Malic acid production from renewables: a review

Malic acid derived from fossil resources is currently applied in the food and beverage industries with a medium global production capacity. However, in the transition from a fossil-based to a bio-based economy, biotechnologically produced l -malic acid may become an important platform chemical with many new applications, especially in the field of biopolymers. In this review, currently used petrochemical production routes to dl -malic acid are outlined and insights into possible bio-based alternatives for microbial l -malic acid production are provided. Besides ecological reasons, the possibility to produce enantiopure l -malic acid by microbial fermentation is the biggest advantage over chemical synthesis. State-of-the-art and open challenges concerning production host engineering, substrate choice and downstream processing are addressed. With regard to production hosts, a literature overview is given covering the leading natural production strains of Aspergillus, Ustilago and Aureobasidium, as well as Escherichia coli as the most important engineered recombinant host. The utilization of renewable substrates as an alternative to glucose is emphasized in particular as a key aspect for a competitive bio-based production. Out of the alternative substrates discussed in this review, the industrial side-streams crude glycerol and molasses seem to be most promising for large-scale l -malic acid production. © 2019 The Authors. Journal of Chemical Technology & Biotechnology published by John Wiley & Sons Ltd on behalf of Society of Chemical Industry.     

Sol-Gel Preparation and Luminescence Properties of BaMgAl10O17∶Eu2+ Phosphors

The synthesis of BaMgAl10O17∶ Eu2 (BAM) phosphors using the sol-gel method and their luminescence properties were reported. The blue-light emitting BAM was synthesized using citric acid and ethylene glycol as chelating materials. Emission of blue-light was obtained from these phosphors. The luminescent intensity increases as the temperature of heat treatment is increased. This study investigated the effects of the molar ratio of ethylene glycol to citric acid (Φ value), with respect to the phase formation and luminescence properties of BAM. The variation of the Φ value resulted in the change of the sol-gel reaction mechanism and the microstructures of the resultant powders. An increase in Φ value leads to an increase in the rate of BAM phase formation. The photoluminescent intensity of the prepared phosphors increases with heating temperatures because of enhanced crystallization.     

现场总线在冶炼烟气制酸系统中的应用实践

分析了冶炼烟气制酸工艺的特点，介绍了由PROFIBUS-DP现场总线构建的冶炼厂烟气制酸监控系统，详细介绍了其硬件配置及相应的软件设计。     

大港孔店油田本源微生物代谢产物监测分析

应用放射性同位素示踪剂技术研究了大港孔店北二断块水动力学关系,结果表明该区块注水井和采油井之间具有紧密的水动力学连通关系。在本源微生物驱油试验阶段,对试验区微生物及其代谢物在地层中的分布状况进行了3年连续监测,表明本源菌激活期间菌数增加102~105倍,原油部分氧化,使得低分子脂肪酸(乙酸盐,甲酸盐,丁酸盐等)含量约增加10~100倍,碳酸氢盐从0·4~0·6g/L增加到0·7~1·8g/L,产生的生物表面活性剂使地层水平均表面张力降低至48~33·3mN/m,地层水相对石蜡平均界面张力降至25~13·7mN/m,产生的生物多糖代谢物使地层水平均粘度增至0·76mPa·s,最高达0·83mPa·s。这些变化改变了油层物理化学和生态环境,改善了原油流动性,尤其是水动力学连通关系最好的井地层水组成的改变和增油降水效果最为明显。试验区监测结果表明,微生物及代谢物随注入水主流动方向运移,生物表面活性剂和低分子脂肪酸及生物聚合物的作用是提高原油采收率的主要机理。     

深层及非生物成烃的催化机制

讨论了非生物成因烃的可能生成机制。通过对比分析,探讨了在地质条件下碳、氢经历费-托合成和由过渡金属催化产生烃的可能机制。     

不锈钢塔器在硫酸装置中的应用

摘 要:主要介绍Sasol Agri公司硫酸四系统的技术改造,分两步进行,第一步更换转化器、热换热器及主省煤器,生产能力由1600t/d提高到1750 t/d,且鼓风机出口压力很低。第二步更换干燥塔、二吸塔及冷换热器,连续生产能力在1950 t/d以上。使用不锈钢材质及克瓦纳·凯密迪公司专有的换热器,使装置的改造相当成功,维护及操作费用较低,并具有较大的灵活性和可操作性。     

川东北飞仙关组碳酸盐岩气藏产能影响因素及压裂酸化新技术探讨

川东北地区飞仙关组碳酸盐岩气藏的储集层条件起好，不论直井还是水平井均可获高产工业气流，投产前的解堵酸化均可实现大幅度增产。在分析介绍该地区气藏地质特征的基础上，全面剖析了影响产能的主要因素，并对多功能深部酸化技术方案和稠化酸加砂压裂技术方案进行了具体探讨。     

湘中海相浅层湘冷1井酸压工艺研究及应用

湘冷1井具有气层埋藏浅（400m-500m）、纵向上裂隙发育的特点，属低孔、低渗的含泥质灰岩致密储层。大量室内实验和研究采用“前置液酸压＋闭合酸化”工艺技术，并优选了相应降阻酸和闭合酸配方。通过酸压实现了该井工业油气流的突破，取得了明显的增产效果，为新区海相浅层气的开发探索出了一套成熟的改造增产措施。     

Electrochemical synthesis and characterization of chloride doped polyaniline

Chloride doped polyaniline conducting polymer films have been prepared in a protic acid medium (HCl) by potentiodynamic method in an electrochemical cell and studied by cyclic voltammetry and FTIR techniques. The FTIR spectra confirmed Cl^- ion doping in the polymers. The polymerization rate was found to increase with increasing concentration of aniline monomer. But the films obtained at high monomer concentration were rough having a nonuniform flaky polyaniline distribution. Results showed that the polymerization rate did not increase beyond a critical HCl concentration. Cyclic voltammetry suggested that, the oxidation-reduction current increased with an increase in scan rate and that the undoped polyaniline films were not hygroscopic whereas chloride doped polyaniline films were found to be highly hygroscopic.