A/O结合循环式活性污泥法处理海产品加工废水

针对海产品加工废水氨氮含量较高的特点。舟山兴业有限公司的污水处理工程采用两段A/O结合循环式活性污泥法工艺，工程验收合格后运行一年多来，排放废水的各项污染指标均达到国家《污水综合排放标准》（GB8978-1996）的二级标准，处理系统具有很好的抗冲击能力和脱氮效果。     

基于等幅周期荷载下软岩Bingham本构模型的研究

为建立一种描述等幅周期荷载下软岩应变特性的本构模型,将Bingham模型中的常值黏壶元件替换成与循环次数相关的变系数黏壶元件,常值弹性元件替换为随周期荷载循环次数的增大而衰减的非定值弹性元件,即可得到反映周期荷载下软岩各种应变规律的Bingham本构模型。当循环荷载应力上限值σmax大于岩石的临界强度σs时,模型为可反映软岩3个应变阶段的改进4参数Bingam模型;反之则为反映软岩前两个应变阶段的非常值2参数Hook模型。将周期荷载分解为一个定值荷载和一个平均应力值为零的周期荷载,基于流变力学理论给出了定值荷载作用下基于该模型的本构方程式,再根据黏弹性力学理论,给出了平均应力值为零的周期荷载下基于该模型的本构方程式,最后将已获得的本构方程式叠加即得到周期荷载下软岩本构方程式。结果表明:所建立的本构方程式可较好描述周期荷载下不同软岩各类应变特征,对各类软岩的应变曲线拟合的相关系数均在0.868以上,且同一种岩石模型中弹性元件系数初始值随周期荷载的动应力幅值的增大而减小,岩石加速应变速率参数随动应力幅值的增大而增大。     

聚醚多元醇中环状齐聚物的去除(续)

(接上期第 2 3页 )3　膜分离Doraietal[16] 通过超滤除去低相对分子质量级份 ,使聚醚多元醇 ,尤其是聚四氢呋喃多元醇 ,具有较窄的分布 (Mw∶Mn=1 .2～ 1 .8)。该方法通过对多分散的熔融聚合物实施物理分级 ,达到降低相对分子质量分布的目的 ,可使最终产物的相对分子质量为 40 0～ 40 0 0 ,分散度为 1 .2～ 1 .8。该方法首先需要准备 1套交叉流动的膜分离系统 ,采用渗透膜或半渗透膜 ,膜的一边是滞留物 ,另一边是超滤液。然后 ,在起始聚合物的熔点以上 ,分解温度以下 ,且温度不大于膜的熔融和分解温度 ,将起始聚合物熔融 ,并流入该系统中…     

Electrodeposition, composition and structure of Zn—Cr alloys

The effect of polyethylene glycol (PEG 1500) as additive and of deposition conditions on Zn—Cr alloy electrodeposition from an acidic sulfate electrolyte at room temperature, without agitation was investigated. PEG polarizes the overall cathodic reaction and inhibits Zn deposition. Cr codeposition with Zn starts at a cathodic potential of about –1,95 V vs Hg/Hg₂SO₄, which is reached at current density of about 20 A dm^–2 in galvanostatic conditions. Zn—Cr alloy coatings containing up to 28 at % Cr were obtained depending on the plating conditions. SEM observations showed an island-like structure, formed by the local growth of crystals, which covered the surface during further deposition. In the first stages of electrodeposition the powder diffraction spectra contain lines of b.c.c. -(Zn,Cr) phase (a 3.02 Å). After 30 s deposition time weak lines of Zn-based phase (a 2.67 Å, c 4.90 Å) appear, and become clearly visible in coatings deposited for 90 s. The average Cr content in the alloy coatings decreases with advancing deposition. The as-plated surface contains C in organic compounds and Zn(OH)₂. After 50 min sputtering, Zn and a mixture of Cr, Cr₂O₃ and Cr₇C₃ were found. The presence of organic C and O, probably from inclusions of PEG, were also detected.     

