基于DSP的多元数据同步采集与存储系统的设计与实现

从硬件和软件两个角度出发,介绍基于DSP的多元数据同步采集与存储系统的组成、工作模式以及功能的测试。系统主要由上位机和数字采集与存储单元组成,其中数字采集与存储单元的硬件部分包括电源模块,值班电路模块,数据采集模块,数据存储模块,时钟同步模块。系统采用DSP作为中央处理芯片,利用经过同步后的秒脉冲作为触发信号,实现同步数据采集。以CF卡作为存储介质,实现数据自容式存储。软件部分实现自检、同步、数据采集存储功能。经过测试,系统工作稳定,功能正常,同步精度在100ns以内。     

园区多能互补供能系统设计方法研究

为提高园区多能互补工程的能源综合利用效率及整体效益，对供能系统设计中的负荷统计、逐时负荷匹配、供能系统、设备选型、容量配置及运行策略等问题进行了分析和总结，提出园区多能互补供能系统设计的基本流程与方法，可为园区多能互补供能系统的设计提供参考。     

基于AMESim的液压马达加载系统研究

液压马达作为液压系统的执行元件在工程机械上广泛应用,针对液压马达加载工况下的输出特性,利用Simulink和AMESim软件对系统进行联合仿真建模,并对系统的运行状态、控制性能、回收性能进行研究,对液压马达加载系统的设计和改进具有重要的参考意义。     

Iron mediated cathodic electrosynthesis of hausmannite nanoparticles

A novel synthetic route has been proposed to prepare hausmannite nanoparticles. The synthetic route comprises an iron mediated constant current cathodic electrodeposition of manganite and heat treatment of the latter to obtain hausmannite. The obtained nanostructures have been characterized using X-ray Diffraction (XRD), scanning electron microscopy (SEM), energy dispersive X-ray spectrometry (EDX) and Fourier transform Infrared Spectrometry (FTIR). The role of iron in the formation of manganite precursor has been studied by cyclic voltammetry (CV) and differential thermal analysis (DTA). A formation mechanism based on iron mediated formation of Mn³⁺ and subsequent cathodic reduction of the disproportionated products has been proposed accordingly. The prepared nanoparticles exhibited specific capacitance of 143 F g⁻¹ in 0.5 M Na₂SO₄ solution. The retained specific capacity was 87% after 2000 cycles.     

A distributed energy system integrating SOFC-MGT with mid-and-low temperature solar thermochemical hydrogen fuel production

Solar thermochemical hydrogen production with energy level upgraded from solar thermal to chemical energy shows great potential. By integrating mid-and-low temperature solar thermochemistry and solid oxide fuel cells, in this paper, a new distributed energy system combining power, cooling, and heating is proposed and analyzed from thermodynamic, energy and exergy viewpoints. Different from the high temperature solar thermochemistry (above 1073.15 K), the mid-and-low temperature solar thermochemistry utilizes concentrated solar thermal (473.15–573.15 K) to drive methanol decomposition reaction, reducing irreversible heat collection loss. The produced hydrogen-rich fuel is converted into power through solid oxide fuel cells and micro gas turbines successively, realizing the cascaded utilization of fuel and solar energy. Numerical simulation is conducted to investigate the system thermodynamic performances under design and off-design conditions. Promising results reveal that solar-to-hydrogen and net solar-to-electricity efficiencies reach 66.26% and 40.93%, respectively. With the solar thermochemical conversion and hydrogen-rich fuel cascade utilization, the system exergy and overall energy efficiencies reach 59.76% and 80.74%, respectively. This research may provide a pathway for efficient hydrogen-rich fuel production and power generation.     

金属配合物与核酸作用机理的理论计算

通过计算机模拟金属配合物与核酸作用机理,对其理论模型能量计算和结构优化。在不同的化学环境条件下得到不同的实验模拟结果,对真实的化学反应过程有重要的指导意义和参考意义。通过Gaussian03,Gauss View等软件的结合应用,分别应用于优化计算和理论建模,熟悉了对化学软件操作应用。     

低觉醒脑电识别与唤醒的可穿戴系统研究

为智能化地识别警戒作业人员出现的低觉醒、注意力下降的生理状态，本文介绍了一种基于FPGA和脑电信号处理的低觉醒状态检测与唤醒系统，系统通过传感器从大脑头皮采集脑电信号，转换为数字信号，经傅里叶变换获取了脑电信号的θ相对能量、α相对能量、重心频率、谱熵等4个特征量，由4个特征量表征低觉醒状态并运用支持向量机对低警戒状态进行识别，当识别出低觉醒状态时采用声音报警模块发出声音，唤醒警戒作业人员。设计系统能够较好地识别出低觉醒状态，识别率达90.8%，可为提高警戒作业工作绩效提供一种可穿戴的智能装备。     

Enabling supercapacitors to compete for ancillary services: An important step towards 100 % renewable energy

While wind and solar generation has increased dramatically over the past decade, there has been a much larger increase in gas generation (eia, 2019). This is driven in part by low gas prices but also in part by how electricity markets are organized. The intermittent nature of wind and solar generation increases the need for more flexible and reliable generation; a role gas plants fill well. However, current market structures and rules unfairly tip the balance in their favor compared to energy storage systems. They have created market barriers restrictive enough to prevent market participation of a technology key to a 100 % renewable grid: supercapacitors. Adjusting markets to remove the market barriers to supercapacitor and other energy storage systems will allow for increased renewable penetration while simultaneously improving grid performance and reducing costs.     

Kinetic analysis of magnesium aluminate spinel formation: Effect of MgO:Al2O3 ratio and titania dopant

The mechanistic pathway of MgO-Al₂O₃ reaction in solid state to form MgAl₂O₄ spinel was investigated to correlate the kinetic parameters with ratio of reactants (MgO:Al₂O₃) and with the presence of a doping agent, TiO₂. The time-temperature-expansion data of oxide compacts was analyzed using several model free analyses and model based (linear and non-linear) kinetic algorithms. These indicated that spinel formation process can be best described by single step with n-dimensional Avrami equation for every MgO:Al₂O₃ ratio, irrespective of titania dopant. The activation energy (E_a) of the process was proportional to % spinel formed in each system and validated with quantitative XRD analysis. The higher value of Avrami coefficient (n) in 90 wt% Al₂O₃ compositions has been explained with geometric considerations of powder packing. Incorporations of 1% TiO₂ in the MgO: Al₂O₃ oxide compact did not markedly affect the reaction model, frequency factor and Activation energy.     

Dielectric,ferroelectric, and energy storage properties in dysprosium doped sodium bismuth titanate ceramics

In this work, Na_0.5(Bi_1-xDy_x)_0.5TiO₃ (0?≤?x?≤?15%) ceramics were prepared via solid state reaction method and were characterized. A stable and pure perovskite phase was revealed by X-ray diffraction analysis for all compositions and a symmetry change from rhombohedral to orthorhombic phase was detected beyond 10% of Dy substitution. The incorporation of Dy³⁺ into Sodium Bismuth Titanate (Na_0.5Bi_0.5TiO₃) matrix allows a substantial decrease of the coercive field, an increase in the resistivity, and leads to a high stability of the dielectric permittivity (??/?_(150?°C) ≤?±?15%) over a wide temperature range. Furthermore, this system was found to exhibit improved energy storage properties at high temperatures with a maximum energy density of 1.2?J/cm³ obtained for 2%Dy composition at 200?°C. The obtained results are very promising for energy storage capacitors operating at high temperatures.