Optimal periodic testing policy for circuit with self-testing

This paper considers periodic testing policies for a system with self-testing. The system can detect its failure by either self-testing or periodic inspection. If the system fails then its failure is detected by self-testing while it is on-line, or otherwise, it is detected at the next periodic test. Introducing the loss cost elapsed between a failure and its detection, the expected costs are obtained. Optimal intervals of periodic testing which minimize the expected costs are analytically derived. Numerical examples are given when both times of failure and its detection by self-testing are exponential distributions.     

Towards a Dual-Tip STM Application in Mesoscopic Electron Transport

A new design for a dual-tip scanning tunneling microscope (STM) is presented. The design is a variation on the mechanically controllable break-junction with two electron beam-induced deposition nano-tips. The new design enables one to scan surfaces simultaneously with two probes having a nano-gap separation. By collecting the lateral current flowing between the tips, the transconductance map can then be compared with the STM images for local characterizations of the electron transport. Since the lateral beam carries the property of the density of states of the surface at momentum space, the dispersion of the electronic structure should give an orientation and position dependence of the local transconductance current. In addition, the reduced terminal separation, on the order of the characteristic mesoscopic length scales, is likely to be sensitive to a variety of typically observed interactions and interference effects.     

Influence of third monomer on the crystal phase transition behavior of ethylene-tetrafluoroethylene copolymer

Crystal phase transition between the low- and high-temperature phases has been investigated for ethylene (E)-tetrafluoroethylene (TFE) alternating copolymer (ETFE) containing the third monomeric species by the temperature dependent measurements of wide-angle X-ray diffraction (WAXD) and small-angle X-ray scattering (SAXS) and differential scanning calorimetry. Nonafluoro-1-hexene (NFH) and hexafluoropropylene (HFP) were chosen as the third monomers, where they are different in the side-branch length, -(CF₂)₃CF₃ and -CF₃, respectively. In the case of E/TFE/NFH copolymer (ET-C4F9), the crystal phase transition temperature of the original ETFE two-components copolymer was not very much affected by the existence of NFH in the range of NFH content from 0.7 to 3 mol%. Contrarily, the crystal phase transition temperature of E/TFE/HFP copolymer (ET-CF3) was found to decrease drastically with increasing HFP content. The melting temperature and the higher-order structure were also affected sensitively depending on the HFP content. This difference in phase transition behavior between ET-C4F9 and ET-CF3 copolymers is reasonably interpreted as follows: the short side groups (-CF₃) of HFP monomeric unit are included in the crystal lattice of E/TFE chains and the unit cell is expanded gradually with an increment of the HFP content, resulting in the decrease in phase transition point because of easier thermal motion of the chains. On the other hand, the long side groups [-(CF₂)₃CF₃] of NFH monomeric units are excluded out of the crystal lattice and located on the lamellar surfaces or in the amorphous region and do not affect very much the phase transition temperature even when the NFH content is increased. In association with such a change in crystal structure, the long period of stacked lamellar structure was found to decrease remarkably in the case of NFH, whereas it does not change very much for HFP, consistent with the interpretation of the above-mentioned WAXD data.     

双柱塞砂浆泵中工作机构的设计和仿真研究

本文介绍了双柱塞砂浆泵的工作原理，根据机构替代原理建立起双柱塞砂浆泵工作机构的运动分析模型，然后在MatLab环境下，详细介绍了工作凸轮曲线的设计程序，利用计算机设计程序可以方便地分析工作缸活塞以及工作凸轮机构的位移、速度、加速度，利用SIMULINK仿真工具箱进行运动学仿真，为工作机构设计提供相应的理论分析依据。     

Atomic force microscopic study on DNA-wrapping for different diameter single-wall carbon nanotubes

DNA-wrapped single-wall carbon nanotubes (DNA-SWNT hybrids) prepared from different diameter HiPco- and Arc-SWNTs were investigated by atomic force microscopy. The mean diameter of DNA-HiPco-SWNT hybrids is 1.94 nm that is consistent with one HiPco-SWNT (~ 0.9 nm) wrapped by DNA (~ 1 nm). On the other hand, the mean diameter of DNA-Arc-SWNT hybrids is 3.74 nm that can correspond to one Arc-SWNT (~ 1.4 nm) wrapped by several layers of DNA. It is suggested that the DNA-wrapping mechanism for large diameter Arc-SWNTs is different from that for small diameter HiPco-SWNTs.     

The usability of passphrases for authentication: An empirical field study

In developing password policies, IT managers must strike a balance between security and memorability. Rules that improve structural integrity against attacks may also result in passwords that are difficult to remember. Recent technologies have relaxed the 8-character password constraint to permit the creation of longer pass-“phrases” consisting of multiple words. Longer passphrases are attractive because they can improve security by increasing the difficulty of brute-force attacks and they might also be easy to remember. Yet, no empirical evidence concerning the actual usability of passphrases exists. This paper presents the results of a 12-week experiment that examines users’ experience and satisfaction with passphrases. Results indicate that passphrase users experienced a rate of unsuccessful logins due to memory recall failure similar to that of users of self-generated simple passwords and stringent passwords. However, passphrase users had more failed login attempts due to typographical errors than did users of either simple or highly secure passwords. Moreover, although the typographical errors disappeared over time, passphrase users’ initial problems negatively affected their end-of-experiment perceptions.     

Development of next generation PWR in Japan

The demand for energy in Japan is expected to increase steadily into the future, and it seems that the importance of nuclear power generation will be heightened more when the situation of our country which is not rich in energy resources is taken into account.

Furthermore, when we consider the present situation that the light water reactors have become common, recent outlook for the supply and demand for uranium resources, trends in the development of the fast breeder reactor technology, etc., the light water reactors are expected to remain dominant in the nuclear power generation of our country until at least the second half of the 21st century.

Based on such a background five PWR utilities in Japan (Hokkaido, Kansai, Shikoku, Kyushu, and the Japan Atomic Power), and Mitsubishi Heavy Industries, Ltd. have jointly started researching the Next Generation PWR which is expected to be the leading nuclear power plant taking place of APWR.     

制丝线加香加料系统的问题及改进方法

针对目前卷烟企业制丝线加香、加料系统普遍存在的问题,从设备选型、控制算法进行分析,提出改进方法。     

轨道交通综合监控系统维护管理功能的实现

针对综合监控系统(ISCS)维护管理功能的实现,介绍维护管理子系统的软、硬件构成和数据流设计。