不同pH值条件下重金属捕集剂有效性的研究

采用高分子有机捕集剂与废水中的多种重金属离子发生螯合反应,生成稳定且不溶于水的金属螯合物来去除废水中的重金属离子。对4种捕集剂在不同pH值的条件下对含有汞、铜、镉、铅等重金属污水的去除效果进行了试验研究。结果表明,利用重金属捕集剂方法处理重金属废水的效率较高,有很好的应用前景。     

用分步沉积法去除Nb(OH)5/Ta(OH)5中Ti,Sb等金属杂质的工艺研究

从理论和实践应用方面，研究了在不同活性金属离子存在的条件下控制pH值，应用分步沉积的方法去除Nb(OH)5/Ta(OH)5中某些金属杂质。在一定温度下，可在不影响Nb(OH)5/Ta(OH)5沉积的条件下，达到有效去除Ti，Sb，Sn，Al，Fe等杂质元素的目的。     

反渗透系统给水电导率与pH的系统影响

测试并分析了一、二级反渗透系统给水电导率及pH与系统透盐率和浓淡水pH之间的关系.测定了给水pH在6～8、给水电导率在400～1 000μS/cm范围内的系统透盐率较低,且pH为7.5、电导率为500μS/cm的系统透盐率最低.此测试与分析为反渗透技术提供了重要的运行与设计依据.     

The emulsifying properties of a polysaccharide isolated from the fruit of Cordia abyssinica

Polysaccharide was isolated from Cordia abyssinica and its effect, at differing concentrations, on its emulsifying ability was determined. Emulsions of vegetable oil containing up to 1% of the polysaccharide in phosphate pH 7.4 buffer, were prepared by using a hand piston homogenizer. Emulsification was assessed by diluting samples of the emulsions in sodium dodecyl sulphate and measuring absorbance at 500 nm. Addition of increasing concentrations of the polysaccharide up to 1% enhanced emulsification and emulsion stability. Above 1% concentration the polysaccharide solutions were too viscous for making emulsions conveniently. At a constant concentration of the polysaccharide, addition of up to a 1% concentration of salt enhanced emulsion formation. Further addition of salt above 1% resulted in no further changes in emulsifying ability, but the stability of the emulsions formed decreased on increasing the concentration of salt above 1%. The effect of pH on emulsifying ability was investigated by preparing emulsions using buffers of different pH, from pH 3 to pH 13. The polysaccharide had poor emulsifying ability below pH 7. Emulsifying ability increased with pH between pH 7 and 11. At pH above 11 there was a decrease in emulsifying ability.     

美国对邮票用压敏胶的开发

介绍了美国对邮票用压教胶的开发情况及其在废纸回用过程中的良好表现，     

铬盐清洁生产工艺中铝的脱除

分析了K2Cr2O7清洁生产工艺中Al(Ⅲ）-K2CrO4-K2Cr2O7-H2O体系的离子平衡，推导出25℃时混合溶液中[Al(Ⅲ）]和[H^ ],[Cr2O7^2-]/[CrO4^2-]之间的对应关系。并由实验测定验证了这一关系。提出了通过调整K2CrO4碳酸化反应转化率来降低体系中Al(Ⅲ）杂质含量的新方法。工业试验已证明了其可行性。     

Recovery of pyruvic acid with weakly basic polymeric sorbents

BACKGROUND: Carboxylic acids are among the most important substances that can be manufactured from biomass. However, the recovery of carboxylic acids from fermentation broths presents a challenging separation problem. To avoid the production of waste salts and net consumption of chemicals in the calcium carboxylate salt process, the use of reversible chemical complexation with polymeric sorbents and extractants is attractive for carboxylic acid recovery. Pyruvic acid is widely used in the manufacture of medicines, pesticides and foodstuffs and can be produced by fermentation. Since the acidity of pyruvic acid (pK_a = 2.49) is stronger than that of normal carboxylic acids, and as few reports on the recovery of pyruvic acid are available, the sorption of pyruvic acid from aqueous solution on two types of weakly basic polymeric sorbent, tertiary amine D301R and primary amine D392, was investigated over a wide pH range and at various salt (MgSO₄) concentrations. RESULTS: Overloading adsorption of pyruvic acid on both weakly basic polymeric sorbents occurred, with the overloading of D392 being greater than that of D301R. The adsorption of pyruvic acid on both sorbents was greatly affected by the solution pH and the salt concentration in the aqueous phase. An overloading model was able to predict the experimental uptake data very well. CONCLUSION: Solution pH is one of the most important operating conditions, and both polymeric sorbents D392 and D301R can be used to recover pyruvic acid from dilute aqueous solution with high efficiency at a solution pH around 2. The uptake by D392 is greater than that by D301R owing to steric hindrance of the tertiary amine. Copyright © 2008 Society of Chemical Industry     

啤酒中测定双乙酰含量的EBC法的改进

EBC法是测定啤酒双乙酰的常规方法,但大量报道此法再生性和重复性较差,本文对影响此方法的一些因素进行了考查,发现酸碱度是影响EBC法的一个重要因素,并对EBC法进行改进。     

偏振CARS研究核苷分子振动结构

用偏振灵敏ＣＡＮＳ光谱研究尿嘧啶、胸腺嘧啶、胞嘧啶和腺嘌呤四种核苷分子的振动结构。谱的非共振背景被有效地消除，核苷的双键振动模清晰可辨，对每种核苷分子的特征谱线进行了标识，作为在生物分子中识别它们的标志。     

二次开发WinCC嵌入模糊控制算法

介绍了WinCC(WindowsControlCenter)的基本功能 ,详细阐述了如何利用WinCC的全局脚本编辑器 ,将用户自行开发的模糊控制算法嵌入WinCC中。通过WinCC与PLC之间的通讯 ,实现对某污水处理装置pH值的模糊控制