Uplink Scheduling in CDMA Packet-Data Systems

Uplink scheduling in wireless systems is gaining importance due to arising uplink intensive data services (ftp, image uploads etc.), which could be hampered by the currently in-built asymmetry in favor of the downlink. In this work, we propose and study algorithms for efficient uplink packet-data scheduling in a CDMA cell. The algorithms attempt to maximize system throughput under transmit power limitations on the mobiles assuming instantaneous knowledge of user queues and channels. However no channel statistics or traffic characterization is necessary. Apart from increasing throughput, the algorithms also improve fairness of service among users, hence reducing chances of buffer overflows for poorly located users. The major observation arising from our analysis is that it is advantageous on the uplink to schedule “strong” users one-at-a-time, and “weak” users in larger groups. This contrasts with the downlink where one-at-a-time transmission for all users has shown to be the preferred mode in much previous work. Based on the optimal schedules, we propose less complex and more practical approximate methods, both of which offer significant performance improvement compared to one-at-a-time transmission, and the widely acclaimed Proportional Fair (PF) algorithm, in simulations. When queue content cannot be fed back, we propose a simple modification of PF, Uplink PF (UPF), that offers similar improvement. Hereafter, we refer to users with low recieved power at the base even when transmitting at peak transmit power as “weak” users, and the strongly recieved users at the base as “strong” users. Krishnan Kumaran is currently a member of the Complex Systems Modeling section in the Corporate Strategic Research of ExxonMobil Corp., Clinton, NJ. Formerly, he was a Member of Technical Staff in the Mathematics of Networks and Systems Research Department at Bell Labs in Murray Hill, NJ, where his research interests were in modeling, analysis and simulation of design, resource management and scheduling issues in telecommunication networks. Lijun Qian is an assistant professor in the Department of Electrical Engineering at Prairie View A&M University. He received his B.S. from Tsinghua University in Beijing, M.S. from Technion-Israel Institute of Technology, and Ph.D. from WINLAB, Rutgers University, all in electrical engineering. Before joining PVAMU, he was a researcher at Networks and Systems Research Department of Bell Labs in Murray Hill, NJ. His major research interests are in wireless communications and networking technologies, especially in radio resource management, protocol design, TCP/RLP optimization and MPLS traffic engineering.     

周宁水电站工程项目管理实践

福建周宁水电站工程由闽东水电开发有限公司负责项目管理。该项目严格按照《招投标法》进行工程和设备的招标,进行了多项设计优化,注重工程质量和安全文明生产,积极开展达标投产工作,实现了进度快、质量优、投资省、效益好的管理目标。     

钻井井喷失控井喷流出口速度预测方法研究

失控井喷流出口速度、喷口内压力、喷层产量都是井喷失控处理方案设计、作业施工中重要的基础数据。由于井喷失控井井口环境条件复杂，井喷失控后无法在井口安装测量仪表及在高速喷流中放入参照物，不能直接获取以上数据。文章利用地质、钻井过程获得的地层物性参数和气体动力学方程，探讨井喷失控井天然气喷流在不同井筒流动尺寸及组合的喷流速度预测模型，可应用薄剪切模型或RNG修正的k-ε模型定量描述速度场、温度场、浓度场颁。为井喷失控井处理方案设计、施工作业提供基础数据。     

聚合物驱偏心分质注入技术

大庆油田主力油层聚驱结束后，聚驱驱替对象已转向渗透率更低、层间差异更大的二、三类油层，分注技术面临着新的矛盾。高渗透率油层需要控制注入量，同时要降低粘损率；低渗透油层要适当降低相对分子质量和粘度，以保证不堵塞油层又有足够的注入速度。为此，研究了聚合物驱偏心分质注入技术，可实现对分层相对分子质量、注入量的双重调节，并在注聚区块开展了现场试验，见到了明显效果。     

