潦河灌区农业水费计收现状分析及对策

阐述了潦河灌区农业水费计收现状，对水费计收现状进行分析并提出解决办法。     

户式中央空调发展方向的探讨

本文描述了我国户式中央空调的发展现状，分析了三种户式中央空调各自的特点，提出了把风管式机组作为我国户式中央空调的发展方向。     

丹江口工程大坝加高后的几个水力学问题

依托1∶100水工模型试验成果,重点介绍了丹江口大坝加高后的几个水力学问题如泄流能力、坝面压力特性、河床局部冲刷、下游河道流速流态、泄洪对电厂及航运的影响等.研究显示:大坝加高后泄流能力可满足设计要求,坝下河床冲刷加重,挑距加远,设计洪水22 300 m3/s时坝下冲坑最低点高程为43.0 m,各级泄量冲坑上游坡均缓于临界坡,也略缓于初期工程同级流量冲坑的上游坡;坝下600 m以内为护岸工程重点防护段,岸边流速为5.8～9.8 m/s;泄洪对丹江口电厂影响较小,对自备电站不利影响较为显著;最大通航流量6 200 m3/s时下游引航道口门区流态复杂,水流较混乱.     

Construction of a control system for disturbance rejection using a dual observer

A well‐known control system which can reduce the adverse effects of disturbances is a disturbance observer. However, in many cases of mechanical systems, system disturbances which do not satisfy the matching condition may be imposed. Therefore, it may be difficult to reduce the adverse effects of the disturbances by the traditional disturbance observer. In this paper, a method of control system synthesis for disturbance rejection using a dual observer is proposed. This method is based on the zeroing induced by the disturbance localization problem. This problem may be solved by dividing the state space into observable subspace and unobservable subspace. As compared with an H_∞ controller based on perfect observation, the usefulness of the proposed control system for disturbance rejection is demonstrated by numerical simulations for a two‐mass spring system. © 2002 Scripta Technica, Electr Eng Jpn, 138(4): 50–60, 2002; DOI 10.1002/eej.1138     

注聚井注入状况诊断方法研究

在室内试验和动态分析的基础上，对引起注聚井注入困难的原因进行了分析，提出了利用单井动态预测结果和实际注入动态曲线对比判断聚合物注入状况的方法，建立了预测注聚井注入动态的预测模型，并对数值模拟计算结果进行了分析。同时还评价了现场应用效果。通过数值模拟和实际注入动态曲线对比，可以初步判断待措施井有无近井地带堵塞，为提高注聚井压解堵措施的有效性奠定了基础。     

Transient Green’s Tensor for a Layered Solid Half-Space With Different Interface Conditions

Pulsed ultrasonic techniques can be and have been used to examine the interface conditions of a bonded structure. To provide a theoretical basis for such testing techniques we model the structure as a layer on top of a half-space, both of different elastic properties, with various interface bonding conditions. The exact dynamic Green’s tensor for such a structure is explicitly derived from the three-dimensional equations of motion. The final solution is a series. Each term of the series corresponds to a successive arrival of a “generalized ray” and each is a definite line integral along a fixed path which can be easily computed numerically. Willis’ method is used in the derivation. A new scheme of automatic generation of the arrivals and ray paths using combinatorial analysis, along with the summation of the corresponding products of reflection coefficients is presented. A FORTRAN code is developed for computation of the Green’s tensor when both the source and the detector are located on the top surface. The Green’s tensor is then used to simulate displacements due to pulsed ultrasonic point sources of known time waveform. Results show that the interface bonding conditions have a great influence on the transient displacements. For example, when the interface bonding conditions vary, some of the first few head waves and regular reflected rays change polarities and amplitudes. This phenomenon can be used to infer the quality of the interface bond of materials in ultrasonic nondestructive evaluation. In addition the results are useful in the study of acoustic microscopy probes, coatings, and geo-exploration.     

模拟电路的模块级故障诊断

本文以多端口元件或子网络为基本单元，提出了一种模块级故障诊断方案，这种方案的故障模型更符合电路的实际情况，因而具有更广泛的实际意义，文中首先推导了模块故障诊断议程，并对模块故障可测性问题进行了一般性讨论。然后，给出了模块故障可测的几个拓扑条件，并通过定义广义独立通路使这些拓扑条件适用于一般的非互易网络。     

改进的FD—TD法分析二维理想导体TM近区散射问题

本文针对一般ＦＤ－ＴＤ方法分析计算二维理想导体散射问题所遇到散射体边角处难以精确处理的缺点进行了改进。将边角处总场近似解析解直接引入ＦＤ－ＴＤ法差分公式，得到了有关修正系数，为了检验此方法的有效性，有无限长导体方柱为例分别用一般ＦＤ－ＴＤ法和本文的ＦＤ－ＴＤ方法进行了分析研究，并与ＭＯＭ法进行了比较，所得结果说明改进后的ＦＤ－ＴＤ方法对分析计算导体边角附近电流分布特性是较有效的。     

轮胎用钢丝帘线及在山东省的发展

介绍了钢丝帘线子午线轮胎的优点和国际上的发展情况。生产钢丝帘线的典型工艺及山东省的生产近况。     

康山金矿地质地球化学特征及其成因

康山金矿产在豫西熊耳山古隆起区的结晶基底太华群和盖层中元古界熊耳群地层接触界面附近，矿体严格受构造破碎蚀变带控制。流体包裹体，稳定同位素等研究表明，成矿物质来自太华群变质岩，成矿流体的性质与变质热液截然不同，而与花岗岩浆热液相近似。该矿床的形成与燕山期发生的同构造－花岗岩浆期热液活动有关，金沉淀成矿阶段有大气水的混入。