CO2驱沥青质沉积对致密储层的伤害机理——以鄂尔多斯盆地延长组长8储层为例

为了揭示CO2驱替过程中沥青质沉积对致密储层的伤害机理,文中基于岩心核磁共振T2谱测试原理,开展了CO2注入压力下的岩心驱替实验,研究了沥青质在岩心中的沉积特征,评价了沥青质沉积对储层的伤害程度。实验结果表明:沥青质沉积量和渗透率伤害率随着CO2注入压力的升高呈现先快速上升后趋于平缓的趋势;在CO2注入过程中,沥青质主要沉积在弛豫时间大于10 ms的大、中孔隙,导致大、中孔隙占比下降,微细、小孔隙占比增加,且随着CO2注入压力的升高,大、中孔隙占比下降幅度增大,微细、小孔隙占比上升幅度增大;此外,沥青质沉积会引起润湿性发生反转,随着沥青质沉积量的增加,润湿反转指数增大,岩心润湿性不断向强油湿方向转变。     

Cd-substituted Mg composites with dual-equivalent permeability and permittivity for high-frequency miniaturization antennas

Spinel Mg ferrites Mg_1-xCd_xCo_0.05Fe_1.95O₄ (x=0.0, 0.2, 0.3 and 0.4) as potential agents for the miniaturization of high frequency antennas are presented. All the synthesized compositions were experimentally revealed to possess pure spinel phase. Dual-equivalent permeability and permittivity (μ'≈26, ε'≈25, x=0.3 and μ'≈29, ε'≈28, x=0.4) from 5 to 100 MHz can be achieved by introducing Cd²⁺ ions, yielding large miniaturization factors of up to 25 and 28. To figure out the effects of Cd²⁺ ions substitution on magnetic and dielectric properties, the change in microstructure is mainly investigated. Meanwhile, enhanced magnetic properties including upward saturation magnetization (Ms) (approximately 47.60 emu/g) and reduced coercivity (approximately 54.22 Oe) are obtained due to increased grain size and denser microstructure arrangements reflected from scanning electron microscopy images. With low magnitude order of magnetic and dielectric losses factors (tanδ_ε reaches 10^-4, tanδ_μ reaches 10^-2), the composites can potentially exhibit high operating efficiencies at high frequencies.     

Effects of sintering in a high magnetic field on properties of vitrified bond and vitrified CBN composites

Vitrified bond CBN grinding wheels are being widely used due to their superior performance. Also, advantages of vitrified grinding wheels are high elastic modulus, stable chemical property, and low thermal expansion coefficient. Brittleness and low strength are key factors restricting the development of vitrified bond CBN grinding wheels. In this paper, the sintering in a high magnetic field was innovatively introduced into the manufacturing of vitrified bond CBN grinding wheels, and the effects of sintering in a high magnetic field on properties on vitrified bond and vitrified CBN composites were systematically investigated. Vitrified bond was characterized using three-point bending, scanning electron microscopy, X-ray diffraction. It was observed that microstructure of vitrified bond could be changed, grain orientation could be controlled and average grain size could be decreased in a high magnetic field, while vitrified bond strength could be simultaneously improved. High quality vitrified bond could be obtained by appropriately adjusting the strength and direction of high magnetic field. Results demonstrated that vitrified bond properties were improved when the magnetic field strength was 6?T. In order to highlight the high magnetic field effect on the vitrified CBN composites, the ordinary CBN abrasives and nickel plated CBN abrasives were used respectively. Microstructures, bending strengths of vitrified CBN composites were compared in different high magnetic fields. When the magnetic field strength was appropriate (less than 6?T), the binding characteristic of vitrified bond CBN composites with nickel plated CBN abrasives was greatly improved. The highest bending strength value of vitrified CBN composites was 79.5?MPa in 6?T high magnetic field.     

Structural,morphological, dielectric and magnetic properties of Zn-Zr co-doping yttrium iron garnet

In this study, yttrium iron garnet co-doped with Zn and Zr atoms with a chemical formula Y₃Zn_xZr_xFe_(5−2x)O₁₂ (x = 0.0-0.3) has been successfully prepared by the solid-state reaction method. The effects of doping concentration on the microstructure, crystal structure, magnetic properties, and dielectric properties of Y₃Zn_xZr_xFe_(5−2x)O₁₂ were investigated. The microstructure analysis indicates that co-doping of YIG with Zn and Zr can effectively reduce the grain size of the ceramic. The crystal structure results reveal that the doping concentration of Zn–Zr has substantial influence on the lattice parameters of YIG, such as, increases the lattice constant, crystal cell size, and interplanar spacing. However, the second phase of ZrO₂ appears once x ≥ 0.15. Additionally, the dielectric properties of YIG ferrite can be regulated using this Zn–Zr co-doping method. Zn–Zr co-doping can improve the dielectric stability and reduce the dielectric loss at high temperature. The magnetization measurement shows that the saturation magnetization is stabilized at x < 0.15, and the magnetic loss is decreased with the increase in the doping concentration. Overall, the findings show that the ceramic with x = 0.1 exhibits better properties included high saturation magnetization (24.607 emu/g), low magnetic loss (0.0025 @ 1 MHz), and relatively low dielectric loss (496 @ 400°C).     

钻井钢丝绳检测方法与装置的研究

钻井钢丝绳对于钻井平台安全可靠性有直接影响。采用磁性检测方法对钻井钢丝绳进行检测,并对钻井钢丝绳的励磁方式、聚磁方法及传感器与钢丝绳的配合间隙问题进行分析。在此基础上,研制了钻井钢丝绳检测仪器,能够实现对钻井钢丝绳断丝、磨损等缺陷的定性、定量检测,并能够对缺陷进行定位,为钻井钢丝绳的寿命评估提供了依据,对提高钻井平台的安全性具有重要意义。     

AlSb晶体内二维磁极化子的磁场与温度效应

在考虑声子之间相互作用的同时，本文应用线性组合算符和微扰法研究了电子自旋对弱耦合二维磁极化子特性的影响。对AlSb晶体所作的数值计算结果表明，随着磁场的加强，磁极化子平均数减少；随着温度的增加，磁极化子平均数也增加；随着温度的增加，电子自旋作用以及声子之间相互作用都加强；随着磁场的加强，电子自旋作用增加而声子之间相互作用基本不变。     

基于MFSK的多载波水声通信系统及实验研究

本文在深入研究水声通信信道特性及多载波关键技术的基础上,设计并研制了基于M FSK的高速自适应多载波水声通信系统,并进行了湖上实验。理论分析、仿真及湖上试验结果表明:基于M FSK的多载波水声通信系统,多径抑制有效,对同步的精确度要求不高,性能稳健,更适合于恶劣水声通信环境下、中距离(10~30km)较高数据率多载波通信系统,易于工程实现,具有良好的应用前景。     

Synthesis of amphiphilic magnetic microspheres by dispersion copolymerization of styrene and poly(ethylene oxide) macromonomer

Amphiphilic magnetic microspheres ranging in diameter from 5 to 100 µm were prepared by dispersion copolymerization of styrene and poly(ethylene oxide) vinylbenzyl (PEO‐VB) macromonomer (MPEO) in the presence of Fe₃O₄ magnetic fluid. The effects of various polymerization parameters on the average particle size were systematically investigated. The average particle size was found to increase with increasing styrene concentration and initiator concentration. It also increased with decreasing stabilizer concentration and molecular weight of MPEO. The content of the hydroxyl groups localized in the microspheres ranged from 0.01 to 0.2 mmol g^?1. © 2003 Society of Chemical Industry