柴油蜡晶的理论形态预测与显微实际形态的比较

采用BFDH模型和AE模型预测柴油中蜡晶的理论形态，与通过相衬光学显微镜在冷环境平台上观察柴油蜡晶在低温下析出的实际形态。以及加入低温流动性改进剂T1804的柴油蜡晶形态进行比较研究。以十八烷晶体和二十三烷晶体作为柴油蜡晶中偶数正构烷烃和奇数正构烷烃的模型化合物，得到它们的晶体理论形态为六面体薄片状晶体。不同降温速率下得到的蜡晶的实际形态与大小均不同。快速降温条件下得到的晶体形态主要为六边形、菱形和其它少数不规则多边形薄片状集合体；慢速降温条件下得到的柴油蜡晶的形态比较完整，为六边形片状，与通过BFDH和AE模型得到的十八烷即偶数正构烷烃的形态比较接近。柴油加T1804后，快速降温时，出现更多细小的无规则晶体，且很快聚集成片状晶体；慢速降温时，出现晶体的数目要多于未加剂柴油，形状不规则，且尺寸小于未加剂柴油。     

干腌火腿的质量缺陷及防止措施

由于猪腿原材料或者加工技术的问题,而造成干腌火腿产品质量的多种缺陷。综述了干腌火腿中常见的各种质量缺陷以及防止这些质量缺陷的措施。     

宽带综合IP网的MPLS技术及其应用

多协议标记交换（MPLS）技术是综合利用网络第二层交换技术的有效性和第三层IP路由的灵活性等优点而产生的多层交换技术。通过在传统的IP包里加入标记，使路由转发依赖于标记，大大地提高IP包的转发速度，同时可使传统IP网络具有服务质量（QoS）能力。现主要分析MPLS体系结构，指出MPLS的一些应用。     

A Bluetooth Based Sensor Network for Civil Infrastructure Health Monitoring

Communicating with sensors has long been limited either to wired connections or to proprietary wireless communication protocols. Using a ubiquitous and inexpensive wireless communication technology to create Sensor Area Networks (SANs) will accelerate the extensive deployment of sensor technology. Bluetooth, an emerging, worldwide standard for inexpensive, local wireless communication is a viable choice for SANs because of its inherent support for some of the important requirements – low power, small form factor, low cost and sufficient communication range. In this paper we outline an approach, centered on the Bluetooth technology, to support a sensor network composed of fixed wireless sensors for health monitoring of highways, bridges and other civil infrastructures. We present a topology formation scheme that not only takes into account the traffic generated by different sensors but also the associated link strengths, buffer capacities and energy availability. The algorithm makes no particular assumptions as to the placement of nodes, and not all nodes need to be in radio proximity of each other. The output is a tree shaped scatternet rooted at the sensor hub (data logger) that is balanced in terms of traffic carried on each of the links. We also analyze the scheduling, routing and healing aspects of the resulting sensor-net topology.     

新安江流域安徽省地区水环境状况分析

统计分析流域内点源污染、面源污染产生量与污染物入河量的调查监测数据,结果表明:安徽省辖新安江流域点源入河系数约为面源入河系数2~3倍,点源污染是流域内主要污染来源,但面源污染的作用不容忽视,尤其是总磷,有近2/3来自面源,相对省辖淮河、长江两流域来说,面源污染贡献率明显增大。指出流域污染防治必须综合考虑点、面源污染两个方面;在点源污染不太严重的情况下,对面源污染的治理必须引起足够的重视,才能取得实效。     

一种新型的多功能照相胶片影像质量评价方法

本设计了一种新型的多功能照相胶片感光性能和影像质量评价方法。这种方法的主要特点的快速、方便并有满足 实用要求的精确度。该方法仅使用一个测试标板，就可以很容易地测定出照相胶片的感光性能、分辨率、均方根粒度和密度振幅响应（DAR）值等多种表征影像质量的参数。本简要介绍该方法并给出试验结果及其与传统测试方法的比较和讨论意见。