过冷包晶合金的相选择分析

分析了过冷包晶铁基合金、铜基合金、稀土超导乳化物、稀土木磁化合物非平衡凝固过程中的相选择现象。根据对实验结果的分析，对过冷包晶合金凝固的相选择进行了分类。探讨了过冷包晶合金凝固今后的研究方向和应用前景。     

带通采样在数据采集中的应用研究

在数据采集中采用带通采样，可大大降低采样率，但系统中的抗混叠滤波器会造成相位的非线性。采用对滤波后的信号进行带通采样，然后再用FRR滤波器校正相位的非线性，从而不失真地还原原信号，最后在Matlab中进行仿真，验证了该方法的有效性。     

Thermodynamic and Transport Properties of Liquid HFC-227ea

The thermal conductivity and heat capacity of liquid 1,1,1,2,3,3,3-hepta-fluoropropane (HFC-227ea) have been studied by a high-frequency thermal-wave method over the temperature range of 294 to 345 K at pressures up to 2.8 MPa. The purity of the samples used throughout the measurements is 99.99 mol%. The experimental uncertainties of the thermal conductivity and heat capacity measurements were estimated to be within ±1.5 and ±2%, respectively. The thermal conductivity of HFC-227ea in the liquid phase decreases as temperature increases, while the pressure has an opposite effect.     

Phase behavior,density, and crystallization of polyethylene in n‐pentane and in n‐pentane/CO2 at high pressures

The phase behavior and volumetric properties of polyethylene (PE) in solutions of n‐pentane and n‐pentane/CO₂ were studied in a temperature (T) range of 370–440 K at pressures up to 60 MPa. Measurements were conducted with a variable‐volume view‐cell system equipped with optical sensors to monitor the changes in the transmitted light intensity as the P or the T of the system was changed. Lower‐critical‐solution‐temperature‐type behavior was observed for all of the liquid–liquid (L–L) phase boundaries, which shifted to higher pressures in solutions containing CO₂. The solid–fluid (S–F) phase boundaries were investigated over a P range of 8–54 MPa and took place in a narrow T range, from 374 to 378 K in this P interval. The S–F phase boundary showed a unique feature in that the demixing temperatures showed both increasing and decreasing trends with P depending on the P range. This was observed in both the PE/n‐pentane and PE/n‐pentane/CO₂ mixtures. The density of these solutions were measured as a function of P at selected temperatures or as a function of T at selected pressures that corresponded to the paths followed in approaching the phase boundaries (S–F or L–L) starting from a homogeneous one‐phase condition. The data showed a smooth variation of the overall mixture density along these paths. © 2003 Wiley Periodicals, Inc. J Appl Polym Sci 89: 2201–2209, 2003     

V波段小型化低相噪频率综合器

本文研究了一种V波段超小型低相噪频率综合器,研制了L段捷变频频综、Ku波段取样锁相源、上变频组件、倍频器等四个小型化组件.为了得到较低的相位噪声和捷变频速度,本捷变频频综采用上变频-倍频方案,其中DRO PLS保证低相位噪声性能,L波段捷变频频综保证捷变频功能.该频综尺寸为100×80×30mm³,相位噪声低于-86dBc/Hz(1kHz),捷变频时间小于40μs,杂波抑制优于-60dBc.     

两相异步电动机变频调速装置

主要讨论对称两相变频器主电路的结构以及介绍一种简单实用的磁链轨迹控制技术．     

油气微运移的烃类相态

微运移机制是目前油气化探等非地震直接找油的理论基础,只有研究清楚油气微运移的相态,才可能进一步研究微运移的机制;含油气水相是油气发生微运移最普遍和优先起作用的相态;在特定的地质条件下,不排除油气以其它相态发生渗漏的可能。     

Interfacial reactions in In-Sn/Ni couples and phase equilibria of the In-Sn-Ni system

The In-Sn-Ni alloys of various compositions were prepared and annealed at 160°C and 240°C. No ternary compounds were found; however, most of the binary compounds had extensive ternary solubility. There was a continuous solid solution between the Ni₃Sn phase and Ni₃In phase. The Sn-In/Ni couples, made of Sn-In alloys with various compositions, were reacted at 160°C and 240°C and formed only one compound for all the Sn-In alloys/Ni couples reacted up to 8 h. At 240°C, Ni₂₈In₇₂ phase formed in the couples made with pure indium, In-10at.%Sn and In-11at.%Sn alloys, while Ni₃Sn₄ phase formed in the couples made of alloys with compositions varied from pure Sn to In-12at.%Sn. At 160°C, except in the In/Ni couple, Ni₃Sn₄ formed by interfacial reaction.     

Application of annexation principle of thermodynamic property of In-Pb-Sb and In-Bi-Pb melts

Based on the principle of annexation and phase diagrams, the structural units of In-Pb-Sb and In-Bi-Pb melts were determined, and their calculating models of mass action concentrations were formulated. Calculated results agree well with practical values, which in turn show that the models deduced can reflect the structural realities of corresponding melts and the principle of annexation is applicable not only to some binary metallic melts, but also to ternary metallic melts.     

具有初始弯曲转子振动峰值的控制方法

本文从理论上研究了控制初始弯曲引起的转子振动幅值的一种新方法。通过在与转轴初始弯曲方向成较大夹角的方向添加不平衡质量的方法 ,使转子新的不平衡方向与初始弯曲方向夹角接近 180° ,则可以减小转子在临界转速附近的振幅。无论新的不平衡参数大于或小于初始弯曲参数 ,只要新的不平衡参数不至于太大 ,则临界转速附近的振幅响应肯定会得到改善。特别是当新的不平衡参数近似等于初始弯曲参数时 ,无论转速高低 ,振幅都会大幅下降。当重力参数、外阻尼系数和内阻尼系数改变后仍有同样结论。本文援引文献 [2 ]中的实例对这种方法进行了验证 ,并给出了解决类似故障的步骤。本文的方法可用于处理生产实际中转轴初弯引起的振动问题