用边界拟合坐标下的有限差分法评价城市的地下水资源

本文给出了边界拟合坐标系下的二维地下的二维地下水流的基本方程，并且用该坐标系下的有限差分法对江苏某市的承压水和潜水资源进行评价。预测了１９９１－２０００年的地下水流场，边界拟合坐标下的ＡＤＩ法的计算结果和实测水位比较一致，表明该方法在地下水资源评价中有实际应用价值，尤其在处理边界几何形状复杂的地下水流问题时更为有效。     

关于Gibbs函数变关系式引出的探讨

本文推荐陈林根编著的《工程化学》对化学热力学基本公式△G=△H-T△S的引出方法,试探基础教学的改革。     

NUMERICAL MODEL FOR DYNAMIC SIMULATION OF TRAFFIC FLOW

ＮＵＭＥＲＩＣＡＬＭＯＤＥＬＦＯＲＤＹＮＡＭＩＣＳＩＭＵＬＡＴＩＯＮＯＦＴＲＡＦＦＩＣＦＬＯＷＷｕＺｈｅｎｇ；ＺｅｎｇＬｉ－ｎｏｎｇ（ＤｅｐａｒｔｍｅｎｔＡｐｐｌｉｅｄＭｅｃｈａｎｉｃｓ，ＦｕｄａｎＵｎｉｖｅｒｓｉｔｙ，Ｓｈａｇｈａｉ２００４３３，Ｐ...     

A semi-analytic boundary element method for parabolic problems

A new semi-analytic solution method is proposed for solving linear parabolic problems using the boundary element method. This method constructs a solution as an eigenfunction expansion using separation of variables. The eigenfunctions are determined using the dual reciprocity boundary element method. This separation of variables-dual reciprocity method (SOV-DRM) allows a solution to be determined without requiring either time-stepping or domain discretisation. The accuracy and computational efficiency of the SOV-DRM is found to improve as time increases. These properties make the SOV-DRM an attractive technique for solving parabolic problems.     

灌河潮流界位置确定与港口防淤探讨

盐城市位于江苏省中部,地处黄海之滨,承接里下河腹部区的排水,区内入海河流众多,在这些入海河流上大多建有挡潮闸坝。但由于盐城市近海为淤积型海岸,闸坝的建设改变了河口的自然状态,造成港口下游淤积严重,排水不畅。灌河作为江苏省沿海唯一下游没有建挡潮闸的重要入海河流,仍为自然状态,下游港口未淤积。本文通过对灌河水体涨、落潮中氯离子含量的监测,找出海水上溯的最大距离,确定其影响范围,为其它入海流河流的防淤提供借鉴。     

三峡水库蓄水前后长江上游近期水沙变化趋势

受多种因素影响,近年来长江上游来沙量明显减少,这将对三峡水库的效益产生影响。本文首先用实测年径流量和年输沙量双累积曲线统计分析法及Spearman秩次相关检验分析了三峡上游来水来沙减少的事实,并统计得到了近期来水来沙量的相关关系,该关系可用于预测近期三峡水库的入库年沙量。然后研究了上游大中小水库群拦沙淤积对减沙的影响系数,α相关分析结果表明α与水库下游沿程距离L呈指数函数关系。     

三维精细积分法地震正演及边界条件

 将任意差分精细积分法用于三维波动方程地震正演，关键在于如何消除数值计算中有限波场区域边界引起的边界反射。文中采用Berenger给出的电磁波完全匹配层吸收边界条件，推导出三维波动方程任意差分精细积分法地震正演的完全匹配层吸收边界条件计算公式，并给出了完全匹配层吸收边界条件算例。计算结果表明，此方法压制边界反射效果明显。三维波动方程地震正演模拟实例表明，完全匹配层吸收边界条件的任意差分精细积分法为复杂区地震波传播规律研究提供了一种实用的正演模拟工具     

1960年以来渭河下游河道的自动调整作用

1960年以来，渭河下游河道来水来沙条件和边界条件都发生了较大的变化，河道纵横剖面形态针对这些变化进行了相应的调整，通过分析河相关系、主槽面积、河底高程以及弯曲系数的调整规律，对渭河下游河道的自动调整作用进行了研究。     

Effect of pH on the Crystallization of Homogeneously Precipitated Nanosized PZT Powder

Nanosized lead zirconate titanate (PZT) powder with Zr:Ti ratio in the morphotropic phase boundary region was synthesized by homogeneous precipitation of metal ions. The powder precipitated at 90°C and at pH 6.7 resulted single-phase perovskite lead zirconate titanate powder when calcined at 550°C and above for 4 hours in air. The solution pH and the precipitation temperature strongly affect the composition of the calcined powder. The results obtained by structural characterization of homogeneously precipitated powder were compared with that obtained from the conventional precipitation method using ammonia in terms of crystallization, homogeneity, and microstructure. The homogeneously precipitated powder showed smaller particle size, minimum agglomeration and uniform shape on calcination and annealing. Powdered samples that precipitated by homogeneous precipitation crystallized directly to perovskite PZT, without any intermediate pyrochlore phase formation. In contrast, the NH₃ precipitated powder converted to perovskite PZT via metastable pyrochlore and it showed phase segregation upon annealing at higher temperatures. The reaction kinetics has been studied by X-ray diffraction, differential thermal analysis, and differential scanning calorimetry.     

Flow Control Through the Use of Topography

In this work, optimal shaft shapes for flow in the annular space between a rotating shaft with axially-periodic radius and a fixed coaxial outer circular cylinder, are investigated. Axisymmetric steady flows in this geometry are determined by solving the full Navier-Stokes equations in the actual domain. A measure of the flow field, a weighted convex combination of the volume averaged square of the L₂-norm of the velocity and vorticity vectors, is employed. It has been demonstrated that boundary shape can be used to influence the characteristics of the flow field, such as its velocity component distribution, kinetic energy, or even vorticity. This ability to influence flow fields through boundary shape may be employed to improve microfluidic mixing or, possibly, to minimize shear in biological applications.