溅渣护炉工艺探讨

从炉渣对炉衬和溅渣层的侵蚀机理入手,提出了兼顾冶金和溅渣双重效果的直接造渣工艺,探讨了终渣碱度、MgO、FeO含量等的调整范围,分析了溅渣操作中枪位、时间等的控制和炉底上涨的原因,以期更好地运用溅渣护炉技术。     

以不同PAN系炭纤维布制备燃料电池气体扩散层之研究

采用石墨化PAN系炭纤维布制备了高分子电解质燃料电池气体扩散层。通过电学实验、X-ray绕射与元素分析考察了所制气体扩散层的性能。结果表明：随热处理温度的升高，气体扩散层的电阻率降低，L2增加，d（x）2减小。高温处理后的炭纤维布作为高分子电解质燃料电池气体扩散层显示了较高的电池效能。     

Influence of the Preheat Treatment on the Microstructure and Properties of X37CrMoV5-1 Steel

The technological properties of the hot-work tool steels depend on their microstructural quality induced by the production process and the heat treatment. One of the frequently applied methods to improve microstructure is preheat treatment. The treatment of carbonitriding X37CrMoV5-1 steel has been investigated in fluidized bed furnaces. Thickness and phase composition have been conducted using optical microscopy Neophot 32 and scanning microscopy, JEOL 5400, after etching in nital.     

坨五站中间乳化层快速增长原因及治理方案

胜利采油厂坨五站高含水(95％)原油化学预脱水中，二级沉降罐内油水相之间的中间乳化层增长迅速，引起了一系列问题。现场调查和大量室内测试结果表明，产生这一现象的原因有：油溶性破乳剂WD-1加入点不合理。有2／3的含水原油在通过油水分离器之后才与破乳剂混合；二级沉降罐进油口伸入油相内，油流的冲击达不到中间层；WD-1对坨五站混合原油中的稠油破乳脱水性能欠佳，不能适应坨五站混合原油组成和含水的变化。针对上述各种原因筛选出了性能更好的一种破乳剂1916。根据确定的几种原因采取了相应的措施：将破乳剂加入点改在3个并联油水分离器之前；将二级沉降罐的进油口移到水相内；改用筛选出的破乳剂1916，结果使中间乳化层的增长受到了抑制。图2表4参2。     

Transition to turbulence in rotating-disk boundary layers—convective and absolute instabilities

This work is an experimental study of mechanisms for transition to turbulence in the boundary layer on a rotating disk. In one case, the focus was on a triad resonance between pairs of traveling cross-flow modes and a stationary cross-flow mode. The other was on the temporal growth of traveling modes through a linear absolute instability mechanism first discovered by Lingwood (1995, J Fluid Mech 314:373–405). Both research directions made use of methods for introducing controlled initial disturbances. One used a distributed array of ink dots placed on the disk surface to enhance a narrow band of azimuthal and radial wave numbers of both stationary and traveling modes. The size of the dots was small so that the disturbances they produce were linear. Another approach introduced temporal disturbances by a short-duration air pulse from a hypodermic tube located above the disk and outside the boundary layer. Hot-wire sensors primarily sensitive to the azimuthal velocity component, were positioned at different spatial (r,θ) locations on the disk to document the growth of disturbances. Spatial correlation measurements were used with two simultaneous sensors to obtain wavenumber vectors. Cross-bicoherence was used to identify three-frequency phase locking. Ensemble averages conditioned on the air pulses revealed wave packets that evolved in time and space. The space–time evolution of the leading and trailing edges of the wave packets were followed past the critical radius for the absolute instability, r _{c A} . With documented linear amplitudes, the spreading of the disturbance wave packets did not continue to grow in time as r _{c A} was approached. Rather, the spreading of the trailing edge of the wave packet decelerated and asymptotically approached a constant. This result supports the linear DNS simulations of Davies and Carpenter (2003, J Fluid Mech 486:287–329) who concluded that the absolute instability mechanism does not result in a global mode, and that linear-disturbance wave packets are dominated by the convective instability. In contrast, wave-number matching between traveling cross-flow modes confirmed a triad resonance that lead to the growth of a low azimuthal number (n = 4) stationary mode. At transition, this mode had the largest amplitude. Signs of this mechanism can be found in past flow visualization of transition to turbulence in rotating disk flows.     

