On the hollowness ratio effect on the dynamics of a spinning Rayleigh beam

The analytical solutions of a spinning Rayleigh beam with rotatory moment inertia and gyroscopic effect are presented in this paper. The critical speeds can be written analytically in a function of the length-to-radius ratio (l) defined by the beam's length over its outer radius and the hollowness ratio (α) defined by the hollow area over the total area of the cross section. The sensitivity analyses show that the critical speed is decreasing with l, but increasing with α. Moreover, α is more sensitive to the critical speeds. The design of a spinning beam should therefore be emphasized more on the hollowness factor. Contrary to common belief, only finite critical speeds exist and the number is independent of the boundary conditions. It increases monotonically with l, but decreases with α. The steady state unbalanced response can therefore be expressed analytically by the finite precessional modes and the corresponding generalized coordinates.     

Nutrient removal performance of an anaerobic–anoxic–aerobic process as a function of influent C/P ratio

The laboratory scale anaerobic–anoxic–aerobic (A²O) process fed with synthetic brewage wastewater was designed to investigate the effects of changing feed C/P ratio on the performance of biological nutrient removal (BNR) processes. In the experiment, the influent chemical oxygen demand (COD) concentration was kept at approximately 300 mg L^?1 while the total phosphorus concentration was varied to obtain the desired C/P ratio. Results showed that when the C/P ratio was lower than 32, phosphorus removal efficiency increased as C/P ratio increased linearly, while when the C/P ratio was higher than 32, the P removal efficiency was maintained at 90–98%, and effluent P concentration was lower than 0.5 mg L^?1. However, regardless of the C/P ratio, excellent COD removal (90% or higher) and good total nitrogen removal (75–84%) were maintained throughout the experiments. It was also found that very good linear correlation was obtained between COD uptake per unit P released in the anaerobic zone and C/P ratio. In addition, the P content in the wasted activated sludge increased with the decrease in the C/P ratio. Based on the results, it was recommended that the wastewater C/P ratio and its effects be incorporated into BNR design and operational procedures, appropriate C/P ratios were used to achieve the effluent treatment goals. Copyright © 2005 Society of Chemical Industry     

复合沉淀氯化镨钕工艺研究

针对草酸沉淀成本高的问题，提出了复合沉淀的方法，试验结果及生产应用都证明了此方法能达到降耗同效的目的。     

Influence of geosynthetic reinforcement on the load-settlement characteristics of two-layer subgrade

The possibility of realistic prediction of two-layer subgrade load-settlement characteristics is discussed. The case of improvement of the soft subgrade properties using the geosynthetic reinforcement placed at the boundary between two different subgrade layers is analysed. In the first part of the paper, a short review of the main conclusions from experimental results dealing with the influence of geosynthetic reinforcement on the load-settlement characteristics of subgrade is presented. Then, the results of using the selected analytical membrane-action model to describe the reinforcement action in soil are discussed. The model is verified on the basis of data obtained from previously published laboratory tests. Particular attention is devoted to influencing some basic initial parameters on the accuracy of obtained results. Important problems which need intensive investigations are identified.     

承压水漏斗地区地下水位时空分布预报的BP网络模型

依据水均衡原理，导出承压水漏斗区任意一点水位与其影响因素之间的复杂的非线性关系，在此基础上提出承压水漏斗水位时空分布预报的BP神经网络模型。该模型具有 分布参数模型的特征，且不需用到区域的水文地质参数。最后针对某实例进行了模型设计及预报分析，通过对部分观测井后期实测数据的训练，优选出双隐层的网络结构及其网络参数。随后用这些观测井的前3年数据进行了检验，并对其他观测井数据进行预报。计算表明，该模型对地下水位拟合与预报的合格率较高，可以获得研究区域某一时刻水位在空间上的分布。     

流域输沙模数与流域面积关系研究

提出至今所有流域泥沙输移比与流域面积关系其实质都是流域输沙模数与流域面积的关系。前人的流域输沙模数与流域面积关系的研究结论认为一般都是呈现反比关系，黄河中游流域输沙模数与流域面积不是这样的关系，这是一个特例。本文通过三个不同层面，即长江干流、黄河干流，长江上游、黄河中游主要支流及任意流域的流域输沙模数与流域面积关系的分析研究，认为黄河中游流域输沙模数与流域面积不是反比关系，这不是特例。因为，长江上游无论是干流还是支流或任意流域的流域输沙模数与流域面积同样不存在一个规律的反比关系。流域输沙模数与流域面积的真正关系不是受控于流域面积的大小，而是取决于流域所在区域的地质构造单元的性质、地貌类型及土地利用的合理性等多个因素，其中最本质的是地貌类型、地质构造单元的活动性质及控制面积。本研究可以推进河流泥沙学科的发展、开拓环境学科的研究思路和有助于流域大型水库的泥沙淤积前景的科学预测；同时对流域尺度转换理论在地学中的正确应用的可能性也是有重要的启迪作用。     

降低氧化铝生产中熟料折合比的探讨

在氧化铝生产过程中，熟料折合比是烧结法一项重要的综合性指标，本文通过对熟料折合比的定义、计算公式的剖析，分析了生产过程中影响熟料折合比的主要因素，对有效降低熟料折合比的措施进行了探讨。     

复杂条件下发挥锚杆支护作用的相关技术

介绍了在特殊地质和开采条件下,发挥锚杆支护作用的几种相关技术。     

房间空调器高效节能技术分析

本文主要介绍了高效节能型空调器的优化设计，包括选用高效压缩机、增大换热面积，增大风量、管路的合理设计，旨在提高制冷量，降低功耗，提高能效比。     

基于自然地理形态的道路测设及其曲线方程的拟合

在山区村镇及风景旅游名胜区的建设中，其道路的曲线测设，往往要基于自然地理形态进行，也就是路径的选择，有时具有不可选择性，且要求与实地具有最大的符合性。因此，其测设的作业方法不同于一般意义的道路测设；其曲线方程的建立，也是极其困难的。本就基于自然地理形态的道路测设工作的曲线类型的选择、曲线的拟合方法、曲线方程的建立及其数据的计算，提出了利用CAD技术进行曲线拟合、曲线方程的建立、曲线计算的实用技术方法。