从混联法生产中提取镓的研究

针对联合法厂家资源的分布特点,提出采用化学法和树脂吸附法相结合的方式实现同时回收烧结法和拜尔法循环母液中镓的新工艺,并通过小试和扩试结果分析,阐述了该工艺的可行性。     

高压静电除垢技术在发电厂汽轮机凝汽器中的应用

汽轮机凝汽器的除垢问题通常采用化学方法或物理方法,这些除垢措施有一定的局限性。介绍了一种利用高压静电除垢技术。     

Heavy arsenic doping of silicon grown by atmospheric pressure selective epitaxial chemical vapor deposition

Selective epitaxial Si with a high arsenic concentration of 2.2×10¹⁹ atoms/cm³ was deposited at a high growth rate of 3.3 nm/min under atmospheric pressure. It was confirmed that this method had excellent selectivity and produced films having good crystalline quality, abrupt dopant profiles at the interfaces, and smooth surfaces. The growth mechanism is discussed in terms of the relationship between the effects of arsenic surface segregation and etching by hydrogen chloride.     

Depollution of atmospheric emissions of wood pyrolysis furnaces

The wood carbonization in Tunisia consists essentially of traditional activity using charcoaling stacks and pits characterized by high atmospheric pollution and poor energy conversion. Indeed, 70% of the initial mass of anhydrous wood are found in the vapor as aerosols, polluting and toxic gases and complex condensable organic compounds that can cause a substantial pollution of air, ground and water. Several processes of treatment and energy valorization of such effluents were proposed, but the incineration remains at present the most promising technique of depollution. The results show that the incineration, at about 1000°C, of wood carbonization smokes allows the destruction of 99% of the mass of pollutants except CO₂ and the reduction of polluting gas emission. The possible valorization of the smoke’s energy in the exit of the incinerator enhances the thermal efficiency of the process.     

三(明)钢烧结厂电除尘灰的气力输送

三钢烧结厂130m^2烧结机电除尘输灰首次采用了气力输送系统。该系统由气源、输送、管路、灰库及控制五部分组成，本文介绍了系统的工作原理及运行调试情况。系统投产后，运行平稳，达到了设计要求。     

Si相的析出状态对Al—Si合金性能的影响

控制Si相的析出状态,会对Al-Si(1wt％)合金的性能产生不同的影响。本文阐述通过不同的热处理工艺改变了Al-Si(1wt％)合金的机械、物理性能,获得了高形变强化率、高塑性变形能力、高拉伸强度的工艺,还讨论了具有上述高拉伸强度的微细丝在半导体器件应用中所具有的优越性。     

Pollutant dispersion over two-dimensional hilly terrain

Numerical prediction of the wind flow and pollutant dispersion over two-dimensional hilly terrain is presented. The wind tunnel experiments are conducted to validate the numerical results of the flow field. Measured mean velocity profiles, turbulence characteristics, and surface pressure distributions show good agreement with the numerical predictions. The hypothesis of Reynolds number independency for an atmospheric boundary layer flow over aerodynamically rough terrain is numerically confirmed. The linear theory provides generally good prediction of speed-up characteristics for gently sloped low hills. The effect of two-dimensional double hills on the dispersion of pollutants from continuously or temporally released line source of different emission heights and locations is also investigated. The ground-level concentrations are considerably reduced as emission heights are increased. The variances of ground-level concentration with respect to time from a temporally released source are strongly influenced by the flow separation.     

Potential control under thin aqueous layers using a Kelvin Probe

Kelvin Probes can be modified to control as well as monitor potential. The design and operation of two different Kelvin Probe Potentiostats (KPPs) are described in this paper. One approach uses a permanent magnet and double coil to oscillate the needle at a fixed frequency, an AC backing potential, and software analysis and control schemes. This technique can also control the distance between the tip and sample, thereby tracking the topography of the sample. Both KPPs were used to make measurements on Type 304L stainless steel under thin layers of electrolyte. Cathodic polarization curves exhibited a limiting current density associated with oxygen reduction. The limiting current density varied with solution layer thickness over a finite range of thickness. Anodic polarization curves on 304L in a thin layer of chloride solution resulted in pitting corrosion. The breakdown potential did not vary with solution layer thickness. However, the thin layer was observed to increase in volume remarkably during pit growth owing to the absorption of water from the high humidity environment into the layer with ionic strength increased by the pit dissolution. The open circuit potential (OCP) and solution layer thickness were monitored during drying out of a thin electrolyte layer. Pitting corrosion initiated, as indicated by a sharp drop in the OCP, as the solution thinned and increased in concentration.     

JDZ-1型固态存储雨量器降水量误差成因分析

对JDZ-1型固态存储雨量器与虹吸自记雨量计平行观测资料进行了系统分析,分析了两者存在误差的影响因素。对JDZ-1型固态存储雨量器在北方地区使用过程中存在的问题提出了解决方法,以保证和提高JDZ-1型固态存储雨量器资料质量。     

Ti_3Al PHASE PRECIPITATION DURING VIBRATION FATIGUING FOR A TITANIUM ALLOY

Ｔｉ_３ＡｌＰＨＡＳＥＰＲＥＣＩＰＩＴＡＴＩＯＮＤＵＲＩＮＧＶＩＢＲＡＴＩＯＮＦＡＴＩＧＵＩＮＧＦＯＲＡＴＩＴＡＮＩＵＭＡＬＬＯＹ￥ＴａｏＣｈｕｎｈｕ；ＺｈａｎｇＳｈａｏｑｉｎｇ；ＹａｎＭｉｎｇｇａｏ（ＩｎｓｔｉｔｕｔｅｏｆＡｅｒｏｎａｕｔｉｃａｌＭ?..