坨五站中间乳化层快速增长原因及治理方案

胜利采油厂坨五站高含水(95％)原油化学预脱水中，二级沉降罐内油水相之间的中间乳化层增长迅速，引起了一系列问题。现场调查和大量室内测试结果表明，产生这一现象的原因有：油溶性破乳剂WD-1加入点不合理。有2／3的含水原油在通过油水分离器之后才与破乳剂混合；二级沉降罐进油口伸入油相内，油流的冲击达不到中间层；WD-1对坨五站混合原油中的稠油破乳脱水性能欠佳，不能适应坨五站混合原油组成和含水的变化。针对上述各种原因筛选出了性能更好的一种破乳剂1916。根据确定的几种原因采取了相应的措施：将破乳剂加入点改在3个并联油水分离器之前；将二级沉降罐的进油口移到水相内；改用筛选出的破乳剂1916，结果使中间乳化层的增长受到了抑制。图2表4参2。     

Transition to turbulence in rotating-disk boundary layers—convective and absolute instabilities

This work is an experimental study of mechanisms for transition to turbulence in the boundary layer on a rotating disk. In one case, the focus was on a triad resonance between pairs of traveling cross-flow modes and a stationary cross-flow mode. The other was on the temporal growth of traveling modes through a linear absolute instability mechanism first discovered by Lingwood (1995, J Fluid Mech 314:373–405). Both research directions made use of methods for introducing controlled initial disturbances. One used a distributed array of ink dots placed on the disk surface to enhance a narrow band of azimuthal and radial wave numbers of both stationary and traveling modes. The size of the dots was small so that the disturbances they produce were linear. Another approach introduced temporal disturbances by a short-duration air pulse from a hypodermic tube located above the disk and outside the boundary layer. Hot-wire sensors primarily sensitive to the azimuthal velocity component, were positioned at different spatial (r,θ) locations on the disk to document the growth of disturbances. Spatial correlation measurements were used with two simultaneous sensors to obtain wavenumber vectors. Cross-bicoherence was used to identify three-frequency phase locking. Ensemble averages conditioned on the air pulses revealed wave packets that evolved in time and space. The space–time evolution of the leading and trailing edges of the wave packets were followed past the critical radius for the absolute instability, r _{c A} . With documented linear amplitudes, the spreading of the disturbance wave packets did not continue to grow in time as r _{c A} was approached. Rather, the spreading of the trailing edge of the wave packet decelerated and asymptotically approached a constant. This result supports the linear DNS simulations of Davies and Carpenter (2003, J Fluid Mech 486:287–329) who concluded that the absolute instability mechanism does not result in a global mode, and that linear-disturbance wave packets are dominated by the convective instability. In contrast, wave-number matching between traveling cross-flow modes confirmed a triad resonance that lead to the growth of a low azimuthal number (n = 4) stationary mode. At transition, this mode had the largest amplitude. Signs of this mechanism can be found in past flow visualization of transition to turbulence in rotating disk flows.     

不同加工工艺的锑化镓晶片损伤研究

用透射电子显微镜、扫描电镜对锑化镓材料切、磨、抛等加工工艺引入的表面损伤进行观察和检测。结果表明：切割加工是锑化镓单晶晶片表面损伤层引入的主要工序；锑化镓单晶切割片表面极不平整，有金刚砂所引起的较粗桔皮皱纹；其表面损伤层深度≤30μm；双面研磨的锑化镓晶片表面仍有较粗桔皮皱纹，但比切割片的要细，而且桔皮皱纹的深浅随磨砂（Al2O3)粒径的减小而变细变浅；晶片的表面损伤层深度（≤5μm）也随着磨砂粒径的减小而减小。一般情况下，其损伤层的深度约为磨砂粒径的1/2。机械化学抛光加工的锑化镓晶片表面的SEM像观察不到桔皮皱纹；其损伤层深度约55nm。     

