A hybrid extended finite element/level set method for modeling phase transformations

A hybrid numerical method for modelling the evolution of sharp phase interfaces on fixed grids is presented. We focus attention on two‐dimensional solidification problems, where the temperature field evolves according to classical heat conduction in two subdomains separated by a moving freezing front. The enrichment strategies of the eXtended Finite Element Method (X‐FEM) are employed to represent the jump in the temperature gradient that governs the velocity of the phase boundary. A new approach with the X‐FEM is suggested for this class of problems whereby the partition of unity is constructed with C¹(Ω) polynomials and enriched with a C⁰(Ω) function. This approach leads to jumps in temperature gradient occurring only at the phase boundary, and is shown to significantly improve estimates for the front velocity. Temporal derivatives of the temperature field in the vicinity of the phase front are obtained with a projection that employs discontinuous enrichment. In conjunction with a finer finite difference grid, the Level Set method is used to represent the evolution of the phase interface. An iterative procedure is adopted to satisfy the constraints on the temperature field on the phase boundary. The robustness and utility of the method is demonstrated with several benchmark problems of phase transformation. Copyright © 2002 John Wiley & Sons, Ltd.     

非织造产业中塑胶网带的用途

介绍了塑胶网带的用途和网带的种类 (玻璃纤维网带、金属网带和塑胶网带 )及其优缺点 ,并对网带的透风率、网带清理及网带收缩等问题进行了讨论     

三峡水电站坝后钢衬钢筋混凝土压力背管的非线性有限元分析

采用钢筋混凝土非线性有限元方法，对三峡水电站钢衬钢筋混凝压力管道结构进行了计算，求得了各种钢材配置下的荷载效应并进行了相应的分析。     

三维有限元法分析频率对接地电阻的影响

提出了用涡流场的A-V有限元分析方法计算接地系统接地电阻的方法,分析了入地电流频率的变化对接地电阻的影响。计算结果表明,频率对接地体自身电阻的影响较大,但对散流电阻的影响很小。     

Ion implantation effect on atomic structure of deformed Si, Ir, W, Ni and Cu

It has been revealed, that in Ir subjected to severe plastic deformation, an ultrafine grained structure (UFG) is formed (the grain size of 20-30 nm). Practically no defects have been detected within the grains, while, in the case of Ar⁺ implantation, the subgrain structure with characteristic sizes of about 3-5 nm is formed; defects have been detected within subgrains.The subgrain structure was also revealed in UFG Ni and Cu after severe plastic deformation (SPD) (subgrain size of 3-15 nm), but in the latter case the observed boundary region is broader and subgrain is highly disoriented.     

核材料检测仪的研制

在原来只适于检测(射线的苯基塑料闪烁体上涂以ZnS薄层，使之对γ射线也有很高的灵敏度。根据光电转换原理，采用PC为主控，并用单片机作为数据预处理器，通过标准串口通讯，构成硬件冗余模式；另外，将传统的直通道设计成直角形，使之既能检测金属容器，又能识别强放射性物质；同时，在出口端加装了限速／位阻拦装置，从而解决了γ射线-金属双重识别，反辐射屏蔽和防高速闯关等难题，大大提高了检测系统的可靠性。PC的数据库操作和远程通信等功能使得本仪器能满足现代高端应用的要求。实测表明，本仪器灵敏度高，可靠性好。对应于3mg的U^235仪器报警响应时间小于0．6s，而拦截动作响应时间不大于2s。     

用FEM/FIM研究单壁碳纳米管束

利用范氏力将单壁碳纳米管样品组装到钨针尖上 ,用FEM/FIM对同一碳纳米管样品用热处理方法和场脱附方法进行了研究。场离子显微镜是具有原子级分辨能力的尖端表面分析工具 ,由场离子像推测这次组装的样品是由三根单壁碳纳米管突起组成的碳纳米管束。清洁碳纳米管束样品的场发射像和场离子像有极好的对应关系。场脱附后的碳纳米管束的场发射特性较好地符合Fowler Nordheim场发射模型。通过比较碳纳米管束吸附态和热处理后以及场脱附后的Fowler Nordheim曲线的斜率变化 ,得出碳纳米管束样品逸出功的变化 ,再结合场发射像的变化推断出场脱附与热处理结合是一种较理想的获得清洁碳纳米管表面的方法     

X-Ray Measurement of Residual Stress in Plastic Bonded Explosives

The X-ray diffractive technology was adopted for tentative study of plastic bonded explosive. The datum of some new diffractive peaks in standard PDF cards were added. The effects of strain to interplanar distance and crystal size of the explosive were studied. The results show that grain size of plastic bonded explosive is decreasing with the increasing of the pressure, and the residual stress of the explosive is draw stress.     

金属包覆平板波导模式特性的有限元法分析

采用有限元法（FEM）分析了具有复数折射率的金属包覆介质波导的模折射率与模场分布情况。计算了具有损耗层的6层介质平板波导模折射率，并与解析解比较，二者有较好的一致性；分析了金属包覆3层平板波导中TM模折射率与波导芯厚度的变化关系，计算了金属包覆5层平板波导中TM模折秧经与金属层厚度的变化关系，并结合对模场分布的分析对模式进行了定性判断，给出了其模式演变过程。     

强度储备法在飞来峡土坝稳定性分析中的应用

强度储备法抓住影响坝体稳定因素中最关键的强度指标，通过研究不同强度参数所对应的破坏区域的演变关系，分析坝体的稳定性和潜存的破坏机理，在混凝土坝和岩体结构的稳定分析中得到了普遍应用。但将强度储备法应用于土坝稳定性分析中属首次，以飞来峡水利枢纽土坝为例，采用二维有限元强度储备法对其稳定安全系数进行了计算分析，研究了边坡的失稳破坏机理，对安全性进行了评价，为运行管理提出了一些有益的参考意见。