EPON媒体接入控制的关键技术研究

文章简要介绍了基于以及太网的无源光网络（EPON）这种新型的接入网技术，将其与基于ATM技术的无源光网络（APON）的优缺点进行了比较，并对其媒体接入控制（MAC）的关键技术测距及上行接入进行了讨论，初步提出了光网络单元（ONU）的软、硬件实现方案。     

辽河催化裂化澄清油中间馏分热反应研究

采用先加入絮凝剂脱灰，再经减压蒸馏切割420～500℃馏分的方法，将辽河催化裂化澄清油预处理，考察了澄清油、加入絮凝剂脱灰后的澄清油以及脱灰后再减压蒸馏所得的中间馏分这3种原料在热转化过程中中间相的转化历程，并采用偏光显微镜观察热转化产物。结果表明，澄清油预处理效果明显，所得中间馏分具有较低的H／C原子比（nH／nC）和适宜的组成分布，是生产针状焦的理想原料。热转化产物的光学组织结构属于各向异性发达的广域-流线型结构。     

参数设计法在铝电解电容器设计中的应用探讨

论述了参数设计法在铝电解电容器设计开发阶段的应用。文中阐明了铝电解电容器的主要质量特性(损耗因子、电容量)及芯包外径的参数设计原理,并建立了归一化函数作为优选设计方案的判据。实例证明在铝电解电容器的设计过程中应用参数设计法以减小产品质量特性变异是有效的。     

The Role of Network Topologies in the Optical Core of IP-over-WDM Networks with Static Wavelength Routing

In this paper, we present a performance analysis of network topologies for the optical core of IP-over-WDM networks with static wavelength routing. The performance analysis is focused on regular degree four topologies, and, for comparison purposes, degree three topologies are also considered. It is shown that the increase of the nodal degree from three (degree three topology with smallest diameter) to four (degree four topology with smallest diameter) improves the network performance if a larger number of wavelengths per link is available. However, the influence of wavelength interchange on the nodal degree gain is small. The performance of regular degree four topologies with smallest diameter is also compared with the performance of mesh–torus topologies (which are also degree four topologies), and it is shown that the blocking probability of degree four topologies with smallest diameter is about two orders of magnitude lower than the blocking probability of mesh–torus topologies. It is also presented a performance comparison of WDM-based networks with nodal degrees ranging from two to five and it is shown that the increase of the nodal degree from two to three leads to high nodal degree gains, while de increase of the nodal degree from four to five leads to low nodal degree gains. These results show that degree three and degree four topologies are very attractive for use in the optical core of IP-over-WDM networks.     

1400-1500 nm,Different Material-doped Raman Fiber Lasers Pumped by Nd∶YVO_4 Laser

Different material-doped Raman fiber lasers with very high efficiency operating in continuous-wave are presented.With 1 W Nd∶YVO 4 laser pumping at wavelength of 1 342 nm, single mode output power of above 500 mW (optical-to-optical conversion efficiency of 50%) is simulated in the range of 1 400-1 500 nm.Using high-germanium,high-phosphate and high-borate silicate fibers as the gain medium,laser output at wavelengths of 1 420,1 450,1 480 and 1 495 nm can be achieved with different geometries,which are just as pumping C-band and L-band distributed Raman fiber amplifiers.     

重视标准工作、强化标准管理是企业生存与发展的基础

本文论述了企业标准化工作的重要性及标准化工作需重视的几个方面。论述了采用国际先进标准及建全标准化管理体系的重要性。     

化学镀SiCp／Ni－P复合镀层与基体结合强度及其影响因素

论述了ＳｉＣｐ／Ｎｉ－Ｐ复合镀层与钢基体的结合强度及其影响因素。复合镀层中离界面５μｍ厚度以内区域的组成及应力状态对镀层／基体的界面结合有决定性作用，在该区域以外ＳｉＣ粒径变化不影响镀层的结合强度。适当的热处理可提高界面结合力。     

重油纳米化助燃效果研究与表征

将复配的分散剂加入重油中制备得到重油纳米颗粒，采用氧弹热值对比法对所研制的纳米化重油进行实验室评价。研究结果表明，纳米化后的重油燃烧性能得到了改善，在掺水量为3％～12％时，重油的燃烧效率提高了2．5％～6．1％。通过TEM观察，纳米化后的重油呈水包油（O／W）型乳液结构，油水界面清晰，界面膜较厚，乳化油粒径约为20～50nm，油水分散均匀，并且分散后的重油粘度增幅小，掺水量在15％以内，粘度增幅不超过20％，并且随着掺水量的增加，乳化重油的粘度逐渐减少。另外，乳化重油稳定性好，室温下至少可保存6个月，在80℃下存放3天未发生破乳现象。     

我国企业开展流程再造应从工作研究开始

由于管理基础工作薄弱，我国很多企业流程再造的努力未获成功。基于企业流程再造与工作研究之间的对比分析，文章提出了运用工作研究领域内的有关理论、经验、方法和工具来帮助我国企业开展流程再造。     

非化学计量LaNi5型储氢合金的性能

采用富La混合稀土与Ni、Co、Mg等元素组合，获得了一种非化学计量LaNi5型储氢合金、用金相、XRD和SEM-EDX等方法分析了该合金的组织结构，研究了合金的气相储氢特性以及电化学性能，结果表明：在1.6MPa氢压和温度29℃下，该合金的储氢量达到1.58%（质量分数），该合金的放电容量为380mAh/g。经300次循环后容量保持率为55%，该合金的基体是CaCu5型结构的LaNi5相，但有第二相（LaMg)Ni3析出，这种第二相的形成是导致该合金大容量的关键。