VG7S变频器及其在电梯拖动系统中的应用

指出了由VG7S变频器拖动的电梯系统运转停止时序分析中的几个主要问题,探讨了使用中的抗干扰技术,并对常用控制端子的设定方法和部分调试要点作了较为详尽的说明。     

Physical Aging of Amorphous Fructose

ABSTRACT: Physical aging of amorphous anhydrous fructose at temperature 5 °C and at 22 °C was studied using differential scanning calorimetry (DSC). The dynamic glass transition temperature, T_g0 for unaged samples was 16 °C and 13.3 °C for heating rate of 10 °C/min and 1 °C/min, respectively. The fictive temperature, T_f0 for unaged samples calculated by Richardson and Savill method was 12 °C, which is close to the dynamic value obtained from the lower DSC heating rate. The fictive temperature T_f of the aged fructose glasses at temperatures both below and above the transition region was fitted well by a non-exponential decay function (Williams-Watts form). Aging above the transition region (22 °C) for 18 d increased both the dynamic glass transition temperature T_g and the fictive temperature T_f. However, aging below the transition region (5 °C) for 1 d increased the dynamic glass transition temperature T_g but decreased the fictive temperature T_f.     

第三代移动通信中TDD和FDD共存的干扰分析

详细分析了3G中TDD以及TDD与FDD之间的各种干扰，建立了一些可用于3G系统性能研究的干扰模型，并提出了一些有效的建议来避免或减少系统中的干扰。     

用于千兆以太网基带铜缆接收器均衡的甚高频自适应 连续时间Gm-C 二阶带通滤波器的研究和设计

本文设计了用于千兆以太网基带铜缆接收器均衡的甚高频自适应连续时间Gm-C二阶带通滤波器。基于最陡梯度下降算法，带通滤波器的零点在57－340MHz的频率范围内可以自适应地调节，中心频率为1.278GHz。通过外接电阻伺服环路，滤波器中跨导转换器的跨导值不受工艺偏差和温度变化的影响，采用CSMC－HJ0.6μm CMOS工艺器件模型，用Cadence Spectres仿真器仿真了设计的自适应滤波器电路，仿真结果验证了设计原理和设计的电路。系统的最长学习时间为880个参考时钟周期。     

Development of an Enzymic Time Temperature Integrator for Sterilization Processes Based on Bacillus licheniformis α-amylase at Reduced Water Content

ABSTRACT: The thermal stability of Bacillus licheniformis α-amylase at low moisture content was studied, based on isothermal experiments performed in a temperature range 113 to 125 °C. The thermal inactivation was monitored by measuring the decrease in thermal denaturation enthalpy and/or the decrease in enzymic activity on pnitrophenyl-α-D-maltoheptaoside, or on starch as a substrate. Based on enthalpy readings, an enzymic system with a z-value of 10.4 °C was observed when using a relative humidity of 81% at 4 °C. A theoretical study showed that this system could be used as a Time Temperature Integrator (TTI) to monitor the safety of sterilization processes of numerous food products.     

分段控温黄原胶发酵过程

温度是影响黄原胶发酵的重要因素之一。为了优化黄原胶发酵过程的温度控制,在5 L通气式搅拌发酵罐中,非溶氧限制的条件下,对恒温黄原胶发酵过程进行了研究。结果显示,发酵温度为28℃时,在发酵稳定期有较高的菌体浓度,所得黄原胶的丙酮酸含量与表观粘度较高,但有较长的发酵周期。而发酵温度为33℃时,有较短的发酵周期,在发酵稳定期有较高的比产胶速率,但所得黄原胶的丙酮酸含量与表观粘度较低。实验测定了控制黄原胶发酵生长期温度为28℃,稳定期温度为33℃的发酵过程数据。结果表明,与恒温发酵过程相比,通过温度的分段控制可以缩短发酵周期,提高产胶浓度及改善胶的品质,分段控温是黄原胶发酵的一种方便有效的调节手段。     

用于机器人轨迹定位纠正系统的回声状态神经网络研究

循环神经网络(RecurrentNeuralNetworks)是人工神经网络(ArtificialNeuralNetworks)中重要的分支,与前馈神经网络(ForwardNeuralNetworks)相比具有更好的时间序列学习能力。但长期以来其学习法一直不能脱离前馈神经网络而自成一体,回声状态神经网络(EchoStateNetworks(ESN))是打破这一局面的全新学习方法。其独特的结构,良好的短期记忆能力,方便的学习方法,不俗的非线性特性是以前循环神经网络所不可比的。本文在介绍了回声状态神经网络之后将其用于四轮机器人的位置测量系统中,有良好的表现。     

高温预析出对Al-Zn-Mg系铝合金时效硬化和应力腐蚀的影响

研究了高温固溶后降温处理工艺对中强可使预析出LC52和7039铝合金的组织、时效硬化和应力腐蚀的影响。金相观察发现,高温预析出可优先在晶界处产生,并提高随后时效状态下晶界析出相的不连续分布程度,温度降低到一定程度晶内和晶界产生大量析出。合金拉伸性能和应力腐蚀结果表明,预析出在保持强度和塑性的同时,可提高抗应力腐蚀性能。而预析出温度降低,合金强度呈下降趋势。     

Spare parts inventory management with demand lead times and rationing

We study an inventory system that consists of two demand classes. The orders in the first class need to be satisfied immediately, whereas the orders in the second class are to be filled in a given demand lead time. The two classes are also of different criticality. For this system, we propose a policy that rations the non-critical orders. Under a one-for-one replenishment policy with backordering and for Poisson demand arrivals for both classes, we first derive expressions for the service levels of both classes. The service level for the critical class is an approximation, whereas the service level for the non-critical class is exact. We then conduct a computational study to show that our approximation works reasonably, the benefits of rationing can be substantial, and the incorporation of demand lead time provides more value when the demand class with demand lead time is the critical class. The research is motivated by the spare parts service system of a major capital equipment manufacturer that faces two types of demand. For this company, the critical down orders need to be satisfied immediately, while the less critical maintenance orders can be satisfied after a fixed demand lead time. We conduct a case study with 64 representative parts and show that significant savings (as much as 14% on inventory on hand) are possible through incorporation of demand lead times and rationing.     

复合绝缘子老化评估方法浅析

复合绝缘子老化是用户十分关心的问题。笔者介绍了两种判别复合绝缘子老化程度的方法,并通过实例,分析了这两种方法的优点以及存在的问题。