镍氢电池负极用低成本储氢合金的研究

研究了ABS型储氢合金在低Co含量条件下，随B组元替代元素Co，Al，Si等含量的变化对合金电化学性能的影响规律，同时研究了A组元中不同La／Ce比对合金电化学性能的影响情况。结果表明，随合金中Co含量的降低，合金的活化性能和放电容量得以改善，但合金的循环寿命下降也比较明显；在试验范围内，随Al元素的加入，合金的循环寿命得以改善，但材料的放电容量和活化性能均有所下降；随合金La／Ce比的降低，合金的放电容量略有下降，但其循环寿命和放电电压平台有较大提高。     

金沙江防洪(库容)规划的探讨

在分析长江灾害洪水特征的基础上，全面深入地研究了全沙江水库的防洪库客、防洪目标、防洪特点和调度原则，并对防洪库容的作用进行了估算和分析。从多方面比较了虎跳峡高坝方案与低坝方案，结果表明：高坝方案的效益明显高于低坝方案，而两者所需付出的代价相差不大。     

Fabrication of a poly-Si thin-film transistor with storage capacitor

The fabrication process of a low-temperature poly-Si thin-film transistor (TFT) with a storage capacitor was studied. The atmospheric-pressure chemical-vapour deposited SiO₂ protected the buried indium tin oxide (ITO) from reduction by a pure H₂ plasma treatment that was essential for the effective improvement of the poly-Si TFT characteristics. Thus, a storage capacitor with an ITO (picture electrode)-SiO₂-ITO (buried common electrode) structure was successfully fabricated. The poly-Si TFT with a channel width/length W/L ratio of 5 drove a 3 pF storage capacitor in 2 μs, and it showed superior driverability for LCD use. The TFT also had good hold characteristics under illumination for the realization of grey-scale representation.     

一种基于知识地图集的知识管理系统模型框架

在分析知识管理、知识管理系统(KMS)的含义和知识地图集技术的特点的基础上，提出了一种基于知识地图集的KMS模型框架，并且分析了该模型框架中知识地图集的组成及功能，讨论了KMS中知识地图集和知识存储之间的关系。依据该模型框架，组织易于构建知识管理系统，实现知识资源的共享与充分运用。最后，通过一个实例分析进一步说明了该模型框架的应用。     

胡状集油田胡5-15井区天然混合羧酸盐/黄胞胶驱油先导试验

报道了在室内实验研究中得到的混合天然羧酸盐/烷基磺基甜菜碱/黄胞胶复合驱油段塞结构:预冲洗段塞,10g/LKCl溶液;前置聚合物段塞,1500mg/L黄胞胶溶液;主驱油段塞,1.5×104mg/L混合天然羧酸盐+800mg/L烷基磺基甜菜碱DSB+800mg/L黄胞胶+5×103mg/L复碱(质量比1∶1的Na2CO3+NaHCO3)溶液;后置聚合物段塞,1000mg/L黄胞胶溶液。在岩心流动实验中0.3PV主段塞在水驱基础上提高采收率18.19%。胡状集油田胡5 15井区采出程度18.48%,油藏温度86℃,地层水矿化度1.7×105mg/L,Ca2+浓度4799mg/L,Mg2+浓度830mg/L,有油、水井各5口,综合含水已达96%(92%～99%)。从2000 01 24到2001 03 20,在5口注水井中依次注入预冲洗液2920m3,前置液2920m3,主驱油液49640m3(除一口井外均不加复碱),后置液2920m3,5口油井均见效,一些油井有效期超过20个月,油井产油量增加,含水下降,自然递减降低62.7%,采油速度升高0.46%。图3表2参3。     

一种三叉树的存储结构及其基本操作的实现

本文在文献［１］所给出的有关三叉树有其相关概念的基础上，提出了一种新的三叉树存储结构，即“儿子－兄弟链表”方法，并在这种结构下，对三叉树的基本操作的实现算法进行了较详细的讨论。     

Computer analysis,design and simulation of horizontal ground heat exchangers

This paper presents a new computerized procedure for dealing with the design of horizontal ground heat exchangers (HGHE). The computer program is based on the transient model of coupled nonlinear partial differential equations governing heat and mass flow in soils. The model is two-dimensional and delineates the operation of ground heat storage with the HGHE and such phenomena as freezing/thawing and drying/rewetting of soil moisture. Comprehensive climatological data, such as ambient temperature, solar radiation, wind velocity, rainfall, snowfall, snow characterstics, and water vapour pressure is used to simulate conditions at the ground surface over any required length of time. The package can be applied to any geographical location by changing climatic and soil data input. The designer has the possibility of selecting any of 12 types of soils from sand to clay, 12 commercial heat pumps, nine different configurations of the HGHE, 16 plastic pipes for ground coils, and 13 ground coil fluids. The program, however, does not calculate the length of the HGHE but it evaluates the thermodynamic performance of a ground heat pump system and provides comprehensive data on thermal and hydraulic conditions in ground heat storage. The length of the ground heat exchanger is obtained from a line source theory model or from site dimensions and pipe spacing. Computed results for ground heat exchanger operation correlate fairly well with experimental data. Simulation of temperature and moisture content in the ground for natural conditions (no heat extraction/deposition) showed a fair agreement with field data. The entire computer program is user-friendly, interactive, menu-driven, and written in FORTRAN 77.     

A portable cryo-storage system for low-temperature scanning electron microscopy,suitable for international transport of cryo-specimens

A cryo-specimen storage system for low-temperature scanning electron microscopy (LTSEM) specimens is described, which: liberates multi-specimen experiments from sampling restrictions imposed by the rate at which LTSEM specimens can be examined in the SEM; provides security against experiment loss resulting from breakdown of the SEM or cryo-system; enables collection of specimens in the field or in laboratories remote from the SEM laboratory; and facilitates international air transport of LTSEM specimens. The components of the system, which has a capacity of 98 stub-mounted specimens, are readily made in a laboratory workshop. The details of the design may be altered to suit particular specimen types or experimental approaches.     

一种高温蓄冷介质蓄放冷特性的应用研究

采用实验的方法获得了氯酸锂共晶盐的蓄放冷特性的实用关系式。这种介质的融点为８℃，单位体积蓄冷量比冰大３０％，适于用作空调系统中的蓄冷材料。