Internal-corrosion inhibitors for pipelines in heat-supply systems carrying water with a high oxygen content

The reliability of heat-supply systems is determined primarily by internal corrosion of the pipelines. The concentration of oxygen in the water exerts a major influence on the corrosion. In systems with a standard oxygen content, OéDF-Zn is a highly effective corrosion inhibitor. However, there are systems in which the quality of deaeration of the make-up water of the heat-supply system is low (or deaeration is nonexistent), and the concentration of oxygen is considerably above the standard value. Classed among these systems, for example, are the HWS systems, which are incorporated into closed heat-supply systems. The oxygen concentration in these systems is analyzed to assess the situation. __________ Translated from élektricheskie Stantsii, No. 6, June 2007, pp. 35–39.     

硫脲树脂对Cu~(2+)吸附性能研究

考察了不同吸附时间、pH值和吸附温度下,聚对苯甲酰基硫脲树脂和聚酯基硫脲树脂对Cu2+的吸附性能影响;并对吸附动力学和热力学进行了研究。     

波流环境中污染物混合的分析

本文根据垂向二维数值模型计算求解和分析了波流环境中的一维对流扩散方程中的混合系数。此二维数值模型采用非线性k-ε紊流模型封闭雷诺时均方程，应用VOF方法处理自由面。分析方法是用该二维模型计算波流环境中污染物瞬时源产生的浓度场，计算该浓度场的断面平均浓度，求此断面平均浓度的概率分布，由概率分布的方差随时间的导数得到一维对流扩散问题中的混合系数。通过算例分析，发现波流环境混合系数随着波浪周期和波 高的不同，可能大于纯流和纯波的混合系数之和，也可能比纯流情况下小；波周期与混合系数呈正比。且存在一个使混合系数最大的波高。     

Cyclamate intake and cyclohexylamine excretion are not related to male fertility in humans

Cyclamate and its metabolite cyclohexylamine affect male fertility in high dose animal studies, but this affect has not been investigated in epidemiological studies. This paper reports the first epidemiological study designed to investigate the possibility of a relationship between cyclamate and cyclohexylamine and male fertility in humans, in which 405 cases of clinically defined infertility in men and 379 controls were surveyed. Semen evaluation, urine analysis for cyclamate and cyclohexylamine and dietary questionnaires were compared between cases and controls. No evidence was found of a significant association between cyclamate intake and male infertility; neither high cyclamate nor high cyclohexylamine excretion were associated with elevated risk. The lack of association remained after adjusting by age, area of residence, education, total energy intake and other variables. No significant correlations were observed between cyclamate intake, metabolism or excretion, and sperm count and motility. The results demonstrate no effect of cyclamate or cyclohexylamine on male fertility at the present levels of cyclamate consumption.     

Optimal control of accelerator concentration for resin transfer molding process

Resin cure following mold filling is an essential element in resin transfer molding. To fabricate a composite part with high dimensional stability and minimize residual stress, uniform resin cure should be achieved. This study considers a three-part resin system composed of epoxy, hardener and accelerator. The cure kinetics can be controlled by the accelerator concentration at the injection gate. A numerical method that can predict degree of cure distribution based on accelerator concentration at the gate was proposed. The degree of cure distribution is obtained by solving the resin flow, heat transfer, accelerator concentration and cure problems sequentially. Utilizing this numerical method, an optimal variation of accelerator concentration during mold filling was sought by solving a constrained optimization problem. The effect of accelerator control on degree of cure distribution was investigated and its validity was examined for two different geometries.     

PH值对化学沉积制备CdS薄膜性质的影响

实验研究了pH值对化学沉积制备CdS薄膜性质的影响。表明：在柠檬酸钠作为络合剂的体系中随着溶液中氨水浓度的提高CdS薄膜会发生相变，从立方相变为六方相，即当氨水浓度为0．31M时，得到立方相的CdS薄膜；而当氨水的浓度大于0．51M时，得到六方相的CdS薄膜。氨水浓度的提高也使得CdS薄膜的形貌有了很大的改善，且制备得到的CdS薄膜从富CA变为富S，但是薄膜仍是n型。氨水浓度对CdS薄膜的光学性质也有很大的影响，随着氨水浓度的提高所得到的CdS薄膜的禁带宽度增大。     

Ion implantation effect on atomic structure of deformed Si, Ir, W, Ni and Cu

It has been revealed, that in Ir subjected to severe plastic deformation, an ultrafine grained structure (UFG) is formed (the grain size of 20-30 nm). Practically no defects have been detected within the grains, while, in the case of Ar⁺ implantation, the subgrain structure with characteristic sizes of about 3-5 nm is formed; defects have been detected within subgrains.The subgrain structure was also revealed in UFG Ni and Cu after severe plastic deformation (SPD) (subgrain size of 3-15 nm), but in the latter case the observed boundary region is broader and subgrain is highly disoriented.     

Diffusion-controlled size-selective chloride ion sensing in the presence of bromide ion using a thin, nanoporous, plasma-polymerized coating on an Ag/AgCl electrode

We have developed a diffusion-controlled size-selective method for sensing chloride ion in the presence of bromide ion, based on a thin, nanoporous, plasma-polymerized coating of hexamethyldisiloxane on an Ag/AgCl electrode. Sub-nanometer-sized pores responsible for a highly cross-linked polymer network in the plasma-polymerized coating allowed diffusion-controlled permeation of chloride ion while blocking the larger bromide ion. An electrode coating of thickness greater than 70 nm enabled chloride detection in the concentration range 1-10 mM in the presence of 0.63 mM bromide ion. Advantages of this approach are: (1) simple design compared with ionophore-based strategies and (2) compatibility with microfabrication and mass production processes.     

Secondary ion emission from Ti and Si targets induced by medium energy Ar ion bombardment - Experiment and computer simulation

The paper presents experimental results of secondary ion energy distributions obtained for Ti and Si targets bombarded by 20-30 keV monoisotope Ar⁺ ion beam. The influence of the extraction voltages between target and a slit of the electrostatic energy analyzer entrance on the energy distributions of secondary ions was investigated. After optimization of the secondary ion extraction system, the mass spectra of secondary ions were also measured. The investigations were done using recently built experimental system. Experimental data are compared with the computer simulation results obtained using TRQR and SATVAL codes.     

铅锌选矿厂废水回用研究

简述了铅锌选厂废水回用小型试验及工业试验情况，在基本上不改变工艺结构基础上改变药剂制度达到废水回用的目的，使选矿废水回用率达到80％，实现尾矿库废水零排放。