聚酰胺微胶囊缓释动力学性能的影响

通过对染料微胶囊缓释性能进行定量研究,制备出一种环保型分散染料微胶囊。文中使用紫外-可见分光光度计测定分散染料微胶囊中染料扩散到丙酮溶液中的吸光度,并通过非线性函数方程Boxlucasl对实验数据进行拟合,建立了与微胶囊缓释性能规律相适应的数学模型。通过对这一模型的分析,得到制备过程工艺条件对聚酰胺分散染料微胶囊缓释性能的影响规律,并得到制作环保型分散染料微胶囊所需要的条件。     

双颗粒提升管中细颗粒的混合行为研究(Ⅱ)──弥散颗粒的轴径向混合行为

利用磷光颗粒示踪技术，使用点源示踪的方法在不同的径向位置测得反映颗粒径向扩散行为的停留时间分布曲线，并对弥散细颗粒的径向混合行为进行了分析．提出二维扩散模型描述所测量的停留时间分布曲线特征．实验发现弥散细颗粒的径向扩散Peclet数随粗颗粒加入量的增加而增加，随细颗粒浓度的增大而增大，而几乎不随气速变化．给出了一个与实验数据吻合较好并可适用于单颗粒提升管的关联式．     

甲醇在聚苯胺修饰铂钼共沉积电极上的催化氧化

用恒电位法和循环伏安法在铂电极上分别制备了聚苯胺修饰的分散氢钼青铜电极和分散铂电极,以及聚苯胺修饰的不同铂钼比例的铂与氢钼青铜共沉积电极。用循环伏安法研究了制备电极在c(H2SO4)=0.5mol/L水溶液中的电化学行为,以及对c(CH3OH)=0.1 mol/L的催化氧化行为。其中,分散氢钼青铜电极对甲醇无催化氧化的作用,铂与氢钼青铜共沉积电极对甲醇的催化氧化效果优于分散铂电极。铂-氢钼青铜共沉积电极对甲醇氧化的催化能力与共沉积铂钼的比例有关,当制备电极所用的溶液中n(氯铂酸)∶n(钼酸钠)=2∶1时,共沉积电极对甲醇的催化氧化活性最高,此时甲醇在共沉积电极上的氧化峰电流是单纯铂电极的2.632倍。     

Promotion of hydrogen permeation on metal-dispersed alumina membranes and its application to a membrane reactor for methane steam reforming

A mesoporous membrane for selective separation of hydrogen was prepared usingthe sol-gel method. Some metal salts such as RuCl₃, Pd(NH₃)₄Cl₂, RhCl₃,, and H ₂PtCl₆, were added to the boehmite sol and coated on a porous alumina substrate before firing at 500°C. It was foundthat the permeability of hydrogen and the separation factor for a hydrogen-nitrogen gaseous mixture of these metaldispersed membranes exceeded the limitations of the Knudsen diffusion mechanism. Although the gas permeation through a neat alumina membrane is governed by the Knudsen diffusion, the metals dispersed in alumina membranes were effective in promoting hydrogen permeation. These metaldispersed alumina membranes were also used in a membrane reactor for methane steam reforming at low temperature. In the temperature range of 300 to 500°C, the membrane reactor attained a methane conversion twice as high as the equilibrium value of the packed bed catalytic reactor system as a result of the selective removal of hydrogen from the reaction system.     

Zr+Er及Zr+Y对Al-Mg-Si-Cu-Mn-Cr合金组织和拉伸力学性能的影响

采用光学显微镜(OM)、电子显微镜(SEM)、能谱分析仪(EDS)、透射电子显微镜(TEM)和拉伸强度试验研究了0.3%Zr+0.2%Er和0.3%Zr+0.2%Y(质量分数)两种元素组合对Al-0.6Mg-0.9Si-0.5Cu-0.5Mn-0.2Cr合金热处理前后微观组织和力学性能的影响。研究结果表明,两种元素组合的加入均能细化铸态晶粒,其中Zr+Y改性合金的晶粒细化更明显,且两种改性合金铸态的强度和塑性均较基体合金提高。在热处理过程中,两种元素组合会影响合金中弥散相的析出,降低合金的弥散强化效果。最终,Zr+Er改性合金的强度较基体合金提高,而Zr+Y改性合金的强度则较基体降低,两种合金的塑性均较基体降低。     

Nanoparticle‐embedded polymer‐dispersed liquid crystal for paper‐like displays

Abstract— A polymer‐dispersed liquid‐crystal (PDLC) matrix template embedded with nano/microparticles can be backfilled/infiltrated with a dye‐doped liquid crystal for a paper‐like reflective display. In this way, a desirable degree of diffusion can be realized to reduce the viewing‐angle dependency of a gain reflector and metallic glare without changing other electro‐optical properties.     

地铁迷流测量与典型数据分析

本文通过分析地铁述流与地铁过渡电阻之间的关系，介绍了地铁迷流的测量方法，并根据已测得的地铁电位分布，对地铁典型区域的目前状况进行分析。     

A novel polarizer‐free dye‐doped polymer‐dispersed liquid crystal for reflective TFT displays

Abstract— A novel preparation method for dichroic dye‐doped polymer‐dispersed liquid crystals has been developed. This was achieved by creating a porous polymer matrix first by washing out the liquid crystal from a polymer‐dispersed liquid crystal (PDLC), which is then refilled with dye‐doped liquid crystal. Optimizing the liquid crystal used in the refilling results in decreased turn‐on voltage and faster response time. Poster‐standard reflectivity and newspaper‐standard contrast was demonstrated with a 3.8‐in. QVGA reflective TFT display with a drive voltage of 10 V.     

Visualized measurement of extremely high-speed droplets in Venturi scrubber

Venturi scrubbers for filtered venting have been installed in nuclear power plants worldwide. Venturi scrubbers can eliminate fission products from a polluted gas by interaction through gas–liquid interfaces. Therefore, droplet diameter is important from the viewpoint of decontamination. When Venturi scrubbers are used in severe accidents, the gas flow velocity might be extremely high. In these studies, the authors did not measure droplet diameter under extremely high gas velocity conditions. In the scenarios, experimental data pertaining to droplet diameter, under the extremely high gas flow velocity, are required. Therefore, this objective is to evaluate the diameter of extremely high-speed droplets. A visualization experiment was conducted using a Venturi scrubber. The droplet diameter distribution and the Sauter mean diameter (SMD) were determined. By comparing between the experimental value of SMDs and the one evaluated using Nukiyama–Tanasawa equation, it was confirmed that the Nukiyama–Tanasawa equation can be used to evaluate SMD with good accuracy in the gas velocity range of 82–250 m/s, except the highest gas velocity conditions. Furthermore, the droplet generation mechanism in the Venturi scrubber was considered to clarify the main reason why the Nukiyama–Tanasawa equation can be used to evaluate SMD droplet diameter.     

Fest‐Flüssig‐Trennung von feindispersen Suspensionen durch Pressfiltration bei pulsierendem Überdruck

The productivity of filtration systems for dewatering of finely dispersed suspensions can be increased by pulsating overpressure. For suspensions of marine organic‐mineral sediments, press filtration processes were investigated under static and pulsating overpressure. The influence of the static pressure component, the pressure amplitude characteristic, the pressure vibration frequency, and the filtration time on the volume of filtrate were determined. Based on Darcy's law, a model of the filtration process under static overpressure was developed. For pulsating overpressure, the mathematical theory of experiment planning and the statistical data analysis method were used.