红外化学遥感数字信号处理算法的研究进展

介绍了几种为远距离红外蒸汽信号监测开发的分类器设计，频域数字滤波，时域数字滤波等数字信号处理技术。对线性分类器，分段线性分类器和神经网络分类器等在红外化学遥感系统中的应用做了初步的探讨。对背景扣除技术，频域数字滤波技术，数字滤波的切趾方法等做了简要的描述。阐述了时域滤波技术的基本原理及实际应用。展望了红外化学遥感数字信号处理算法的研究前景。     

长25-29井卡钻事故的处理

长２５－２９井在完井阶段通井过程中发生粘附卡钻事故，在处理卡钻过程中又发生卡套铣筒、井漏、溢流等事故及复杂情况。通过对井下情况的认真分析，采取先堵漏后循环再解卡的处理方案，顺利地解除了该次卡钻事故，大大地减少了经济损失。     

低银医用X光胶片的研制

对几种增黑剂进行了筛选实验研究，选用了两种增黑剂组合使用，提高了遮盖力，使医用Ｘ光胶片涂布银量由原业的９ｇ／ｍ２降到了６．８ｇ／ｍ２，与美国医用Ｘ光胶片涂布银量（６．７ｇ／ｍ２）相当，照相性能不低于国产医用Ｘ光胶片。     

�ø������ռ�ͬʱ�ѳ���Ȼ���е������ˮ

本文介绍了采用复合吸收剂净化天然气的试验结果,在现有三甘醇等脱水剂中添加单乙醇胺,在脱水的同时脱除H_2S,在保证净化气露点低于-21℃的条件下,使净化气中H_2S含量亦低于5mg/m～3。     

Effects of a Nd—Fe—B magnetic filler on the crystallization of poly(phenylene sulfide)

The crystallization of poly(phenylene sulfide) (PPS) in a polymer–magnetic Nd—Fe—B powder suspension was studied. Isothermal crystallization behavior was analyzed by way of differential scanning calorimetry, and the kinetics were described via the Avrami equation. The Avrami parameters and the crystallization times were strongly affected by both the particle size and the presence of a coupling agent coated on the filler particles. The small Nd—Fe—B particles exhibited long induction and half‐times, whereas the large particles tended to have short crystallization times. Particles ranging from 38 to 150 μ appeared to have similar crystallization times and to have no significant change in the value of Avrami index with melt crystallization temperature. As a result of these analyses, the dynamic mechanical properties were determined to correlate the fundamental polymer crystallization characteristics and the physical properties of the PPS binder. The enhancement of the wetting of the filler to the binder was promoted through the coupling agent, as confirmed by dynamic mechanical testing performed on the samples. The storage modulus typically decreased because of the presence of the uncoated small particles. Conversely, the loss modulus was enhanced because of the presence of the coated small particles in the PPS binder. © 2002 Wiley Periodicals, Inc. J Appl Polym Sci 83: 1091–1102, 2002     

Energy Value of Resistant Starch

Resistant starch was evaluated for energy value using fine silica and normal starch as controls and young rats as a test model. The net increase in rats' carcass energy due to the test materials fed over a 3-wk period formed the basis for assessing energy value. Rats fed normal starch deposited about twice as much fat and significantly more protein in the carcass than those fed either resistant starch or silica. Rats fed resistant starch or silica showed similar growth responses and increases in components of body composition and carcass energy content. This suggested that resistant starch provided, like silica, no energy.     

乳化炸药的高温化学发泡

文中在阐述ＮＨ４ＮＯ３－ＮａＮＯ２－Ｈ２Ｏ发泡体系的发泡机制的基础上，推导出了就获得较低的反应速率ｒＲ和气体生成量ｎ的高ｐＨ值对高温的平衡关系，从而提出了高温发泡技术。     

阳离子化多元醇防塌剂的研制

室内研究和现场应用表明,聚乙烯醇类防塌剂表现出较明显的增粘负效应,可引起钻井液粘度的急剧增加,严重影响其推广应用.通过金属盐催化降解和阳离子化反应,研制出了抑制性好且增粘负效应低的阳离子化改性多元醇防塌剂.考察了阳离子化试剂、反应温度、反应时间对取代度、反应效率和产品主要性能的影响,得出了阳离子化多元醇防塌剂最佳制备条件,即：PVA与阳离子化试剂物质的量比为1：1,反应温度为50℃,反应时间为4 h,阳离子度可达0.435.     

聚合磷硫酸铁制备及净化含铅废水的试验研究

以钛白粉副产品绿矾为主要原料,氯酸钠作氧化剂,调节亚铁离子与硫酸根离子之间摩尔比后微波作用仅几分钟就能合成出液体聚合硫酸铁,并在此基础上加入磷酸根离子可得到所需絮凝剂--聚合磷硫酸铁;试验了该絮凝剂最佳合成工艺条件;采用该试剂净化含铅废水,取得了较好去除效果,并且探讨了除铅最佳试验条件.     

一种有机硫类絮凝剂DTC的合成及性能评价

讨论了由有机伯胺或仲胺和CS2合成二硫代氨基甲酸盐DTC的反应及副反应,简介了合成工艺。根据红外光谱确认了由三乙烯四胺合成的二硫代氨基甲酸盐（以下简称DTC）的结构。以含原油350 mg/L、含悬浮固体55.1 mg/L,含Fe^2＋10.0 mg/L的模拟污水为实验水样,考察了该DTC的絮凝性能,在40℃、pH=6-7、沉降时间30分钟条件下DTC的适宜加量为20 mg/L,此时污水含油量为9.0 mg/L;使用DTC的适宜pH范围在4-8,pH=6为最佳值,适宜温度范围为10-45℃,温度高于45℃时DTC可发生热分解;DTC的除油效果随污水中Fe^2＋浓度增大而改善。在含油89.1 mg/L、含悬浮固体55.1 mg/L、含Fe^2＋13.2 mg/L的油田污水中,DTC的除油率最高,远高于常用絮凝剂PFS,PAC,CPAM,HPAM和PAM。当污水中不含Fe^2＋时,DTC无絮凝除油效果。讨论了DTC在Fe^2＋参与下的絮凝过程。图5表1参8。