Hypoxia/Temperature/pH Triple Stimuli–Responsive Block Copolymers: Synthesis,Self-Assembly,and Controlled Drug Release

The amphiphilic block copolymer poly(methacrylic acid-co-2-nitroimidazole acrylate)-b-poly(2-(N,N-dimethylamino)ethyl methacrylate) (P(MAA-co-NIMA)-b-PDMAEMA) with the hypoxia/temperature/pH triple responsiveness is synthesized by reversible addition-fragmentation chain transfer polymerization (RAFT), hydrolysis, and 3-(3-dimethylaminopropyl)-1-ethylcarbodiimide (EDC) reactions, and successfully self-assembled into micelles. The hypoxia response in vitro is realized, and then the sensitivity of the self-assembled micelles to the hypoxia condition is studied by controlling the grafting amount of aminated 2-nitroimidazole. Because 2-(N,N-dimethylamino) ethyl methacrylate (DMAEMA) is a typical material sensitive to temperature and pH conditions, the self-assembled micelles are also responsive to temperature and different acidic/basic conditions. In addition, the cumulative release rate of doxorubicin (DOX) at 42 °C, pH = 6.0, and hypoxic conditions increases significantly, and verifies the synergistic promotion effect of the above stimulations. This intelligent polymer with triple response mechanism improves the controllability and efficiency of drug release, and is expected to be a drug carrier for cancer treatment.     

中小电机新能效等级对无取向电工钢需求的影响

电机新能效等级标准的实施,对硅钢产品提出了更高的要求。本文结合中小电机、无取向电工钢的发展,分析了电机的损耗与硅钢性能的关系,并提出了新能效等级标准实施后对无取向电工钢的需求预测。     

基于PCA-RBF网络模型的硫化矿自燃安全性研究

为了更加准确地预测硫化矿自燃安全性,综合考虑硫化矿自燃倾向性及火灾后果严重性,将硫化矿自燃安全性划分为9个等级,并选取矿山含硫量、矿山含碳量、矿石温度、矿石堆放时间、采场人员数量、氧气浓度和采场矿层厚度作为评价因素集。利用主成分分析法（Principal Component Analysis,PCA）对94个采场样本数据进行降维处理,得到包含70%以上原始信息的3个主成分。将降维后的84组数据作为基于径向基函数神经网络（Radial Basis Function Neural Network,RBF）预测模型的训练样本,10组数据作为检验样本进行硫化矿自燃安全性预测。最后分别利用十折交叉验证法和留一法对94组检验样本的自燃安全性预测结果进行检验,得到硫化矿自燃安全性预测准确率分别为92.55%和91.49%。研究结果表明：PCA-RBF网络模型对硫化矿自燃安全性的预测性能良好,且优于未经主成分分析的结果。     

B级钢中频感应熔炼用镁砂坩埚的失效与防护

根据B级钢中频感应熔炼过程中镁砂坩埚的工作环境特点,指出坩埚失效的主要形式:热应力开裂、侵蚀变薄、表层剥落、钢液渗透、表面结渣等,并对其失效机理进行分析。通过调整镁砂的颗粒级配,采用多相复合技术,在坩埚的特定区域使用特定坩埚材料的分区捣筑、合理安排烧结工艺、精心操作、精心修补。从而提高了坩埚使用寿命。     

Soft and Hard Adhesion

The force needed to pull a cylindrical stud from a soft elastomeric film depends on their elastic and geometric properties. For a rigid stud and a thick elastomeric film, the pull-off stress (σ) depends on the elastic modulus (E) of the film and the radius (a) of the stud as σ ∼ (E/a)^1/2 (soft adhesion). However, when the film is very thin, the pull-off stress is significantly higher than the case with thick films, and its value depends on the elastic modulus and the thickness (h) of the film as σ ∼ (E/h)^1/2 (hard adhesion). Here, we study the pull-off behavior of a soft cylindrical stud, one flat end of which is coated with a high modulus thin baseplate. As the flexural rigidity of this baseplate is varied, we observe the transition between the two types of adhesion. We present a simple physical interpretation of the problem, which could be of value in understanding various biofouling and adhesive situations.     