Normality and impairment following profound early institutional deprivation: A longitudinal follow-up into early adolescence.

Longitudinal analyses on normal versus impaired functioning across 7 domains were conducted in children who had experienced profound institutional deprivation up to the age of 42 months and were adopted from Romania into U.K. families. Comparisons were made with noninstitutionalized children adopted from Romania and with nondeprived within-U.K. adoptees placed before the age of 6 months. Specifically, the validity of the assessment, the degree of continuity and change in levels of functioning from 6 to 11 years, and the factors in the pre- and postadoption environment accounting for heterogeneity in outcome were examined. Pervasive impairment was significantly raised in children experiencing institutional deprivation for ≥6 months of life, with a minority within this group showing no impairment. There was no additional significant effect of duration of deprivation beyond the 6-month cutoff, and few other predictors explained outcome. The pattern of normality/impairment was mainly established by 6 years of age, with considerable continuity at the individual level between 6 and 11 years. The findings are discussed in terms of the possibility of a sensitive period for development. (PsycINFO Database Record (c) 2010 APA, all rights reserved)     

不同加工工艺的锑化镓晶片损伤研究

用透射电子显微镜、扫描电镜对锑化镓材料切、磨、抛等加工工艺引入的表面损伤进行观察和检测。结果表明：切割加工是锑化镓单晶晶片表面损伤层引入的主要工序；锑化镓单晶切割片表面极不平整，有金刚砂所引起的较粗桔皮皱纹；其表面损伤层深度≤30μm；双面研磨的锑化镓晶片表面仍有较粗桔皮皱纹，但比切割片的要细，而且桔皮皱纹的深浅随磨砂（Al2O3)粒径的减小而变细变浅；晶片的表面损伤层深度（≤5μm）也随着磨砂粒径的减小而减小。一般情况下，其损伤层的深度约为磨砂粒径的1/2。机械化学抛光加工的锑化镓晶片表面的SEM像观察不到桔皮皱纹；其损伤层深度约55nm。     

针对混合应用业务的ARQ改进方案

在高速无线通信中,自动请求重传(ARQ)是链路层不可缺少的技术,它通过重传向上层屏蔽无线链路上包的丢失。随着无线网络的发展,无线传输速率不断提高,应用的业务类型也越来越广泛。目前,众多ARQ技术的研究都集中在如何提高该技术的确认效率,以适应更高的传输速率,但鲜有研究着手于如何使ARQ能够更好地应用于混合业务环境。针对混合业务环境下的ARQ改进提出了2种方案,并给出其中1种在实际应用中的改善效果。     

盘石头水库河槽段趾板基岩的地质概况与防渗设计分析

盘石头水库河槽段趾板基岩建基面下8m为相对不透水层,如按常规进入不透水层5m设计帷幕,深度只有13m左右,对100m高坝而言,深度偏浅,为安全考虑,帷幕设计为悬挂式帷幕,主帷幕深度按1/3坝高考虑,穿透隔水层,隔水层以上以一排主帷幕和两排副帷幕防渗,隔水层以下以一排主帷幕防渗。     

埋地管道三层PE外覆盖层及其检测方法研究

文章介绍了埋地管道三层PE外覆盖层系统的构造参数和性能特点,论述了两种用于埋地钢质管道外覆盖层状况检测的方法,一种是多频管中电流法,另一种是DCVG/CIPS组合检测技术。分别介绍了两种方法的工作原理、操作方法和设备,并结合工程实例进行了说明。这些方法和设备可分别或同时用于管道不开挖检测防腐层破损点的位置以及漏点大小。