雷达仿真系统中电磁干扰环境的仿真设计和实施

雷达仿真系统是为检测雷达设备的抗干扰能力以及在各种电磁环境下的工作性能而设计的，包括有源干扰和无源干扰的模拟仿真。本文阐述了无源干扰即杂波的散射模型和仿真过程；从同步脉冲干扰的基本原理出发，阐明在雷达工作环境仿真系统中距离拖引、速度拖引、虚假目标等同步脉冲有源干扰的设计和实施过程；并针对工作在搜索和跟踪交替模式下的相控阵雷达提出自适应综合干扰方式；最后分析并总结了系统仿真时为真实、有效地模拟电磁干扰环境应注意的关键问题。     

多排数翅片管空冷器风阻特性的数值模拟

本文对多排数翅片管空冷器空气侧的风阻特性进行了数值模拟.利用商用软件Fluent进行数值计算,结合经验公式和已有的实验数据,分析了不同入口风速下,阻力的变化规律以及流动阻力和温度变化对模拟计算的影响.     

Vibration thresholds for fretting corrosion in electrical connectors

Single frequency vibration tests were used to induce fretting corrosion in tin alloy plated contacts. The samples used in this study were connectors consisting of 25 pairs of mated pin and socket contacts. Experimental results for a variety of vibration levels, frequencies, and wiring tie-off lengths are presented. The experiments consisted of running a series of vibration tests at each frequency where the excitation level was stepped through a range of g-levels. During each test run contact resistance was monitored as a performance characteristic. The results exhibit threshold behavior at each frequency for the onset of fretting degradation. Typically a plateau region was observed where similar g-levels produced similar fretting rates. It was also found that outside the plateau region the g-levels varied according to the dynamic behavior of the mechanical system. In addition, a transfer matrix model was used to analyze these results. An empirical fit of the data correlated well with the model when damping was used. This analysis revealed the importance of the bending moment induced at the contact interface as a result of excitation levels and tie-off configurations. Consequently, it is concluded that dynamic response of the mechanical system under various g-levels and tie off configurations can greatly impact the performance of a connector system subjected to vibration stresses.     

浅析特殊人群的住宅设计

特殊人群住宅的设计要点及对特殊人群住宅建设的几点建议。     

核壳乳液聚合中甲基丙烯酸用量对印花制品的影响

采用核壳乳液聚合法合成涂料印花粘合剂，考察了甲基丙烯酸(MAC)用量的改变对印花产品的牢度和色光的影响：在核中，当MAC的用量分别为0．0g，0．2g，0．4g，0．6g时，干摩牢度分别为25，2．5 ，3,0，3．5，色光由暗变亮；在壳中当MAC的用量分别为0．0g，0.2g，0．4g，0．6g时，干摩牢度分别为2.5，2．5 ，3．0，3．5，色光变亮，对得色量和鲜艳度影响不大。     

高能超声处理对锡锑包晶合金凝固组织的影响

在锡锑包晶合金的凝固过程中导入高能超声，不仅显著细化α相和β相晶粒组织，同时使具有立方晶体特征的β相组织有明显的球化趋势，消除了密度偏析，分析了高能超声细化凝固组织的机理。     

弹簧钢棒线材质量投诉的分析研究

为分析研究某特钢厂用户投诉的原因及存在的问题，统计了其两年间的弹簧钢棒线材用户质量投诉，从缺陷类型及生产过程控制进行了分析，重点对多起断裂原因不明的投诉进行了深入的失效研究。结果表明，弹簧钢生产厂在设备工艺、过程控制和管理中存在很多不足，加上用户的使用工艺、材料的内外质量和规格等综合因素导致了材料的断裂失效。     

Effects of passive tilt and submaximal exercise on spectral heart rate variability in ventricular fibrillation patients without significant structural heart disease

It has been shown that tilt and exercise elicit significant changes in autonomic activity in normal subjects and that submaximal exercise causes a greater reduction in heart rate variability (HRV) in animals susceptible to ventricular fibrillation (VF). Whether there is an abnormal HRV response to tilt and exercise in patients at risk of sudden cardiac death (SCD) remains unknown. Short-term HRV before and during passive tilt and exercise was studied in 12 survivors of out-of-hospital cardiac arrest with documented VF and compared with 12 age- and sex-matched normal controls. No patient had significant structural heart disease or left ventricular dysfunction. HRV was computed as total-frequency (TF, 0.01 to 1.00 Hz), low-frequency (LF, 0.04 to 0.15 Hz) and high-frequency (HF, 0.15 to 0.40 Hz) components. There was no significant difference between normal controls and SCD survivors in HRV before or during tilt or submaximal exercise testing. The HF component was significantly decreased during tilt compared with that in the supine position in both normal controls (5.85 +/- 0.61 vs 5.08 +/- 0.95 In(msec2), p = 0.005) and patients (5.58 +/- 1.49 versus 4.74 +/- 1.18 In(msec2), p = 0.003). There was again no significant change in the TF or LF components during tilt in either patients or controls. All frequency components were significantly decreased during submaximal exercise testing in both patients and controls. However, there was no significant difference in any of these tilt- and exercise-induced changes in HRV between normal controls and SCD survivors.(ABSTRACT TRUNCATED AT 250 WORDS)     

压力传感器静态检定装置的测量不确定度

本文根据压力传感器（静态）国家计量检定规程，对压力传感器静态检定装置进行误差分析，得出该装置的测量不确定度。最后，通过实例说明实际测量不确定度与理论分析相符合。     

A SURVEY OF ARYLAMINE N-ACETYLTRANSFERASE ACTIVITY IN COMMON FRUITS AND VEGETABLES

The N-acetyltransferase activity was determined in 58 common fruits and vegetables. The assay was based on acetylation of 2-aminofluorene or p-amino-benzoic acid, followed by high pressure liquid chromatographic analysis of products and remaining nonacetylated substrate. The highest specific activities were observed in Balsam pear which contained 17.37 ± 1.45 N-acetyl aminofluorene nmole/min/mg protein and 46.27 ± 6.87 N-acetyl p-aminobenzoic acid nmole/min/mg protein. N-acetyltransferase activities within the remaining 57 foodstuffs analyzed ranged from none detected to 3.39 ± 0.72 N-acetyl aminofluorene nmole/min/mg protein and none detected to 32.45 ± 6.55 N-acetyl p-aminobenzoic acid nmole/min/mg protein. This is the first demonstration of acetyl CoA: arylamine N-acetyltransferase activity in common foodstuffs.