基于USB接口的心电信号数据采集系统

介绍了基于USB接口的心电信号数据采集系统，给出了该系统的硬件组成原理及软件设计方法。由于该系统使用了高性能的USB专用芯片CY7C64613，因而具有使用方便、即插即用等特点。与笔记本电脑相连即可构成移动式心电信号检测分析仪器，具有较高的实用推广价值。     

25Cr3Mo3NiNb二次硬化钢中的碳化物

利用TEM和萃取相分析方法，研究了25Cr3Mo3NiNb二次硬化钢淬火回火组织中的碳化物。结果表明，随淬火奥氏体化温度的升高，M6C型碳化物逐渐溶解。于1050℃奥氏体化时M6C型碳化物全部溶解，淬火态试样中只有少量的Nb(C，N)颗粒和自回火M3C型碳化物。随回火温度的升高，先后析出ε、M3C、M2C和M7C3等类型的碳化物。Nb(C，N)颗粒可以阻止淬火奥氏体晶粒的异常长大，而高温回火析出的M2C碳化物有二次硬化作用，从而提高回火稳定性和高温强韧性。     

热处理对Ti-25V-15Cr-2Al-2Mo-0.2C合金组织稳定性的影响

研究了热处理对Ti-25V-15Cr-2A1-2Mo-0.2C阻燃β钛合金组织稳定性的影响。结果表明，高温固溶并直接时效处理导致合金β基体上析出较多的α相沉淀，尤其在随后的热暴露组织中形成了恶化合金塑性的连续晶界α膜。然而，若在时效前再进行一次低温固溶处理则可明显减少α相的析出数量，合金的热稳定性因此而得到显著改善。     

高速钢W6Mo5Cr4V2的脱磷试验

在３０ｋｇ感应炉上用ＣａＯ－Ｎａ２ＣＯ３－ＣａＦ２－ＦｅｘＯ（ＭｏＯ３）渣、ＭｏＣｌ６粉剂和Ａｌ－Ｃａ合金作脱磷剂对高速钢Ｗ６Ｍｏ５Ｃｒ４Ｖ２进行脱磷试验。结果表明，ＣａＯ－Ｎａ２ＣＯ３－ＣａＦ２－ＦｅｘＯ渣的脱磷效果最好，一般脱磷率可达２６％￣５６％。     

Zr-2/Cr反应扩散研究

研究了Zr-2/Cr扩散偶在1023－1123K范围内的反应扩散，用扫描电镜观察反应宽度，用能谱仪（EDS）测定了反应层Zr,Fe和Cr沿扩散方向的浓度分布，研究了反应层的生长动力学，结果表明，反应层生长基本符合抛物经规律，生长过程受扩散控制，用Boltzman-Matano-Heumann模型计算了Cr在反应层Zr（Fe,Cr）2中的互扩散系数D，得到了互扩散系数D与温度的Arrhenius方程，由计算的扩散数据与Cr在Zr中形成稀固溶体时Cr的扩散数据比较可知，Cr在金属间化合物Zr（Fe,Cr）2中的扩散比在稀因溶体中的扩散快5个数量级。     

Probing the early stages of polymerization of ethylene on a model chromium/silica catalyst by Fourier transform infrared spectroscopy

The nature of the interaction of monomer, and the early stages of growth of oligomers of ethylene on a rather more uniform surface of Cr/SiO₂ catalyst than hitherto studied has been investigated by differenceFTIR spectroscopy using C₂D₄ and C₂H₄ as reactants both with and without subsequent treatment of the catalyst with CO andTHF. The active catalyst was prepared by reaction of vapour phase CrO₂Cl₂ with the vicinal hydroxyls of the silica surface. Three distinct kinds of methylene groups were detected. Arguments are given for assigning the peaks at 2935 and 2860 cm^–1 to CH₂ groups directly bound to the active site and those at 2920 and 2850 to CH₂s in the growing chain well removed from the Cr. The peaks at 2160 and 2165 cm^–1 are attributed to CD₂ groups hydrogen bonded to surface hydroxyls.     

Catalytic behavior of YBa2Cu3O7-x in the partial oxidation of methanol to formaldehyde

The partial oxidation of methanol to formaldehyde was studied over YBa₂Cu₃O_7-x catalyst in a flow reactor. The structural change of YBa₂Cu₃O_7-x before and after the reaction was measured by means of XRD and iodometric titration method. The catalytic characteristics of YBa₂Cu₃O_7-x for the partial oxidation of methanol to formaldehyde was due to copper ions. It was found that Cu⁺² was responsible for the higher selectivity for formaldehyde.     

Cr12钢的预处理工艺研究

本文研究了Ｃｒ１２钢经４种不同的预处理工艺处理后钢中碳化物的大小，数量，分布及钢的硬度，强度和韧性，试验结果表明，经调质处理，高温固溶淬火＋高温退火处理后，Ｃｒ１２钢中碳化物的大小，分布及其组织，性能均优于常规球化退火预处理的。通过扫描电镜对冲击断口的分析，初步探讨了新的预处理工艺提高韧性的原因。     

常减压蒸馏装置阻垢剂进料管腐蚀与防护

通过对常减压蒸馏装置阻垢剂进料管的材质、性能、工作条件及腐蚀形貌、腐蚀产物的全面分析,找出了使进料管发生大面积腐蚀的腐蚀介质为环烷酸.并提出了减缓阻垢剂进料管环烷酸腐蚀的措施,主要包括选用更耐蚀的316或316 L材质以及改进三通结构等.