrates quadrature modulators and demodulators, wide dynamic range automatic gain control (AGC) amplifiers, with linear-in-decibel gain control, and associated circuitry. This paper describes the problems encountered and the solutions envisaged to meet stringent specifications, with process and temperature variations, thus overcoming the limitations of CMOS devices, while operating at frequencies in the range of 100 MHz-1 GHz. Detailed measurement results corroborating successful application of the new techniques are reported. A receive AGC dynamic range of 73 dB with linearity error of less than /spl plusmn/2 dB and spread of less than 5 dB for a temperature range of -30/spl deg/C to +85/spl deg/C in the gain control characteristic has been measured. The modulator measurement shows a carrier suppression of 35 dB and sideband/third harmonic suppression of over 46 dB. The core die area of each chip is 1.5 mm/sup 2/.     

Broadband dual-polarized patch antennas fed by capacitively coupledfeed and slot-coupled feed

Designs of broadband dual-polarized patch antennas fed by promising feed structures of a capacitively coupled feed and a slot-coupled feed (antenna A), two capacitively coupled feeds of a 180° phase shift and a slot-coupled feed (antenna B), and two capacitively coupled feeds of a 180° phase shift and two slot-coupled feeds (antenna C) are proposed and experimentally studied. The first two feed designs are for the excitation of a single-element broadband patch antenna, while the last design is for a two-element broadband patch antenna. These proposed patch antennas have a thick air substrate, and the 10 dB return-loss impedance bandwidths obtained for the two polarizations are all greater than 13%. High isolation (<-30 dB for antenna A, <-32 dB for antenna B, <-35 dB for antenna C) between the two feeding ports for the entire impedance bandwidth of the proposed antennas can be obtained. Also, improved cross-polarization levels (>20 dB) in both E and H plane patterns for the two polarizations of antennas B and C are achieved     

Annular slot-coupled dielectric resonator antenna

An annular slot-coupled dielectric resonator antenna is investigated experimentally. As compared with the previous rectangular-slot version, the new configuration offers a much wider bandwidth of 18%. The return loss, radiation patterns, and antenna gain of the configuration have been measured and are discussed     

Microbiologic depuration of Anadara tuberculosa (Mollusca: Arcidae)

In Costa Rica the mollusk Anadara tuberculosa represents a risk for human health due to the contamination of the growing waters and the fact that its is consumed raw. The families depending on the income obtained through commercialization of these animals have a low education and economic status. Therefore, it is of great importance to develop and evaluate simple methods of depuration that could be easily used by these families to make these mollusks safe for consumption. Bottles containing 11 of saline solution (25g/l) were prepared in duplicates to test the bactericidal effect of acetic acid. The solution in each bottle was adjusted to ph 4.5, 5.0 or 5.5 or held at ph of 7.0 or 8.0 for the controls. The solution in each bottle was then inoculated with approximately 1 X 104 cfu/ml of coliforms. Counts of coliforms were determined for each bottle 0, 1, 2, 4 and 8 hours after inoculation. For the depuration studies, specimens with diameters ranging from 4.0 to 4.5 cm were collected from a harvester at the estuary of Puntarenas, Gulf of Nicoya. Fifty specimens each were depurated in separate tanks containing 25 1 of oxygenated saline solution adjusted with acetic acid to an initial ph of 4.5 (treatment) or non adjusted ph of 8.0 (control). Counts of Enterobacteriaceae were determined, in duplicates, every 12 hr for 48 hr. An additional fifty animals were depurated using the defined method and tested to determine if they met international standards of microbiological quality for aerobic plate count, Enterobacteriaceae count, Escherichia coli count and presence of Salmonella. A sensory evaluation using a triangle test was performed to compare a typical dish prepared with depurated or non-depurated animals. A significant coliform reduction was determined in a saline solution (25 g/l) at a pH range of 4.5 to 5.5. This reduction, during 8 hr, was higher in the acid treatments compared to the controls. During depuration, the elimination of Enterobacteriaceae bacteria was faster when acetic was used (initial ph = 4.5) than when it was not. This elimination was more important the first 24 hr, time defined as adequate for the application of the method. The method has the advantage of transforming the bivalve in a product that is safe for human consumption, since it guarantees that the international standards of microbiological quality, for raw and depurated mollusks, are reached. On the other hand, the sensory qualities of a typical dish prepared with depurated animals are not affected by the method, which can be easily implemented and applied by the people that work in the extraction of this mollusk.     

Modification of the calcium and calmodulin sensitivity of the type I adenylyl cyclase by mutagenesis of its calmodulin binding domain

The type I adenylyl cyclase is directly stimulated by Ca2+ and calmodulin in vitro, and the enzyme is also stimulated by increases in intracellular Ca2+ in vivo. Ca2+ stimulation of the enzyme in vivo may be due to direct interactions of the enzyme with Ca2+ and calmodulin or to an indirect mechanism involving stimulation of the enzyme by Ca(2+)-activated protein kinases. In this study, we have made several point mutations within the calmodulin binding domain to determine if the Ca2+ sensitivity of the enzyme can be modified by mutagenesis. The catalytic activities of the mutant enzymes were comparable to wild type type I adenylyl cyclase. Substitution of Cys-507 with Ser-507 did not have significant effects on the calmodulin or Ca2+ sensitivity of the enzyme. However, replacement of Lys-504 with Asp caused a 4-fold decrease in sensitivity to Ca2+. Ca2+ and calmodulin stimulation were abolished by substitution of Phe-503 with Arg-503. Stimulation of type I adenylyl cyclase activity in vivo by intracellular Ca2+ was also greatly diminished with the Arg-503 mutant indicating that Ca2+ stimulation of the enzyme in vivo is due primarily to direct interactions with calmodulin and Ca2+. These data demonstrate that the Ca2+ sensitivity of this enzyme can be modulated by point mutagenesis within the putative calmodulin binding domain and indicate that the enzyme can be directly regulated by Ca2+ and calmodulin in vivo.