低截留分子质量新型聚芳醚腈酮超滤膜的研制

以新型聚芳醚腈酮为膜材料 ,以N -甲基 - 2 -吡咯烷酮 (NMP)为溶剂 ,研究了聚合物浓度、添加剂种类及含量、凝胶浴温度等对超滤膜性能的影响。结果表明 ,聚合物质量分数以 1 2 %～ 1 3 %为合适的制膜浓度 ,以聚乙二醇PEG - 4 0 0为添加剂时获得了高截留率和高水通量的超滤膜。随着凝胶浴温度的升高 ,水通量明显增大 ,而截留率有所下降 ,而共聚物的浓度增加则有相反的效果。制得的超滤膜具有较低的截留分子量 (PEG- 2 0 0 0 ) ,将制得的超滤膜用于达旦黄、黄X-G等染料的分离 ,截留率均达 90 %以上     

饲料级磷酸氢钙标准样品的研制

简述了饲料级磷酸氢钙标准样品的研制过程，并对样品作了稳定性试验，对搅拌设备的搅拌均匀性和物料的均匀性进行了测定，并由国家认可实验室进行了定值数据的监测。通过对比实验证明了国家实验室之间的无差异性。实验数据表明了所测定的饲料级磷酸氢钙产品是稳定和均匀的，同时简要介绍标准样品的研制程序，为开发其他化工行业标准样品奠定了基础。     

Nafcillin release from poly(acrylic acid–co–methyl methacrylate) hydrogels

Summary Copolymeric poly(acrylic acid-co-methyl methacrylate) hydrogels for three different compositions: (90/10), (80/20) and (60/40), have been studied. Drug release has been examined as a function of the hydrogel composition by HPLC (High Pressure Liquid Cromatography). The release experiments were carried out at 37 °C. The fraction of available drug release was linear in t^1/2. The values of the diffusional coefficient (0.50<n<1.0) indicate that the nafcillin release mechanism from the hydrogels in study is non-Fickian. The diffusion coefficients for this drug release have been calculated. The molecular diffusion of nafcillin through hydrogels is controlled by the swelling.     

Calculated effect of pulsed pheromone release on range of attraction

In order to assess the possible function of pulsed release of windborne pheromones, calculations were performed to predict the concentration pattern downwind of the source. Two patterns of pulsed releases (sinusoidal and instantaneous) were compared to a constant release pattern. In all three cases, the average rate of release was the same. Assuming the receiving animal needs only a momentary exposure to concentrations above threshold to respond, it is clear that sinusoidal release has a greater distance of detection than constant release and that instantaneous release is even better. The relative magnitude of the increase in range of detection depends on the ratio of average release rate to threshold concentration. Pulsed releases have a greater advantage when the threshold is high and the range of attraction is inherently short. Under these conditions, sinusoidal release can double the range of attraction and instantaneous release can increase it 10-fold. In contrast, with a low threshold and consequent long range of attraction, the pulsed patterns are lost and the increase in range is insignificant. Several testable predictions are derived from the hypothesis that the primary function of pulsed release is to extend the range and time over which a given quantity of pheromone can act.     

纤维素/聚乙二醇/维生素共混膜的制备与缓释性能研究

介绍了在纤维素/聚乙二醇体系中加入维生素C制备成药物缓释膜的过程,并研究了其在水中的药物缓释性能。结果表明,固液比、pH和温度这三个条件都对药物缓释有非常明显的影响。例如,药物在中性条件下的缓释一般是随着固液比的增大和温度的升高而加快的,但在高分子材料的结晶温度区域进行时也受到抑制。此外,在酸性环境中药物缓释在初始时是受到抑制而后逐渐以脉冲式进行。值得指出的是,药物缓释在碱性条件下完全不发生,并出现与缓释相反的吸附现象。