Electrocopolymerization kinetics of a binary mixture of 3‐chloroaniline 2‐amino‐4‐phenylthiazole and characterization of the obtained block copolymer films

Electrocopolymerization of a binary mixture of 3‐chloroaniline and 2‐amino‐4‐phenylthiazole on platinum electrode in acid medium was carried out under different reaction conditions such as temperature, current density, hydrochloric acid, and monomer concentrations with duration time. The initial rate of the electrocopolymerization reaction on platinum electrode is small and the rate law is R_p = K₂ [D]^1.29[HCl]^0.97[M]^1.94. The apparent activation energy is found to be 38.87 kJ/mol. The obtained copolymer film is characterized by ¹H‐NMR, elemental analysis, GPC IR, UV‐visible, and cyclic voltammetry and compared with those of the two homopolymers. The mechanism of the electrocopolymerization reaction is also discussed and the monomer reactivity ratio (r₁and r₂) is calculated. The thermogravimetric analysis (TGA) is used to confirm the proposed structure and determination of the number of water molecules in the polymeric chain unit. X‐ray and scanning electron microscopic analysis are used to investigate the surface morphology. © 2005 Wiley Periodicals, Inc. J Appl Polym Sci 97: 2076–2087, 2005     

去甲氨噻肟酸乙酯合成研究

去甲氨噻肟酸乙酯是半合成头孢菌素药物的重要中间体之一.报道了在环合反应中,采用甲醇和水(体积比为1∶1)的混合溶剂代替二氯甲烷,甲醇等单一溶剂,反应温度在25℃左右下进行,收率明显提高,可达56.2%,结果令人满意.产品结构用1HNMR验证.     

循环荷载作用下重塑饱和粉黏土的刚度弱化特性研究

以东海大桥海上风电场项目为课题背景,通过动三轴系统对重塑饱和粉质黏土开展一系列长期不排水循环加载三轴试验,分别考虑围压、动应力比和频率3种因素,特别是对高频(f5 Hz)下土体的动力弱化特性进行了研究。试验结果表明:累积塑性应变与累积孔压随着循环次数的增加而增大并且趋于稳定,呈现出应变软化和孔压软化现象。割线动变形刚度模量和割线动弹性刚度模量则随着循环次数的增加,先急剧降低然后趋于稳定,从而表现出刚度弱化现象。进一步研究了割线动弹性刚度模量与循环应变幅值的关系,割线动弹性刚度模量的衰减趋势受动应力比和频率的影响不大,与围压有关,围压越大,割线动弹性刚度模量衰减趋势越慢,衰减稳定幅值越低。     

Electrochemical investigations of copper behaviour in different cupric complex solutions: Voltammetric study

The electrochemical behaviour of copper has been investigated in different cupric complex solutions by cyclic voltammetry. In pyridinic and picolinic solutions the reduction of cupric complex occurred in two stages leading to Cu(I) and Cu(0), respectively. The electrodeposited copper is oxidized in two steps leading to Cu(I) and Cu(II) as in ammoniacal cupric complex solutions. In glycine, alanine, sulfamic acid and ethylenediamine solutions, the cuprous complex is an intermediate in the cupric complex reduction but it is not detected during the oxidation of the electrodeposited copper in these solutions. In EDTA and triethanolamine solutions, the cuprous complex is not observed. The rate of copper etching was determined in pyridinic and ammoniacal cupric solutions and was shown to be faster in ammoniacal cupric solutions than in the pyridinic solutions.     

五元环硫酸酯的合成及其在立体合成中的应用

五元环硫酸酯具有较高的反应活性，在有机合成中得到广泛的应用。本文将对五元环硫酸酯化合物的合成及其在有机立体合成中的应用作一综述。     

循环经济与浮法玻璃工艺的发展

在玻璃行业贯彻循环经济的理念,改进工艺思想和方法,节约资源,降低消耗,提高资源利用率,减少污染物排放,是我们对后人应负的责任和对地球应尽的义务。