Experimental evaluation of the strength distribution of E-glass fibres at high strain rates

A bimodal Weibull distribution function was applied to analyse the strength distribution of glass fibre bundles under tensile impact. The simulation was performed using a one-dimensional damage constitutive model. The results show that there were two concurrent flaw populations in the fracture process. The regression analysis using the bimodal Weibull distribution function was in good agreement with experiment.     

Dynamics of hydrated iron(II) cations in nafion polymer membranes

Mössbauer studies of Fe²⁺ in water-soaked nafion polymer membranes in the temperature range between 90 K and 250 K have been performed. Above a critical temperature (～ 180 K) the spectra exhibit both elastic narrow absorption lines and quasielastic broad lines. These spectra are typical of bounded diffusion phenomena observed by Mössbauer spectroscopy in macromolecular systems like haemoglobin, myoglobin and ferritin. Similar spectral shapes have been observed by quasielastic neutron scattering from water in nafion membranes. Within 50 K above the critical temperature the total Mössbauer absorption area decreases by an order of magnitude whereas the narrow absorption line decreases by two orders of magnitude. The results are interpreted in terms of bounded diffusive motion of the iron. Using a model based on overdamped harmonically bound Brownian motion, the essential parameters of the iron motion can be derived as a function of temperature. The iron motion most probably reflects the motion of a large Fe²⁺ complex, e.g. Fe(H₂O)²⁺₆, which is attached to the polymer side chains via the sulphonic group.     

Ni-Mo-O催化剂中协同作用对丙烷氧化脱氢的影响

在 Ni-Mo-O体系中 ,加入 Mo O3 能极大地提高丙烷氧化脱氢制丙烯的反应活性。选用固混法、沉淀法、柠檬酸法制备了 Mo O3 过量 1 5 % (摩尔分数 )的α -Ni Mo O4催化剂 ,其中用沉淀法制得催化剂在 5 0 0℃ ,V( C3 H8) /V ( O2 ) /V ( N2 ) =1 0 /1 0 /5 0 ,反应气流量为 70 m L/min的条件下丙烷转化率可达 38.7% ,丙烯选择性达 70 .1 4 %。经 XRD,XPS,TPR表征说明 ,在含有过量 Mo O3 的催化剂中 ,α -Ni Mo O4与 Mo O3 两种晶体之间可产生微小的相互吸引 ;从而发挥协同作用 ,是提高催化剂活性     

拉伸速率对PP/GB复合材料力学性能的影响

应用Instron材料试验机考察了室温下拉伸速率对玻璃微珠填充聚丙烯复合材料的弹性模量和屈服强度的影响，结果表明，随着微珠含量的增加，试样的弹性模量（Ec）增大，且与拉伸应变速率呈近乎幂律函数关系，而屈服强度（бyc）则随着微珠体积分数（Φf）的增加呈线性函数形式下降，并随着拉伸应变速率的增加呈幂律函数形式提高，此外，讨论了Ec、Φf与бyc三者之间的关系。     

玻璃工业中的计算机应用

本文对国内外微机在玻璃工业中的应用现状进行了综述与评价 ,主要讨论微机应用对玻璃工业的影响 ,并初步探讨了玻璃工业中微机应用的前景     

SO_3磺化法合成PNTS新工艺的研究

本文采用正交设计及方差分析法,确定了 SO_3磺化法合成 PNTS 新工艺的最佳工艺条件;并从技术及经济方面将新工艺同国内现有的生产老工艺进行了分析对比。     

Sol-gel processing: A versatile concept for special glasses and ceramics

The various parameters related to sol-gel processing are discussed with special reference to those which usually attract less attention but depending on the final product in mind, can play important roles. The versatility of the sol-gel technique in materials preparation is demonstrated by discussing the various products developed at the author’s laboratory by using this processing method.     

石英玻璃基复合材料的研究进展

石英玻璃基复合材料属于重要国防材料，在导弹通讯、制导和防热上具有不可取代的地位。本工作介绍了几种形式的石英玻璃基复合材料的组织结构、性能和制备工艺的研究与应用情况。同时提出了石英玻璃基复合材料研究中存在的问题。     

改性玻纤增强尼龙610,1010塑料

研究了采用(准)中粘度级尼龙做基体树脂,加入成核剂改善尼龙的结晶过程,提高结晶速率和初始熔融温度;添加光、热氧稳定剂,防止尼龙在成型加工和使用过程中产生降解与老化,提高塑料制品的质量和减少性能的分散性;采用合理的工艺条件,确保添加剂的均匀分散与减少玻纤的磨损,得到适于军工、航空和机电等领域需要的高性能的受力结构工程塑料。     

Reactively sputtered MoO3 films for ammonia sensing

We report the gas-sensing properties of ion-beam sputter deposited MoO₃ thin-films. The change in the DC conductivity was measured in dry N₂ with 10% O₂ in the presence of up to 490 ppm of NH₃, NO, NO₂, C₃H₆, CO and H₂. At ∼440 °C the film was found to be very sensitive to NH₃, with 490 ppm increasing the conductivity by approximately a factor of 70. This was approximately 17 times greater than the response to the other gases. The NH₃ response was strongly affected by the accompanying levels of O₂, NO₂ and H₂O. For example, changing the accompanying O₂ levels from 1% to 20% decreased the NH₃ response by approximately a factor of 20. Similarly, the presence of 100 ppm NO₂ (in 10% O₂) decreased the NH₃ response by approximately a factor of three, and 1% water vapor decreased it by more than a factor of two. The NH₃ response, however, was relatively unaffected by 100 ppm of accompanying NO, C₃H₆, CO or H₂. XPS measurements show that the increased conductivity in the presence of NH₃ was also accompanied by a partial reduction of the surface MoO₃. We observed an increase in the resistance of the films after extended time at elevated temperatures.