复杂膨胀性围岩条件下交岔点支护技术研究

针对复杂膨胀性围岩条件下交岔点高应力集中区围岩稳定性控制和支护技术难题，通过对交岔点围岩变形表现形式、交岔点围岩变形机理的研究分析，提出了交岔点支护难点及重点。基于围岩控制理论分析，提出了“有限让压的柔性支护+全断面封闭抗压的刚性支护技术”，前期柔性支护采用“高强、高预应力锚杆+锚索+喷浆”联合支护有限度控制围岩变形，允许围岩在可控范围内释放围岩应力|后期通过架设异形支架与支撑架组成的联合支护体并喷射混凝土对交岔点围岩进行全断面封闭抗压支护，有效控制巷道交岔点围岩的变形。确保了交岔点围岩变形的整体可控性、稳定性，达到了预期支护效果。     

Study on maximum power point tracking of photovoltaic array in irregular shadow

Traditional maximum power point tracking (MPPT) methods can hardly find global maximum power point (MPP) because output characteristics curve of photovoltaic (PV) array may have multi local maximum power points in irregular shadow, and thus easily fall into the local maximum power point. To address this drawback, Considering that sliding mode variable structure (SMVS) control strategy have such advantages as simple structure, fast response and strong robustness, and P&O method have the advantages of simple principle and convenient implementation, so a new algorithm combining SMVS control method and P&O method is proposed, besides, PI controller is applied to reduce system chattering caused by switching sliding surface. It is applied to MPPT control of PV array in irregular shadow to solve the problem of multi-peak optimization in partial shadow. In order to verity the rationality of the proposed algorithm, the experimental circuit is built, which achieves MPPT control by means of the proposed algorithm and P&O method. The experimental results show that compared with the traditional P&O algorithm, the proposed algorithm can fast track the global MPP, tracking speed increases by 60% and the relative error decreased by 20%. Moreover, the system becomes more stable near the MPP, the fluctuations of output power is greatly reduced, and thus make full use of solar energy.     

Application of differential evolution for cascaded multilevel VSI with harmonics elimination PWM switching

Harmonic elimination pulse width modulation (HEPWM) method has been widely applied to multilevel voltage source inverter (MVSI) to remove low frequency harmonics from its output voltage. However, the computation of the HEPWM switching angles for MVSI is very challenging due to several constraints, namely angle sequencing, very tight angular spacing and the numerous possibilities of angles distribution ratio. Realizing the potential of Differential Evolution (DE) to handle complex problems, this work proposes its application to solve the HEPWM problem for cascaded MVSI. Its emphasis is on improving the availability of HEPWM for higher output voltage by extending the maximum range of modulation index (M). It also removes the discontinuities in the switching angles and reduces the number of distribution ratio required to obtain the required solution. Compared to the most advanced (similar) work, i.e., 7-level MVSI with seventeen switching angles, DE covers a wider range of M; the maximum achievable M is 2.80. Furthermore, it exhibits very low second order distortion factor (DF₂): for the worst case, the value of DF₂ is 0.0014%. To verify the viability of the proposed algorithm, simulation is carried out and hardware prototype is constructed. Both results show very good agreement with the theoretical prediction.     

胸腺五肽辅助治疗肺癌对免疫功能影响及其疗效的系统评价

为了系统地评价胸腺五肽作为辅助药物治疗各种肺癌的疗效及其对机体免疫功能的影响，利用电子检索收集有关胸腺五肽联合放疗或化疗方案治疗肺癌的临床随机对照试验文献，对符合纳入标准的文献，采用RevMan5.3 软件进行系统评价。最终共纳入文献 9 篇，总样本量 784 例。Meta 分析结果表明，胸腺五肽作为辅助药物治疗各种肺癌提高总有效率的差异无统计学意义[OR ＝ 1.44, 95%CI(0.99, 2.10), P ＝0.06 ＞ 0.05]。在对免疫功能的影响方面，胸腺五肽的使用显著增高外周血中的 CD3+ 细胞水平[OR ＝ 5.88, 95% CI(2.34, 9.42), P ＝0.001]，CD4+ 细胞水平也显著上升[OR ＝8.32, 95%CI(5.22, 11.42), P ＜ 0.00001] , CD4＋ /CD8＋比值也有明显的提高[OR ＝ 0.38, 95% CI(0.18, 0.59), P＝0.0002]，但 CD8+ 细胞水平的差异无统计学意义[OR ＝－3.12, 95% CI ( －9.02, 2.79), P ＞0.05]。总的来说，本研究在一定程度上反映了在辅助治疗肺癌方面，胸腺五肽能显著提高外周血中的 CD3+ 细胞水平、CD4+ 细胞水平、CD4+/CD8+ 比值。而对于治疗的有效率、CD8+ 细胞水平，差异无统计学意义。     

内插法在相关干涉仪测向体制中的应用

测向误差的减小一直以来都是无线电测向精度提高的一个难点,对于不同的测向体制所采用的减小测向误差的方法都不尽相同。本文主要介绍的是相关干涉仪测向体制的基本原理以及通过内插法的应用来减小测向误差的方法。     

