Zr-2/Cr反应扩散研究

研究了Zr-2/Cr扩散偶在1023－1123K范围内的反应扩散，用扫描电镜观察反应宽度，用能谱仪（EDS）测定了反应层Zr,Fe和Cr沿扩散方向的浓度分布，研究了反应层的生长动力学，结果表明，反应层生长基本符合抛物经规律，生长过程受扩散控制，用Boltzman-Matano-Heumann模型计算了Cr在反应层Zr（Fe,Cr）2中的互扩散系数D，得到了互扩散系数D与温度的Arrhenius方程，由计算的扩散数据与Cr在Zr中形成稀固溶体时Cr的扩散数据比较可知，Cr在金属间化合物Zr（Fe,Cr）2中的扩散比在稀因溶体中的扩散快5个数量级。     

变井储系数的确定方法及其在反褶积分析中的应用

中针对变井储试井分析问题，给出了确定变井储系数及计算续流量的方法，并用反褶积分析积分析方法解释了未出现径向流的早期测压数据，给出了解决早期试井资料分析问题的有效方法。     

On the boundary-layer control through momentum injection: Studies with applications

The concept of moving surface boundary-layer control, as applied to a Joukowsky airfoil, is investigated through a planned experimental programme complemented by numerical studies. The moving surface was provided by rotating cylinders located at the leading edge and/or trailing edge as well as top surface of the airfoil. Results suggest that the concept is quite promising, leading to a substantial increase in lift and a delay in stall. Depending on the performance desired, appropriate combinations of cylinder geometry, location and speed can be selected to obtain favourable results over a wide range of angle of attack. Next, effectiveness of the concept in reducing drag of bluff bodies such as a two-dimensional flat plate at large angles of attack, rectangular prisms and three-dimensional models of trucks is assessed through an extensive wind tunnel test-programme. Results show that injection of momentum through moving surfaces, achieved here by introduction of bearing-mounted, motordriven, hollow cylinders, can significantly delay separation of the boundary-layer and reduce the pressure drag. The momentum injection procedure also proved effective in arresting wind-induced vortex resonance and galloping type of instabilities. A flow visualization study, conducted in a closed-circuit water tunnel using slit lighting and polyvinyl choride tracer particles, adds to the wind-tunnel and numerical investigations. It shows, rather dramatically, the effectiveness of the moving surface boundary-layer control (MSBC). The Sabita Chaudhury Memorial Lecture The models were fabricated in the Mechanical Engineering Workshop. The assistance of M/s E Abell, P Hurren and D Camp in the design and construction of the models is gratefully acknowledged. The investigation was supported by the Natural Sciences and Engineering Research Council of Canada, Grant No. A-2181.     

TJ10—74与GBJ10—89规范受弯构件正截面抗力转换系数

分析了 TJ10—74规范受弯构件正截面诸修订因素(砼强度“双改方案”、设计表达式、正截面计算方法……).在此基础上推演出 TJ10—74与GBJ10—89两规范关于受弯构件抗力转换系数.可供结构设计使用.     

抛物形量子阱的共振隧穿

文中通过求解薛定谔方程得到抛物型形量子阱的变换矩阵与透射系数。利用这一结果计算透射系数可以达到任意高的精度，最后，讨论了结构变化对抛物型量子阱的共振隧穿的影响。     

β—BBO晶体的电光性能

用干涉法测量了β－ＢＢＯ晶体的电光系数：γ２２＝２．６，γ３３＝０．２３，γ３１＝０．２５，γ５１＝－３．５×１０－１２ｍ／Ｖ。结果表明如果在Ｙ方向加电场，Ｚ方向通光，β—ＢＢＯ晶体可能制作成有应用价值的光开关。     

基底元素表面富集与扩散阻档层

根据An－Ag系统以及An－Cu系统的扩散系数计算，提出了扩散阻挡层模型。利用这个模型对Au－Ag系统进行有关实验，得利了较好的验证。     

Calculation of second virial coefficients and gaseous viscosities of the refrigerants HFC-32 (CH2 F2), HFC-23 (CHF3), and HCFC-22 (CHC1F2)

The second virial coefficients of refrigerants HFC-32 (CH₂F₂), HFC-23 (CHF₃), and HCFC-22 (CHC1F₂) have been correlated on the bisis of site site model potential and have been compared with experimental results. The molecular interactions consisted of repulsion dispersion and electrostatic parts. From the site site potentials adjusted to the experimental second virial coefficients, spherically averaged potentials have been determined and a subsequent calculation of gaseous viscosity has been carried out. Agreement between measured and calculated values of second virial coellicients and gaseous viscosity is satisfactory. Calculated values of second virial coefficients and gaseous viscosity beyond available experimental data, therefore. can be assumed as a reliable extrapolation to lower and higher temperatures.     

Vapor-phase viscosity of phenol

New measurements of the vapor-phase viscosity of phenol were performed from 437 up to 624 K and for densities between 0.006 and 0.023 mol · L^–1 in an all-quartz oscillating-disk viscometer with small gaps. Thus, including our own measurements reported earlier, experimental data are available in the temperature range between 376 and 639 K and in the density range from 0.001 up to 0.023 mol · L^–1. The data were evaluated with a density series for the viscosity in which only a linear density contribution is included. The values of the second viscosity virial coefficient obtained for phenol as well as for benzene, toluene, and p-xylene were compared with results of the Rainwater-Friend theory and of the modified Enskog theory on the basis of the Lennard-Jones 12-6 potential. The agreement is reasonable, when the potential parameter ratios determined by Bich and Vogel are used. The influence of bound dimers seems to be already taken into account in the three-monomer contribution according to Hoffman and Curtiss.Paper dedicated to Professor Joseph Kestin.     

聚醚合成工业齿轮油的研制

以聚醚为基础油辅以抗磨剂、抗氧剂、防锈剂等多种添加剂研制而成的KGW聚醚合成工业齿轮油具有优异的黏温性能和低温性能，优异的极压抗磨性，极优的减摩性能，可满足高负荷、强冲击等苛刻条件下各类齿轮传动装置的润滑要求。该系列产品达到国外同类油品质量水平。