服装湿冷机理分析

本文在明确冷暖感、湿冷感、接触湿冷感等概念的基础上,分析了在冬季着装状态下,人体热量、水汽 散失的途径和人体产生冷感的原因。     

Reconfigurable hardware implementation of a phase-correlation stereoalgorithm

This paper describes the implementation of a stereo-vision system using Field Programmable Gate Arrays (FPGAs). Reconfigurable hardware, including FPGAs, is an attractive platform for implementing vision algorithms due to its ability to exploit parallelism often found in these algorithms, and due to the speed with which applications can be developed as compared to hardware. The system outputs 8-bit, subpixel disparity estimates for 256× 360 pixel images at 30,fps. A local-weighted phase correlation algorithm for stereo disparity [Fleet, D. J.: {Int. Conf. Syst. Man Cybernetics 1:48–54 (1994)] is implemented. Despite the complexity of performing correlations on multiscale, multiorientation phase data, the system runs as much as 300 times faster in hardware than its software implementation. This paper describes the hardware platform used, the algorithm, and the issues encountered during its hardware implementation. Of particular interest is the implementation of multiscale, steerable filters, which are widely used in computer vision algorithms. Several trade-offs (reducing the number of filter orientations from three to two, using fixed-point computation, changing the location of one localized low-pass filter, and using L1 instead of L2 norms) were required to both fit the design into the available hardware and to achieve video-rate processing. Finally, results from the system are given both for synthetic data sets as well as several standard stereo-pair test images.     

新场气田致密低渗透气藏重复压裂工艺技术

新场气田蓬莱镇组气藏由于储层致密、渗流条件差，单井自然产能低，所以多数气井必须进行压裂改造才能投产，但由于受储层致密和其它多种因素的影响，压裂增产有效期较短，针对这种情况，进行了气井重复压裂工艺技术的理论计算和现场应用研究，初步形成了一套包括储层评估、重复压裂潜力井优选、重复压裂造缝机理研究、优化重复压裂施工及配套工艺和压后评估的气井重复压裂技术。现场试验表明，对具有潜力的压裂失效气井采取重复压裂措施，能取得较好的增产效果。气井重复压裂技术的形成和推广，将有效提高川西地区各气藏的开发水平，同时也为类似致密碎屑岩气藏的开发提供有益的指导和借鉴。     

Logistic模型的改进及在油藏可采储量预测中的应用

为了更准确地预测油气藏未来的经济可采储量，依据油气藏随开发必然要经历产量递减和生产收支平衡的实际。利用Logistic模型中技术可采储量、产量与时间的相互关系，经推导和改进后，再结合当前经济技术条件下的废弃产油量，预测油气藏的有效生产时间及其经济可呆储量。实践证实，改进后的Logistic模型预测结果更符合油气藏的生产实际，能为油气藏的储量管理提供可靠的依据。     

氧对聚合物污水溶液黏度影响的实验研究

在45℃下对溶解氧对聚合物污水溶液表观黏度(170 s-1)的影响作了全面的实验研究。采油污水取自大庆采油二厂,矿化度4013、Fe3+、∑Fe、SO42-分别为0.2、1.09、.6 mg/L。厌氧实验操作和测试均在Bactron 1.5型厌氧室中进行。污水中SRB菌数随放置时间延长而增加,厌氧条件下增速远大于曝氧条件下的增速,放置7天时菌数相差6~600倍。用脱氧和含氧加盐蒸馏水配制的抗盐型和功能型聚合物溶液的黏度,均随放置时间延长(1~10天)而减小,脱氧溶液的黏度总是明显大于含氧溶液。0.5 g/L超高分聚合物溶液在厌氧和曝氧条件下放置时,黏度随放置时间延长而减小,分别由1天时的22.2和28.8 mPa.s减至60天时的2.7和3.4 mPa.s,曝氧条件下的黏度总是大于厌氧条件下的黏度;加入甲醛杀菌剂使溶液黏度的减小趋缓,60天时为8.9和9.6 mPa.s;在4~8mg/L范围改变含氧量,当含氧6 mg/L时放置2~40天时的黏度均最大,40天时为18.2 mPa.s。6 mg/L为污水的合理曝氧量。分析了聚合物降解、SRB菌作用、杀菌剂作用等机理。表6参10。     