A new catalyst based on a nickel(II) complex of diiminodiphosphine for hydrogen evolution and oxidation

Based on that hydrogen energy is widely used in fuel cells, we focus our interests on the design and research of new complexes that catalyze the reaction in both directions, such as hydrogen evolution reactions (HERs) and hydrogen oxidation reactions (HORs). A highly efficient catalyst for both hydrogen evolution and oxidation, based on a nickel(II) complex, [Ni-en-P₂](ClO₄)₂, has been designed and provided by the reaction of Ni(ClO₄)₂ with N,N′-bis[o-(diphenylphosphino)benzylidene]ethylenediamine (en-P₂) in our group. Its structure has been determined by X-ray diffraction. [Ni-en-P₂](ClO₄)₂ can electro-catalyze hydrogen evolution both from acetic acid and a neutral buffer (pH 7.0) with a turnover frequency (TOF) of 204 and 1327 mol of hydrogen per mole of catalyst per hour (H₂/mol catalyst/h) under an overpotential (OP) of 914.6 mV and 836.6 mV, respectively. [Ni-en-P₂](ClO₄)₂ also can electro-catalyze hydrogen oxidation with a TOF of 111.7 s⁻¹ under an OP of 330 mV. The results can be attributed to that [Ni^II-en-P₂](ClO₄)₂ has three good reversible redox waves at 1.01 (Ni^III/II), −0.79 (Ni^II/I) and −1.38 V (Ni^I/0) versus Fc^+/0, respectively. We hope these findings can afford a new method for the design of electrocatalysts for both H₂ evolution and H₂ oxidation.     

Study on metamerism degree evaluation based on wavelength sensitive cone weighting algorithm

Metamerism phenomenon can be used in illuminant detection to ensure the accuracy of light source. A method based on Long‐, Middle‐, Short‐ wavelength cones(LMS) weighting algorithm to evaluate metamerism degree is proposed. The chromatic relationship between the degree of metamerism mismatch and the light source is studied. Herein, the consistency between the metameric indices (MIs) and CIE1976 L*a*b* color difference ranking is analyzed by SRCC, KRCC, PLCC and RMSE. A statistically sampling method to obtain practical LMS cone fundamentals to evaluate metamerism degree is employed. The analysis results obtained show that the method based on LMS weighting algorithm has good evaluation ability and stability in simulation experiments and statistically sampling experiments, which are in line with visual characteristics of human. Proposed method meets the requirements of selecting metameric pairs used in light source detection. The analysis results have certain guiding significance.     

Grain mapping to freeform surface for machining using parameter-based incremental tracking method

This paper presents a novel method for mapping a texture for machining onto a freeform surface. When a grain texture designed on a 2D plane is projected onto a freeform surface simply, the texture is distorted along the curvature of the surface in the projection direction. Therefore, a method is required to suppress this distortion. The algorithm proposed in this paper rapidly generates a point cloud that represents a texture with less distortion on a simply connected parametric surface. Specifically, four equations that express local geometry constraints instead of conventional parameterization methods are presented to reduce the distortion between adjacent points on the point cloud. Solving these equations can generate grain textures on freeform surfaces. This paper examines two grain images mapped to two freeform surfaces that were prepared as case studies to demonstrate the effectiveness of the proposed method.     

Preparation of CaO granules using the granulation method

ABSTRACT

Improving the hydration resistance of CaO particle in manufacturing and application of free CaO-containing materials has practical significance. In this study, CaO granules was made from Ca(OH)₂ particles, which were fabricated by the granulation method. The results showed that the hydration resistance of the CaO granules which was prepared under 1700?r?min^?1 was the best, the CaO granules was sintered well in calcination process, the shell of CaO granules was relatively dense, which improves the hydration resistance of CaO granules, and the rate of hydration weight increment was 0.58% after placed in the air for 20 days under a temperature of 10–14°C and a relative humidity of 57–81%.     

iM-SIMPLE: iMproved stable increased-throughput multi-hop link efficient routing protocol for Wireless Body Area Networks

Wireless Body Area Networks (WBANs) are envisaged to play crucial role in psychological, medical and non-medical applications. This paper presents iM-SIMPLE; a reliable, and power efficient routing protocol with high throughput for WBAN. We deploy sensor nodes on human body to measure the physiological parameters such as blood pressure, temperature, glucose, lactic acid, EMG, acceleration, pressure, and position. Data from sensors is forwarded to intermediate node, from where it is transmitted to sink. An end user can access the required information available at sink via internet. To minimize energy consumption of the network, we utilize multi-hop mode of communication. A cost function is introduced to select the forwarder; node with high residual energy and least distance to sink has minimum cost function value and is selected. Residual energy parameter balances the energy consumption among the sensor nodes, and least distance improves packet delivery to sink because of reduced less path loss. We formulate the minimum energy consumption and high throughput problems as an Integer Linear Program. In order to support mobility, we also consider two body postures. Simulation results confirm the performance advantage of iM-SIMPLE compared to contemporary schemes in terms of maximizing stability period and throughput of the network.