低速爆轰管对黑火药的点传火性能研究

文章采用中心点火管结构的实验装置研究了黑火药的点传火性能。用低速爆轰 (L VD)中心点火管来点燃黑火药时 ,1# ～ 3# 大粒黑药的传火速度为 70 0 m· s-1～ 80 0 m· s-1数量级 ,燃烧波宽度在 3.1ms～ 3.5 ms,最大压力峰值 :1# 为 36 .4 MPa,2 # 为 2 4 .0 MPa,3# 为 38.0 MPa。用普通中心点火管点燃黑火药时 ,2 # 、3# 和钝化 2 # 大粒黑的传火速度分别为 6 1.2 m· s-1、6 8.2 m·s-1和 4 0 .1m· s-1,最大燃烧波宽度分别为 9.2 ms、6 .3ms和 9.5 ms。燃烧波表明 ,L VD中心传火管与普通中心传火管相比较 ,在传火管的不同位置处 ,前者的 P- t曲线一致性远高于后者。     

利用短周期地脉动推断深层地基S波速度

从二维随机波场的相关理论出发，提出了如何从短周期地脉动（频率＞０．５Ｈｚ）时域信号中计算Ｒａｙｌｅｉｇｈ波弥散曲线，进而反演深层地基剪切波（Ｓ波）速度的理论方法和分析技术，并结合实测信号的分析结果，探讨了该方法的可行性和实用性。     

电路板故障诊断中神经网络信息融合技术的应用

将信息融合技术应用到导弹电子设备的电路板故障诊断之中．提出了一种基于红外热成像实验的温度故障隶属度函数构造形式以及改进的BP神经网络算法。进行了BP神经网络信息融合故障诊断的实验研究．从结果看信息融合能较好地解决电路板元件故障诊断的不确定性问题。     

Extraction of Singular Points from Dense Motion Fields: An Analytic Approach

In this paper we propose a new method to extract the vortices, sources, and sinks from the dense motion field preliminary estimated between two images of a fluid video. This problem is essential in meteorology for instance to identify and track depressions or convective clouds in satellite images. The knowledge of such points allows in addition a compact representation of the flow which is very useful in both experimental and theoretical fluid mechanics. The method we propose here is based on an analytic representation of the flow. This approach has the advantage of being robust, simple, fast and requires few parameters.     

孔板—均速管组合法测量汽—水两相流双参数

利用孔板与均速管组合在线测量汽—水两相流双参数，解决了稠油热采中同时测量蒸汽流量与干度的难题。其工作程序用Mcs-51单片机汇编语言编制而成，主程序由初始化、数据采集处理，热物理参数生成、汽—水两相流量、干度、质量流量、热量计算以及累计运算等模块组成。通过在现场进行标定；干度用化验CI^-法进行标定，流量用锅炉入口的涡轮流量计标定。经胜利和新疆两油田进行的大量试验可知，该仪表测量水蒸汽流量和干度其均方差皆小于7%，满足了工业应用要求。     

不锈钢绕带容器环板与绕带端头的焊接

本文通过焊接试验对奥氏体不锈钢绕带容器环板与绕带焊接工艺进行了研究分析,并得出了合理的焊接方法和工艺参数。     

Macha爆炸机故障维修十一例

随着Macha遥爆系统在地震勘探中使用年限的增加，该系统在工作中时常出现各种各样的故障，本文根据其日常检修记录，分析总结了Macha系统常见的十一例故障，并从故障的现象、分析、排除三个方面对各个故障进行了详细的介绍。     

2006年SEG年会反映的各向异性研究新进展

介绍了2006年SEG年会上所反映的各向异性研究的新进展，主要包括：提高速度分析精度的各向异性速度分析参数正交化方法；影响裂隙储层预测的地震波动力学与运动学特征差异分析；验证现行裂隙硬币理论模型可靠性的不规则裂隙有效弹性参数计算分析；提高计算效率的波场延拓各向异性参数参考值优选Lloyd算法；常见TTI介质不同成像方法试验效果的比较。     

Paste Residence Time in a Spouted Bed Dryer. II: Effect of Spout Operational Conditions

Residence time distributions for an aqueous solution of 10% sodium chloride in a spouted bed dryer of inert particles were determined using the stimulus-response technique. Glass and polyethylene beads with diameters 2.6 and 3.4 mm were used as inert bodies in a cylindrical column of 14.0 cm diameter and 60° conical base. The effects of inert bodies load, air, and paste flow rates on the mean residence times and RTD were determined following 2³ factorial designs. The RTD could be correlated to the perfect mixing cell model with R² varying from 0.8684 to 0.9815. The mean residence times in CSBD varied from 10.8 to 13.9 and 10.7 to 13.3 min for glass and polyethylene beads, respectively. For both inert particles, mean residence times increased with bed height and decreased with paste feed rates. Also, terms of interaction among the factors were significant in some cases, showing a complex behavior of paste residence times. Equations obtained by response surface regression could predict mean residence times on glass and polyethylene beads with deviations lower than ±10%.     

丹江口工程大坝加高后的几个水力学问题

依托1∶100水工模型试验成果,重点介绍了丹江口大坝加高后的几个水力学问题如泄流能力、坝面压力特性、河床局部冲刷、下游河道流速流态、泄洪对电厂及航运的影响等.研究显示:大坝加高后泄流能力可满足设计要求,坝下河床冲刷加重,挑距加远,设计洪水22 300 m3/s时坝下冲坑最低点高程为43.0 m,各级泄量冲坑上游坡均缓于临界坡,也略缓于初期工程同级流量冲坑的上游坡;坝下600 m以内为护岸工程重点防护段,岸边流速为5.8～9.8 m/s;泄洪对丹江口电厂影响较小,对自备电站不利影响较为显著;最大通航流量6 200 m3/s时下游引航道口门区流态复杂,水流较混乱.