提高E^2PROM中NMOS管源漏穿通电压的实验研究

为了提高Ｅ＾２ＰＲＯＭ中Ｎ管源漏穿通电压，用实验的方法对制造工艺进行了研究。结果表明，高能量注入是提高ＶＰＴ的有效手段，但受到ｐｎ结击穿的限制，只适用于低区短沟Ｎ管；ＤＤＤ工艺大幅度高ＶＰＴ，但ｐｎ结击穿电压低于２０Ｖ，不能应用于高压ＭＯＳ管；采用适量的防穿通注入和适当增大沟道长度为最理想的工艺途径。     

石英砂的相变与换向器套筒铸件的变形

用呋喃树脂石英砂工艺生产牵引电机换向器套筒出现变形、裂纹等铸造缺陷,是由石英砂相变膨胀引起,后用高铬刚玉砂代替石英砂得到解决.     

月桂氮草酮研究进展

介绍了月桂氮草酮作为高效皮肤促渗剂的发展概况、合成工艺、研究进展及其应用前景。     

Adsorption and desorption characteristics of 2-methyl-4-chlorophenoxyacetic acid onto activated carbon

Adsorption and desorption characteristics of the 2-methyl-4-chlorophenoxyacetic acid (MCPA) from aqueous solution onto the activated carbon (GAC, F-400) were studied. Adsorption equilibrium capacities of the MCPA increased with decreasing pH and temperature of the solution. Adsorption equilibrium of the MCPA could be represented by the Sips equation. The internal diffusion coefficients were determined by comparing the experimental concentration decay curves with those predicted from surface diffusion model and pore diffusion model. The adsorption model based on the linear driving force approximation (LDFA) was used for simulating the adsorption behavior of the MCPA in a fixed bed. Over ninety five percent desorption of the MCPA could be obtained using distilled water.     

Nanocrystalline CeO2 in SBA-15: Performance of Pt/CeO2/SBA-15 Catalyst for Water-gas-shift Reaction

CeO₂ particles confined within the pores of an SBA-15 mesoporous silica host were prepared by incipient wetness impregnation (IMP) and deposition precipitation (DP) methods. The materials were characterized by XRD, N₂-adsorption and temperature programmed reduction (TPR) to evaluate the structure, texture, and redox properties. The preparation procedure had significant impact on the assembling mode of CeO₂ inside the SBA-15 mesopores. A high dispersion of CeO₂ particles was achieved via DP, whereas the dispersion of CeO₂ prepared by IMP was found to be inhomogeneous and CeO₂ partially blocked the pores. The CO conversion in the water-gas-shift reaction was enhanced over 1 wt% Pt supported on CeO₂-modified SBA-15 obtained by DP.     

A voltammetric study concerning the structural stability of Li-overstoichiometric Mg-doped LiCoO2 powders

The effect of Mg-doping and Li overstoichiometry on the structural stability of LiCoO₂ powders has been investigated with emphasis to voltammetric properties. Microparticle cyclic voltammetry (CV) conducted in caustic NaOH to best simulate a non-aqueous electrolyte shows a marked improvement of the structure stability of doped LiCoO₂. In contrast to the unsubstituted LiCoO₂ sample which shows voltammetric peaks associated to the well-known two-phase domain and monoclinic distortion reactions, in Li_1.08Mg_0.06CoO₂, LiMg_0.06CoO₂ and Li_1.08CoO₂ samples these peaks are strongly suppressed providing direct evidence for the existence of a stable solid solution with negligible phase transitions in the reversible intercalation region (3.8-4.2 V vs. Li) as well as in the overcharged region. The effect is higher with Mg-doping, irrespective of the Li overstoichiometry. However, the concomitant presence of Mg and Li excess in the structure is important for obtaining small particle sizes. Since Mg-doping induces a quasi metallic behavior in the samples, whereas the Li excess may provide an higher initial capacity, it is suggested that the Li_1.08Mg_0.06CoO₂ composition may be of interest as positive cathode for advanced Li-ion batteries.     

Possible Energy Network with polygeneration system and CCS for China

On basis of adopting polygeneration systems for power and alternative fuels,capturing CO2 with near zero energy penalties,and storing CO2 on sites,a new kind of Energy Network can integrate energy utilization,CO2 capture,transportation and storage synthetically.Techno-economic analysis of this solution focusing on Inner Mongolia and the Yangtze River Delta districts had been carried with comparison to the chain method for energy utilization and CO2 sequestration.This solution can save 21.5% of energy,and re...     

CuO-NiO/Al_20_2催化剂上N-甲基哌嗪合成研究

以共沉淀法制备铜、铝系复合氧化物作为催化剂,二乙醇胺和甲胺为原料,合成了N-甲基哌嗪.利用高压反应釜对其进行活性评价,发现CuO-NiO/Al2O3活性最高.并对铜、铝、镍摩尔比、沉淀剂种类、沉淀方式,焙烧温度等条件进行了优化.结果表明:催化剂中理想的Cu、Al、Ni摩尔比为1:1:3.2,沉淀剂为氢氧化钠,沉淀方式为并流,焙烧温度为500℃.该条件下N-甲基哌嗪的选择性为27.7%,二乙醇胺的转化率达89.8%.另外通过对使用前后催化剂进行表征分析发现催化剂失活原因为表面高聚物的附着和对孔道的堵塞.     

Study of the physico–chemical characteristics and rheological behaviour of boehmite dispersions for dip-coating applications

Dispersions of a totally dispersible AlOOH powder have been studied. The effect of the initial composition has been studied to outline the reactions that determine the final rheological behaviour of the dispersions. The final viscosity and viscoelastic properties of the dispersions are determined by the sol–gel phenomena occurring during the ageing treatment. Gel formation is favoured by low water and high acid contents, while it is disfavoured by prolonged stirring. Gelling time from 48 h to 4 months has been observed depending on the initial composition.