Generalized difference control of parallel streams temperatures

A furnace with multiple parallel passes and multiple burners is commonly seen in petroleum refineries. In order to maintain the furnace running in a safe, stable, and high-efficiency state it is necessary to control the outlet temperatures of the multiple passes to be the same. Due to the fact that the process of the oil heating in such furnace is nonlinear, multivariable, time varying, has serious coupling among passes, has frequent dynamic changes and a large time delay, traditional control methods have trouble in controlling these temperatures, and some advanced control methods, including predictive control, adaptive control, and robust control, are usually too complex for convenient use. In this paper, a control technique, called differences control technique (DsCT), is proposed to distribute the stream flowrates such that the stream temperatures are as identical as possible. The principle of the proposed technique is explained and demonstrated, and the results of its application to a real-life petroleum refinery furnace are also reported. The DsCT technique has the following advantages: it does not need complicated design procedures, the controller structure is simple, it is easy to apply, and it can be canonically applied to furnaces with different number of passes.     

Electrochemical mass transfer between an impinging jet and a rotating disk in a confined system

This paper presents the mass transfer results from an impinging liquid jet to a rotating disk. The mass transfer coefficients were measured using the electrochemical limiting diffusion current technique (ELDCT). Rotational Reynolds number (Re_r) in the range of 3.4 × 10⁴–1.2 × 10⁵, jet Reynolds number (Re_j) 1.7 × 10⁴–5.3 × 10⁴ and non-dimensional jet-to-disk spacing (H/d) 2–8 were taken into consideration as parameters. It was found that the jet impingement resulted in a substantial enhancement in the mass transfer compared to the case of the rotating disk without jet.     

新疆油田微生物开采稠油技术研究及矿场试验

通过室内筛选复壮,选育出对克拉玛依稠油具有显著降粘作用的微生物菌种.室内降粘实验结果表明,菌种对稠油的降粘率可达70%,同时菌种可以改善稠油的流体性质.原油族组分分析结果表明,菌种能够降解稠油中的非烃和长链饱和烃.首次在克拉玛依油田进行了6口井的微生物吞吐开采稠油矿场试验,累计增油865t.     

EXPERIMENTAL AND NUMERICAL INVESTIGATIONS ON HORIZONTAL OIL-GAS FLOW

Experiments were carried out to investigate the characteristics of oil-gas flow in a horizontal pipe on a large scale (with the inner diameter D = 125 mm). With the experimental data, the flow patterns were presented. Through the analyses for the flow regime transition, it was found that there was a critical superficial velocity of liquid phase for the flow regime transiting from stratified flow to slug flow. The slug flow could not occur until the superficial velocity of liquid phase was higher than the critical velocity. For the flow pattern transiting from stratified to slug flow, the transmitting velocity of gas phase decreases with the augmentation of superficial velocity of liquid phase. On the basis of the experiments, numerical simulations of different flow patterns and their transitions were performed with the use of the Volume Of Fluid (VOF) technique. The results of the computations are shown to match well with the measured data in the experiments.     

青藏铁路西格二线混凝土冻融试验研究

由于工期的要求,青藏铁路西格增建二线必须进行冬期施工。根据工程状况,分析了混凝土受冻的破坏机理,针对施工环境及对混凝土设计强度和要求,进行了大量冻融试验分析,对引气剂、水胶比、砂率、粉煤灰掺量等原材料与混凝土含气量的关系及其混凝土搅拌温度与静停时间等对混凝土性能的影响进行了分析与技术论证,确保了该线冬期混凝土施工顺利进行。     

基于随机分析和概率预测的固定式海洋平台结构风险评估研究

对极端海况进行了环境荷载的联合概率分析。引入了整体不确定性和敏感性分析理论,利用非正态过程、具有不同相关性的多变量随机模拟技术,求解结构的失效概率。提出结构失效分析的新方法,并利用DNV提供的历史数据,对结构失效的后果做了适当分析。以埕北12-C井组平台为实例,对平台甲板高程(Air Gap)失效分析进行了实例计算。结果表明,使用多维联合极值分布理论及相应的求解方法,是离岸工程结构物风险评估的重要手段。     

克拉-2气田射孔工艺研究

克拉-2气田具有5大射孔难题:射孔井段长、地层压力大、产气量大、流体中腐蚀性物质和不宜丢枪,作业风险非常大。提出了带枪生产的射孔方案和射孔后取枪生产2种射孔方案,通过分析对比优选出最佳方案——最终选定模块式射孔枪过油管方案,并对该方案作了较为详尽的叙述,在后来的施工中成功地得到了印证。     

山西沁南煤层气井试气工艺分析

对山西沁南地区三口煤层气井试气施工工艺进行总结分析，改进了注入压降测试管柱，采用电潜泵法对煤层排采测气。对今后煤层气井的施工具有一定的指导意义。     

喷锚网技术在高陡边坡防护中的应用

喷锚网支护可提高高且陡的边坡岩土结构强度和抗变形刚度,增强边坡的整体稳定性.根据公路路段的情况,路堑边坡采用喷锚网支护的形式,针对设计方案、材料要求、施工方法、技术措施,以及现场质量管理和检测问题进行探讨.     

CO2 emissions in Greece for 1990–2002: A decomposition analysis and comparison of results using the Arithmetic Mean Divisia Index and Logarithmic Mean Divisia Index techniques

This paper deals with the decomposition analysis of energy-related CO₂ emissions in Greece from 1990 to 2002. The Arithmetic Mean Divisia Index (AMDI) and the Logarithmic Mean Divisia Index (LMDI) techniques are applied and changes in CO₂ emissions are decomposed into four factors: income effect, energy intensity effect, fuel share effect and population effect. The period-wise and time series analyses show that the biggest contributor to the rise in CO₂ emissions in Greece is the income effect; on the contrary, the energy intensity effect is mainly responsible for the decrease in CO₂ emissions. A comparison of the results of the two techniques gave an insight in the intricacies of energy decomposition. Finally, conclusions and future areas of research are presented.