电压稳定在线预测评估方法研究

提出了有效的方法评估系统状态,预测电压崩溃。并根据指标值进行排序,进一步确定电压崩溃的地点。     

变电站电压无功调节的研究

由于电压在整个电力系统的重要性，电压无功控制越来越被重视。本文分析了电压与无功的关系，提出如何调整电压和无功。     

直接转矩控制中电压矢量对电磁转矩的影响

本文分析了直接转矩控制中电压矢量对电磁转矩的影响,提出了当定子磁链幅值和磁通角(定、转子磁链夹角)变化发生矛盾时,磁通角变化决定转矩变化的传统观点是在一定前提条件下成立的,否则,在某些情况下,转矩的变化与磁通角变化恰恰相反,这导致控制实际效果与开关表设定相反,增大转矩脉动.     

铜接地体技术在GIS变电站工程中的探索与实践

本文通过阐述铜接地体技术的基本原理,结合广东省江门市220kV新会变电站和广东省台山电厂220kV铜鼓升压站等GIS配电装置变电站工程实例,分析铜接地体与常规接地体的优劣与互补性,探索出一套适用于GIS变电站的铜接地体技术。     

单片机控制高压脉冲电网报警系统

介绍了用单片机控制高压脉冲电网,采用语音合成技术进行防盗报警应用系统的组成、原理和软件设计.     

一种高精度的带隙基准电压源及电流源

设计了一种采用0．25μm CMOS工艺的高精度带隙基准电压源，该电路结构新颖，性能优异，其温度系数可达5ppm／℃，电源抑制比可达到62dB。在此基础上设计了一种基准电流源，其温度系数可达6ppm／℃，输出电流变化率仅为0．03％／V。     

高性能永磁同步电机交流伺服系统的研究

介绍了永磁同步电机的数学模型，叙述了空间电压矢量脉宽调制(SVPWM)的原理，构建了永磁同步电机交流伺服系统，并对上述电机模型，SVPWM算法以及伺服系统进行了仿真实现。     

集成电压／电流变换器AD694

工业测控现场中常常需要利用电压／电流变换，进行远距离传送被测信号和增加信号的抗干扰能力。本文介绍一种常用的高性能电压／电流变换器ＡＤ６９４的特点、原理及其应用     

Terminal voltage build-up and control of a DFIG based stand-alone wind energy conversion system

The paper presents the voltage build-up process and the terminal voltage control of a doubly-fed induction generator (DFIG) driven by a pitch controlled wind turbine for the supply of autonomous system without any auxiliary source. A control strategy for the complete system including voltage build-up phase is developed with a view to provide as well as possible the required power for load. Indirect stator flux-oriented vector control is proposed to keep the stator voltage constant by means of a back-to-back converter connected to the rotor side, while the management system is supported by the pitch angle and the load shedding controllers. A novel scheme for voltage build-up is presented, which requires no additional hardware support, and physical interpretation of how self-excitation can occur from residual magnetism in the machine core is examined. A reliable start-up process is accomplished by using an appropriate voltage reference ramp which enables minimizing energy loss during the starting. The proposed system is modeled and simulated using Matlab/Simulink software program to examine the dynamic characteristics of the system with proposed control strategy. Dynamic simulation results for different transient conditions demonstrate the effectiveness of the proposed control strategy.     

On power tracking and alleviation by a new controller for fulfilment of the damping and performance requisites for a variable speed wind system: An optimal approach

This paper addresses a new control strategy for a variable wind energy conversion system. The proposed controller aims to regulate the output power tightly in response to the desired value changes and alleviate power oscillations against the disturbances, including wind speed variation and fluctuation of the voltage magnitude, as voltage sag and swell. For the sake of straightforward analysis, an effective and reduced representation for the wind system is developed. In addition to the proper performance, the controller seeks to adequately fulfilment the damping requirements, as though both damping and performance requisites are taken into account control policy. Consequently, the proposed approach focuses on optimal tuning based upon a performance index incorporated into linear quadratic (LQ) cost function, which is subjected to the performance constraints. To validate the controller role, multiple simulation tests are carried out including set point tracking, disturbance rejection against wind speed, voltage sag and swell. Simulation results verify the proposed method features a satisfactory performance and sufficient damping, meeting both aspirations of the power regulation and disturbance suppression.