韶钢第五轧钢厂自动分槽器的设计与应用

介绍了韶钢第五轧钢厂自动分槽器的设计与应用．     

用改进的逐次逼近解法计算二维井间电磁场

提出了一种计算积分方程的新方法——改进的逐次逼近解法 (MSAM) ,并用该方法计算了轴对称二维井间电磁场。与传统的逐次逼近解法 (SAM)相比 ,该方法收敛性强 ,应用范围广 ,可适用于高电导率对比地层。由于不必进行直接的大型矩阵求逆运算 ,因此与积分方程的直接解法 (IE)相比 ,该方法计算速度更快 ,所需内存更少。采用矩阵求逆方法计算了成层介质中的二维 Green函数 ,并对含 Green函数的积分进行了简化 ,从而加快了计算速度。数值计算结果显示 ,在地层电导率对比度达到 2个数量级时 MSAM仍收敛 ,且计算结果与直接求解积分方程的结果一致 ,因此 MSAM是一种有效的计算轴对称二维井间电磁场的方法     

全密封变压器用波纹油箱的波纹高计算

介绍了全密封变压器所用的液纹油相的波纹筋高的计算方法，并用试验进行了验证。     

Criterion of Magnetic Saturation and Simulation of Nonlinear Magnetization for a Linear Multi-core Pulse Transformer

The linear multi-core pulse transformer is an important primary driving source used in pulsed power apparatus for the production of dense plasma owing to its compact,relatively low-cost and easy-to-handle characteristics.The evaluation of the magnetic saturation of the transformer cores is essential to the transformer design,because the energy transfer efficiency of the transformer will degrade significantly after magnetic saturation.This work propses analytical formulas of the criterion of magnetic saturation for the cores when the transformer driver practical loads.Furthermore,an electric circuit model based on a dependent source treatment for simulating the electric behavior of the cores related to their nonlinear magnetization is developed using the initial magnetization curve of the cores.The numerical simulation with the model is used to evaluate the validity of the criterion.Both the criterion and the model are found to be in agreement with the experimental data.     

微重力落塔电磁悬吊、释放技术研究

论述了微重力落塔电磁悬吊、释放、提升机构的关键技术,电磁释放过程的特性分析以及微重力落塔实际试验的情况。分析说明:悬吊、释放性能的好坏决定了试验落舱的微重力水平,也是微重力落塔试验能否成功的关键技术。     

TOP开关电源的设计与制作

利用TOP开关器件设计了一种高精度，输出电压可调的开关电源，并介绍了制作方法。     

A novel method of suppressing the inrush current of transformers by using a series‐connected voltage‐source PWM converter

This paper proposes a novel method of suppressing the inrush current of transformers. A small‐rated voltage‐source PWM converter is connected in series to the transformers through a matching transformer. As the connected PWM converter serves as a resistor for the source current, no inrush phenomena occurs. The required rating of the PWM converter, which serves as the damping resistor for the inrush phenomena, is 1/400 that of the main transformers in single‐phase circuits. In three‐phase circuits, it is 1/900. The basic principle of the proposed method is discussed. Digital computer simulation is implemented to confirm the validity and excellent practicability of the proposed method using the PSCAD/EMTDC. A prototype experimental model is constructed and tested. The experimental results demonstrate that the proposed method can perfectly suppress the inrush phenomena. © 2006 Wiley Periodicals, Inc. Electr Eng Jpn, 157(4): 56–65, 2006; Published online in Wiley InterScience ( www.interscience.wiley.com ). DOI 10.1002/eej.20174     

山区狭窄变电站的布局综合优化

电气设备和相关建筑物的综合布置是变电站设计过程中最重要的环节之一。针对山区地形狭窄、出线复杂条件苛刻的状况，提出了立体综合的电气布局优化方案。工程实践表明：该方案紧凑美观、运行维护方便，各项指标均能达到相关要求。     

施加复合电磁搅拌对A357合金微观组织的影响

在半固态加工技术中，电磁搅拌是最早应用于制备非枝晶浆料的方法之一，同时也是半固态触变压铸技术最早获得工业应用的重要技术基础之一。采用自行开发的电磁搅拌器，研究了多种不同电磁搅拌方式在不同工艺条件下，单独施加或复合施加对A357合金微观组织的影响。试验结果表明：单一施加旋转感应电磁搅拌时，浆料径向组织很不均匀；单一施加无芯感应电磁搅拌。当搅拌电流较小时，径向组织也不均匀，增大电流，浆料质量有明显改善；采用（旋转感应＋无芯感应）复合电磁场进行复合电磁搅拌时，可在电流较小时获得满意的浆料质量。     

小孔矩形腔体屏蔽特性的研究

本文提出了有孔腔体远、近场电磁屏蔽效能的计算方法，体研究了矩形腔体的屏蔽特性，讨论了各类孔对屏蔽能的影响程度。数值结果表明，理论计算与实验数据吻合较好。