针对混合应用业务的ARQ改进方案

在高速无线通信中,自动请求重传(ARQ)是链路层不可缺少的技术,它通过重传向上层屏蔽无线链路上包的丢失。随着无线网络的发展,无线传输速率不断提高,应用的业务类型也越来越广泛。目前,众多ARQ技术的研究都集中在如何提高该技术的确认效率,以适应更高的传输速率,但鲜有研究着手于如何使ARQ能够更好地应用于混合业务环境。针对混合业务环境下的ARQ改进提出了2种方案,并给出其中1种在实际应用中的改善效果。     

盘石头水库河槽段趾板基岩的地质概况与防渗设计分析

盘石头水库河槽段趾板基岩建基面下8m为相对不透水层,如按常规进入不透水层5m设计帷幕,深度只有13m左右,对100m高坝而言,深度偏浅,为安全考虑,帷幕设计为悬挂式帷幕,主帷幕深度按1/3坝高考虑,穿透隔水层,隔水层以上以一排主帷幕和两排副帷幕防渗,隔水层以下以一排主帷幕防渗。     

埋地管道三层PE外覆盖层及其检测方法研究

文章介绍了埋地管道三层PE外覆盖层系统的构造参数和性能特点,论述了两种用于埋地钢质管道外覆盖层状况检测的方法,一种是多频管中电流法,另一种是DCVG/CIPS组合检测技术。分别介绍了两种方法的工作原理、操作方法和设备,并结合工程实例进行了说明。这些方法和设备可分别或同时用于管道不开挖检测防腐层破损点的位置以及漏点大小。     

小浪底水库坝前漏斗区泥沙测验分析

小浪底水库坝前漏斗区的形成和发展,直接影响到枢纽建筑物的安全运行。为了保持塔前“门前清,”掌握坝前漏斗区的形成和发展,保证水库进入拦沙后期和正常运用期的正常运用,对坝前漏斗区进行了泥沙测验分析。结果表明:目前漏斗区范围内纵向坡度较缓,尚没有明显的漏斗形成,仅在坝前和塔前200m×1000m范围形成了漏斗雏形。     

无线网状网技术与应用

无线网状网(WMNs)由网状路由器节点和客户机节点组成,其中的网状路由器节点组成了无线网状网的网络骨干,其移动性很小。他们一起为无线网状网和其他常规无线网络的客户机节点提供网络的无线接入。WMNs技术结合了中心式控制的蜂窝网与分布式控制的无线自组织网的优点,可有效克服这两种技术的缺陷并显著提高无线网络的性能,已经成为下一代无线通信网络的研究热点之一。WMNs可为无线个域网、局域网、校园网、城域网的一系列应用提供高速无线宽带接入服务。虽然目前WMNs技术发展很快,但其协议栈各层仍存在许多有待研究的课题。首先简要介绍了无线网状网的结构与特点;随后重点分析了其主要的几个应用领域;最后探讨了WMNs各协议层的研究现状与关键技术,并分析了该技术存在的问题及未来的研究方向。     

HART协议物理层设备的测试（II）

本文介绍HART协议物理层设备的测试要求、测试设备、测试方法及测试时的一些特别说明。     

W‐band physical layer design issues in the context of the DAVID–DCE experiment

This paper aims at focusing on the aspects concerning the physical layer design for an innovative satellite communication experiment. Such an experiment, denoted by the acronym DAVID–DCE (Data and Video Interactive Distribution—Data Collection Experiment) is based on the exploitation of the W‐band (75–110 GHz) for high‐bit‐rate satellite transmission. The potential advantages of using of the W‐band are mainly related to the great bandwidth availability, and to the absence of interference. Moreover, an expected result of the experiment is a substantive improvement in the communication system's performances in the presence of meteorological phenomena (e.g. rain) as compared with the more conventional Ka‐band satellite transmission. On the other hand, problems to be faced concern the non‐ideal behaviours of hardware devices employed for high‐frequency digital transmission. In particular, carrier recovery and timing recovery are the most crucial signal‐processing tasks to be carefully considered in the design of the physical level of the system, because they considerably suffer from hardware impairments. The purpose of this work is to illustrate the proposed solutions in terms of the most critical modulation, demodulation and synchronization design issues, together with the effects of non‐ideal behaviours of hardware components on BER performances. Copyright © 2004 John Wiley & Sons, Ltd.