低温腐蚀及其防护技术

为了加热炉和锅炉的安全经济运行 ,分析了烟气余热回收中低温腐蚀的机理 ,提出了行之有效地解决和防止低温腐蚀的几种技术方法     

纳米级BaAl_2O_4微粉的制备和性质

分别用溶胶 -凝胶法、低温固相反应法 ,制得了纳米级BaAl2 O4微粉 ,用电镜观察了其形貌和粒径的大小 ,用X-射线衍射仪进行了物相分析 ,测定了其纯度与晶型 ,讨论了制备方法与粒度大小的相互影响     

瞬态非傅里叶导热效应判据的探讨

讨论了通用傅里叶导热定律的数学模型,推导了半无限大物体在第一类边界条件下的基于非傅里叶导热定律的双曲线型偏微分方程的解析解。通过分析非傅里叶导热定律在瞬态条件下温度分布的变化过程,提出了非傅里叶导热效应的瞬态判据以及非傅里叶导热的作用范围,对研究工程中瞬态导热问题(如激光处理,电子束处理等)有重要意义。     

换热器小浮头螺栓断裂失效分析

针对换热器小浮头螺栓发生断裂的情况进行失效分析，找出原因，提出处理措施及材质选择时应注意的问题。     

Energy use in controlled temperature marine aquaculture

Temperature control offers benefits in land‐based marine aquaculture: stock growth rates may be enhanced by heating in winter; mortality rates in summer may be reduced by cooling. However, if the plant is not well designed, temperature control may create very large energy demands. This paper describes the application of temperature control in abalone aquaculture in New Zealand, with a focus on energy considerations in plant design. An abalone farm using a semi‐closed water conditioning system is used as a case study for which an energy model, based on a heat pump system, is developed. The model is used to determine the impact of plant design and tank conditions on the economics of the operation. Copyright © 2002 John Wiley & Sons, Ltd.     

Augmentation of boiling heat transfer from horizontal cylinder to liquid by movable particles

This paper presents a series of experimental results on a passive augmentation technique of boiling heat transfer by supplying solid particles in liquid. A cylindrical heater 0.88 mm in diameter is placed in saturated water, in which a lot of mobile particles exist, and the nucleate and film boiling heat transfer characteristics are measured. Particle materials used were alumina, glass, and porous alumina, and the diameter ranged from 0.3 mm to 2.5 mm. Particles are fluidized by the occurrence of boiling without any additive power, and the heat transfer is augmented. The maximum augmentation ratio obtained in this experiment reaches about ten times the heat transfer coefficient obtained in liquid alone. The augmentation ratio is mainly affected by the particle material, diameter, and the height of the particle bed set at no boiling condition. The augmentation mechanism is discussed on the basis of the experimental results. © 2001 Scripta Technica, Heat Trans Asian Res, 31(1): 28–41, 2002     

分离式热管换热器在脱硫装置的应用

介绍了分离式热管换热器的工作原理及其在工业脱硫装置中的应用，并不其余热回收情况与传统的二次中热方法相比较，阐明了其节能及环保作用。     

分户计量供暖节能住宅户型修正研究

针对多层住宅中不同户型在耗热量上的差异，引入户型体形系数修正各户的计量用热量，以计算和实测方法分析了一栋节能住宅不同围护结构户型的能耗特点，发现山墙、屋面、地面造成的不同户型之间的耗热量差别小于传统建筑；使用面积大的住户山墙造成的户型间耗热量差别小于使用面积小的住户。     

中厚板表面质量分析

在对济钢中厚板各种表面缺陷产生原因和几率进行综合分析的基础上 ,将缺陷分为 3类 :A类(折叠、麻点、划伤等 )、B类 (夹杂、结疤、分层 )、C类 (裂纹 ) ,重点对裂纹缺陷进行探讨 ,并提出了相应的改进措施。     

柳钢2800mm中板轧机液压自动厚度控制系统

介绍了柳钢2800mm中板轧机液压自动厚度控制（HAGC0系统工艺参数与系统的结构、特点和功能。系统还包括平面形状控制、动态规程自动和控制轧制技术，构成一个较完善的控制系统。