地球化学录井技术的发展和应用

简要介绍了国内地化录井技术的发展历程，分析了该技术的特点及在油气勘探开发应用中取得的成效。认为中国地化录井技术在引进、消化、吸收的基础上，扩展了该技术的应用领域和范围，目前该专业的整体技术水平处于国际领先地位。在以统计资料及应用实例报道该技术的应用成果及独特技术优势的同时，也分析了存在的问题，指出了解决问题的主要途径。     

Inverted Solution Processable OLEDs Using a Metal Oxide as an Electron Injection Contact.

A new type of bottom‐emission electroluminescent device is described in which a metal oxide is used as the electron‐injecting contact. The preparation of such a device is simple. It consists of the deposition of a thin layer of a metal oxide on top of an indium tin oxide covered glass substrate, followed by the solution processing of the light‐emitting layer and subsequently the deposition of a high‐workfunction (air‐stable) metal anode. This architecture allows for a low‐cost electroluminescent device because no rigorous encapsulation is required. Electroluminescence with a high brightness reaching 5700 cd m^–2 is observed at voltages as low as 8 V, demonstrating the potential of this new approach to organic light‐emitting diode (OLED) devices. Unfortunately the device efficiency is rather low because of the high current density flowing through the device. We show that the device only operates after the insertion of an additional hole‐injection layer in between the light‐emitting polymer (LEP) and the metal anode. A simple model that explains the experimental results and provides avenues for further optimization of these devices is described. It is based on the idea that the barrier for electron injection is lowered by the formation of a space–charge field over the metal‐oxide–LEP interface due to the build up of holes in the LEP layer close to this interface.     

硫酸钙氨法制取硫酸钾新工艺的实验研究

利用K2 +2 ,Ca2 +/ /SO2 -4 ,Cl2 -2 ,NH3—H2 O混合体系相图作为工艺指导 ,进行硫酸钙制取硫酸钾工艺的相图研究和分析 ,确定实验优选因素及水平并进行正交实验 ,根据实验结果进行极差分析 ,得出新的结论。合适的工艺条件为 :氨浓度为 40 % ,配料比n( 2KCl) :n(CaSO4 ·2H2 O)为 1:1,反应温度为 5℃ ,反应时间为 1h。     

加氢处理润滑油基础油各组分对光安定性的影响

将经紫外光照前后的加氢处理润滑油基础油分离为饱和烃、轻质芳烃、中质芳烃、重质芳烃和极性组分，分别采用薄层色谱、质谱和紫外吸收光谱分析了各组分的烃组成、硫和氮含量的变化，并通过将从原料油中分离出的各组分反加到光安定性好的饱和烃中，试验验证了加氢处理润滑油基础油中的重质芳烃和极性组分是光不安定组分，其中含有硫、氮的芳香杂环化合物光安定性差。     

液晶光阀光电导层光吸收系数的研究

用化学气相沉积法制备了液晶光阀中光电导层———非晶硅薄膜,从实验中得出最佳制备工艺的参数取值。给出了用包络线法测量非晶硅薄膜光吸收系数的原理,测量了样品的光吸收系数随波长的变化规律。得到样品在最佳工艺条件下的光吸收系数高于1×103cm-1。     

人脸识别研究进展

人脸识别技术在各种应用的推动下发展很快。而近几年中，为避免各种实际应用环境的限制，非约束环境下的人脸识别也得到了很大的发展。本文概述了人脸识别的一些主要方法，讨论了影响人脸识别的几个主要因素及其处理方法以及基于视频的人脸识别技术，最后指出了鲁棒的人脸识别技术的研究方向和发展前景。     

Distributed Optical Fiber Sensor for Multi-point Temperature Measurement

The distributed optical fiber sensing technology is overviewed, which is based on Raman scattering light theory. Basic operation principle, structure, system characteristics and signal processing are discussed. This structure and method of the signal processing possess of certain spatial resolution, hence will ensure the practicability of system.     

Pool boiling on a superhydrophilic surface

Titanium Dioxide, TiO₂, is a photocatalyst with a unique characteristic. A surface coated with TiO₂ exhibits an extremely high affinity for water when exposed to UV light and the contact angle decreases nearly to zero. Inversely, the contact angle increases when the surface is shielded from UV. This superhydrophilic nature gives a self-cleaning effect to the coated surface and has already been applied to some construction materials, car coatings and so on. We applied this property to the enhancement of boiling heat transfer. An experiment involving the pool boiling of pure water has been performed to make clear the effect of high wettability on heat transfer characteristics. The heat transfer surface is a vertical copper cylinder of 17 mm in diameter and the measurement has been done at saturated temperature and in a steady state. Both TiO₂-coated and non-coated surfaces were used for comparison. In the case of the TiO₂-coated surface, it is exposed to UV light for a few hours before experiment and it is found that the maximum heat flux (CHF) is about two times larger than that of the uncoated surface. The temperature at minimum heat flux (MHF) for the superhydrophilic surface is higher by 100 K than that for the normal one. The superhydrophilic surface can be an ideal heat transfer surface. Copyright © 2002 John Wiley & Sons, Ltd.