Relaxation phenomena caused by equilibration of point defects

Relaxation phenomena due to equilibration of point defects in metals are reviewed. The relaxation effect in specific heat observed in tungsten and platinum confirms that in both cases the nonlinear increase in the high-temperature specific heat has to be attributed to point-defect formation. Relaxation phenomena observed by measurements of electrical resistivity and positron annihilation are also considered. The comparison of the data seems to be favorable for the conclusion that all the phenomena are of one origin.     

Carbon fibre cloth as an electrode material: electrical conductivity and mass transfer

The paper deals with carbon fibre cloth electrodes, employed in the fabrication of composite materials. The electrical conductivity of single bundles, groups of bundles and cloth is studied. Ohm's law applies to the electrical conduction in the direction of the fibre length, but bundle conductivity decreases with the number of fibres in the bundle. Electrochemical mass transfer between a flowing electrolyte and a cloth arranged as a flow-through or a flow-by porous electrode indicates the existence of double porosity in the material. Due to double porosity, only the external surface of the cloth works as an electrode. This finding shows that the material is not suitable for such an application.     

可燃性粉尘环境用电气设备标准介绍

章着重对可燃性粉尘环境用电气设备新标准（GB12476．1－2000和GB12476．2－2XXX）的主要内容进行了介绍，并对粉尘的爆炸机理，国内外粉尘标准体系等进行了阐述。     

The current and residual value of superphosphate for lupins grown in rotation with oats and wheat on a deep sandy soil

In a field experiment on a deep pale-yellow sand in a 600 mm per annum rainfall Mediterranean environment of south-western Australia, six levels of phosphorus (P) as superphosphate (O up to 546 kg P ha^–1) were applied once only, to the soil surface, before sowing lupins (Lupinus angustifolius). The lupins were grown in a continuous arable cropping rotation with, in successive years, oats (Avena sativa), wheat (Triticum aestivum), lupins. Five such rotations were started in the experiment from 1985 to 1989. The experiment continued until the end of 1990.The relationship between lupin seed (grain) yields and the level of P applied was measured in the year of P application for five successive years (1985 to 1989). The relationship had the same general form but it varied between years, largely due to different maximum yields (yield plateaux) in each year.The residual value of superphosphate applied three years previously was measured for lupins on two occasions (1988 and 1989) relative to superphosphate applied in the current year. The residual values was different in the two years. The superphosphate applied three years previously was about 30% as effective as freshly applied superphosphate in 1988, and 12% as effective in 1989.At each harvest, the relationship between grain yield and the P concentration in the grain differed for different species. However, for each species at each harvest, the relationship was similar regardless of when the P was applied in the previous years. Thus each species had the same internal efficiency of P use curve, and yields varied only with P concentration in tissue.Bicarbonate-extractable soil P was determined on soil samples taken in mid-July of 1989 and 1990. These soil test values were related to grain yields at harvest. The relationship between yield and soil test values had the same general form but varied for different species within years and for each species between years. It also varied for each species within years depending on the year the P was applied.     

新型环氧树脂绝缘浸渍胶（WSK）在微特电机上的应用

介绍了新型环氧树脂少溶剂快干绝缘浸渍胶的性能试验数据及基在微特电机上的应用及注意事项。     

Al(OH)3对硅橡胶性能的影响

综述了Al（OH)3粒径和用量对硅椽胶漏电电流、脉冲电流、耐漏电起痕、表面粗糙程度、电蚀损、介电性能、拉伸强度及漏电电流实验重复性的影响。     

Residual Stress Evolution in Repair Welds

Abstract: The aim of this paper is to study the influence of the repair procedure on the evolution of residual stress distribution in butt welds. C-Mn steel coupon plates of 11 mm thickness were prepared, subjected to stress relief heat treatment and welded with two beads, using the gas metal arc welding process. After the deposition of two weld beads, two successive repair welds were made on the middle length of the second bead. Longitudinal and transverse residual stresses were measured in the vicinity of the weld, after deposition of the two weld beads and after each repair weld. Residual stress evaluation was conducted using an X-ray diffraction method. The repair welds caused a decrease in magnitude of the initial longitudinal residual welding stresses, and an increase of the transverse residual stress magnitude, in tension at points within the repair length, and in compression at points outside the repair length.     

基于AutoCAD的电气符号图像控制菜单的开发

以电气符号为例，介绍了AutoCAD平台下图像控制菜单的开发过程以及幻灯片、幻灯片库的创建方法。     

二氧化氯处理油田回注水工艺

针对中原油田回注水中细菌易产生抗药性,难以控制的问题,提出了应用二氧化氯处理油田回注水工艺。经室内评价及现场试验,二氧化氯可杀死回注水中的细菌,控制微生物生长,同时该工艺可降低现有回注水污泥残渣产出量的50%,减少污泥对环境的污染,提高注水水质。     

检修链在煤矿生产中的作用

机电事故严重影响企业的安全运行。国投新集二矿通过完善机电设备检修链的各个环节,最终实现了降低机电事故率的目标。