麻柳场嘉二3储层酸化工艺室内实验研究

储层酸化改造是低渗碳酸盐岩油气藏增产的主要措施之一。由于储层性质不同，改造方案的实施效果差异较大。对麻柳场嘉二^3储层酸化工艺室内实验研究和现场实践发现，胶束酸多级注入酸化-闭合酸化工艺对川南麻柳场嘉陵江组的储层改造行之有效。     

宝浪油田宝北区块低渗透油藏层系优化研究

针对宝浪油田宝北区块低孔低渗油藏地质特征以及油层层数多、分布井段长、部分零散层动用难度大等问题 ,研究了宝北区有效厚度、油层层数、单井产能及单井控制地质储量等层系划分与组合的技术经济界限 ,并在此基础上进行了宝北区层系划分与组合优化论证 ,最终优选出宝北区开发层系     

Cs-K混合蒸气中Cs(8D)+K(4S)碰撞能量转移

在Cs-K混合蒸气中，两步激发Cs原子到8D态，观察了Cs(8D) K(4S)→Cs(5D) K(4P)碰撞能量合并逆过程(REP，reverse energy pooling)。应用双调制技术探测K(4P)原子发射的荧光，基态K原子密度用光学吸收方法测量。得到了REP速率系数，讨论了其它过程对速率系数的影响．     

低温低渗透砂岩油藏窜流大孔道深部封堵技术研究

所用堵剂为高强度的淀粉接枝聚丙烯酰胺交联凝胶SAMG-1,由<6%淀粉、4.5%-5.5%丙烯酰胺、0.003%-0.006%交联剂组成,35℃成胶时间受淀粉和交联剂用量控制,为18-20小时以上,成胶前黏度-100 mPa.s。该堵剂具有长期稳定性,在储层岩心中注入深度15 cm的堵剂,在35℃候凝48小时后及老化90天后,封堵强度分别为0.61和0.59 MPa/cm,封堵率分别为98.6%和98.1%。该堵剂优先进入高渗层,注入0.5 PV并成胶后,2组双填砂管组成的模型低、高渗管渗透率保留率分别为68.4%、0.7%和69.4%、0.0%。吉林扶余油田西一区+15-8.2区块有水井6口,油井13口,含水率达91.5%,注入水最快在5天内到达油井。报道了该区块整体深部调剖封堵窜流通道的情况,详细叙述了+15-9.2井施工中通过注入压力和井底回压控制注入流量,使堵剂陆续进入原生和次生孔道的工艺作业,该井设计注入堵剂92 m3。6口水井整体调剖后,油井产液量差别减小,产油量增加,有效期已超过了9个月,共增油843 t,含水平均下降3.87%。图7表1参8。     

Biases of Success Rate Differences Shown in Binomial Effect Size Displays.

The intent of a binomial effect size display (BESD) is to show "the [real-world] importance of [an] effect indexed by a correlation [r]" (R. Rosenthal, 1994, p. 242) by reexpressing this correlation as a success rate difference (SRD) (e.g., treatment group success rate - control group success rate). However, SRDs displayed in BESDs generally overestimate real-world SRDs implied by correlations of (a) dichotomous X and Y variables (φ coefficients), (b) dichotomous X and continuous Y variables (point-biserial coefficients [rphs]). and (c) continuous X and Y variables (rxys). Furthermore, overestimation biases are larger for rxys than for rphs. Differences in the sizes of biases linked to different correlations suggest that BESD SRDs reported for different correlations are not comparable. The stochastic difference index (N. Cliff, 1993: A. Vargha & H. D. Delaney, 2000) is recommended as an alternative to the BESD. (PsycINFO Database Record (c) 2010 APA, all rights reserved)