Effect of thermomechanical treatment on mechanical properties and electrical conductivity of a CuCrZr alloy

The CuCrZr alloy undergoes processes of precipitation during ageing. Besides precipitation hardening the strength is affected by cold deformation which is performed before and after ageing. The cold deformation (D ₁) before ageing accelerates the process of strength hardening, since it induces higher rate of precipitation from the saturated a-sold solution. Cold deformation (D ₂) after ageing primarily affects the alloy strength. In this paper the results of the effect of thermomechanical treatment on mechanical properties and electrical conductivity of a CuCrZr alloy are presented. The aim of the paper was to evaluate the most suitable combination of thermomechanical treatment and alloy properties.     

原油沥青质沉积引起储集层损害的室内评价

防止沥青质沉积造成的储集层损害是渤海稠油油藏开发生产中遇到的技术难题之一。结合渤海SZ36-1油田实际情况，使用岩心流动实验装置，建立沥青质沉积导致储集层岩心渗透率下降的室内评价方法，并应用SARA法对稠油发生沥青质沉积的可能性进行预测。评价实验结果表明，损害程度与沥青质沉积量和储集层岩心的原始渗透率有关。沉积量越大，原始渗透率越低，则损害越严重。表5参12     

An integrated downstream processing strategy for the recovery and partial purification of penicillin acylase from crude media

An integrated process strategy for the recovery of penicillin acylase was developed, based on precipitation of non‐enzymatic proteins directly from Escherichia coli homogenates or crude extracts using Rolquat (quaternary ammonium salt) and adsorption of the enzyme on Amp‐Seph (3.8 µmole ampicillin cm^?3) under pseudo‐affinity conditions. The effect of pH, concentrations of ammonium sulfate and Rolquat, and also concentrations of protein and cell debris on the precipitation of non‐enzymatic proteins from homogenates and crude extracts of penicillin acylase were analysed. The method of addition of Rolquat to homogenates and crude extracts significantly influenced the size of the precipitated particles. Improved results on the specific activity of penicillin acylase were obtained for 22% and 1% (w/v) of ammonium sulfate and Rolquat, respectively, added sequentially to enzyme solutions and at room temperature. Under these experimental conditions, the specific activity of penicillin acylase in homogenates and crude extracts was enhanced 2.5–3.0‐fold. Finally, the integrated process strategy was implemented first by precipitation of non‐enzymatic proteins and recovery of penicillin acylase directly from the enzyme solution treated with Rolquat using an adsorption/filtration system with an overall yield of 86%. This system allows simultaneously the filtration of cell debris and fine precipitated particles, in situ recovery of penicillin acylase by its adsorption on Amp‐Seph, and selective desorption of the enzyme with a specific activity of 11 IU (mg prot)^?1 and a desorption yield of 95%. © 2002 Society of Chemical Industry     

高压CO_2和乙醇协同沉淀法从牛乳中分离蛋白质的研究

以CO2 为沉淀剂 ,乙醇为CO2 助溶剂 ,考察了高压CO2 和乙醇对牛乳中蛋白质的协同沉淀作用。结果表明 :牛乳中蛋白质的沉淀存在着临界温度和临界压力 ,分别为 3 2℃和2 76MPa ,当体系高于这个临界温度和临界压力时对沉淀过程有利 ;CO2 和乙醇对牛乳中蛋白质的沉淀具有双重作用 ,在水体系中加入乙醇既有助于增加CO2 的溶解度 ,也可以使沉淀的临界温度和临界压力降低     

A new method for the determination of wax precipitation from non-diluted crude oils by fractional precipitation

Wax precipitation is one of the most important flow assurance problems. Unfortunately, experimental data are very scarce to confirm existing models for prediction of such precipitation problem. This work reports a new experimental method. Multistage fractional wax precipitation was carried out by decreasing the temperature of crude oil. No solvent dilution was used, so the effect of solvent on temperature wax precipitation was avoided. The reproducibility of the method was tested with comparable results. The precipitation curve and the wax appearance temperature were obtained for two crude oils with different chemical nature using the reported method.     

不锈钢热轧浊环水处理工艺设计

介绍了宝钢集团上海五钢不锈钢长型材热轧工程浊循环水处理的工艺设计，探讨了采用化学除油工艺、自动反清洗过滤器等技术和设备，处理不锈钢热轧浊环水的技术特点。     

从混联法生产中提取镓的研究

针对联合法厂家资源的分布特点,提出采用化学法和树脂吸附法相结合的方式实现同时回收烧结法和拜尔法循环母液中镓的新工艺,并通过小试和扩试结果分析,阐述了该工艺的可行性。     

高压静电除垢技术在发电厂汽轮机凝汽器中的应用

汽轮机凝汽器的除垢问题通常采用化学方法或物理方法,这些除垢措施有一定的局限性。介绍了一种利用高压静电除垢技术。     

三(明)钢烧结厂电除尘灰的气力输送

三钢烧结厂130m^2烧结机电除尘输灰首次采用了气力输送系统。该系统由气源、输送、管路、灰库及控制五部分组成，本文介绍了系统的工作原理及运行调试情况。系统投产后，运行平稳，达到了设计要求。     

Si相的析出状态对Al—Si合金性能的影响

控制Si相的析出状态,会对Al-Si(1wt％)合金的性能产生不同的影响。本文阐述通过不同的热处理工艺改变了Al-Si(1wt％)合金的机械、物理性能,获得了高形变强化率、高塑性变形能力、高拉伸强度的工艺,还讨论了具有上述高拉伸强度的微细丝在半导体器件应用中所具有的优越性。