Preparation and Compressive Stress Effect of Polymer Matrix RE-Fe Giant Magnetostrictive Composite

Polymer matrix RE-Fe giant magnetostrictire composite （GMPC） was prepared using bonding and magnetic field forming technique, and magnetostriction of samples was measured for different compressive stress. The experimental results show thai there is certain compressive effect in GMPC. And the influence of compressive stress on magnetostriction of sample was investigated. It offers essential reference for application and device design of GMPC.     

解吸塔换热器706C结堵的原因分析及其对环保装置正常运行的影响

本文详细分析了解吸塔换热器结堵的原因和对环保装置正常运行的影响,并针对性地提出了防范和处理措施。     

基于SMS的水情信息传输系统的开发应用

黄委中游水文测区由于处在经济落后地区，当地电信部门通讯发展滞后。多年来各报汛水文站通讯手段主要依靠无线短波电台相互联系。近几年，随着电信部门移动通讯网络的快速发展，移动网络已基本覆盖中游水文测区所属各报汛水文站点。手机短信传递已经成为一种十分成熟的技术，通过对手机短信应用功能的开发，建立基于SMS的水情信息传输系统，将极大地提高中游水文测区水情传递的时效性和可靠性。     

The effect of nitrogen oxides in air on the performance of proton exchange membrane fuel cell

The effects of NO_x on the performance of proton exchange membrane (PEM) fuel cell were investigated through the introduction of a mixture containing NO and NO₂, in a ratio of 9:1, into the cathode stream of a single PEM fuel cell. The NO_x concentrations used in the experiments were 1480 ppm, 140 ppm and 10 ppm, which cover a range of three orders. The experimental results obtained from the tests of durability, polarization, reversibility and electrochemical impedance spectroscopy (EIS) showed a detrimental effect of NO_x on the cell performance. The electrochemical measurements results suggested that the impacts of NO_x are mainly resulted from the superposition of the oxygen reduction reaction (ORR), NO and HNO₂ oxidation reactions, and the increased cathodic impedance. Complete recovery of the cell performance was reached after operating the cell with clean air and then purging with N₂ for hours.     

Halo effects in grading student projects.

Halo effects in rating specific pieces of work, as in educational grading, have received little attention. Grades awarded by 2 independent graders to undergraduate projects were analyzed with a correlated uniqueness model. Grades showed substantial halo despite being awarded by expert assessors at the time of reading the work. There was greater halo between different grades applying to the same section of the project than between grades applying to different sections. Supervisors who had regular contact with the student whose work they were grading showed no more halo than other graders. More reliable graders showed less within-section halo than graders of lower reliability but equal between-sections halo. The halo effects observed cannot be entirely attributable to a unitary general impression. (PsycINFO Database Record (c) 2010 APA, all rights reserved)     

动态多目标决策问题的灰色分析方法

将用于固定时间截面下静态多目标决策的灰色关联理论推广到动态情形，引入局部理想最优效果和整体理想最优效果的概念，提出一种新型的动态多目标决策问题的灰色关联模型，并通过算例说明该方法的合理可行性。     

Fracture toughness of thermoset composites reinforced by perfectly bonded impenetrable short fibers

The fracture toughness of brittle thermoset resins could be improved significantly by perfectly bonded tough, short fibers through both crack trapping and bridging effects. In this paper, the crack trapping effect was studied through the analysis of the change of strain energy associated with the crack propagation across a regular array of fibers, and the bridging effect was discussed based on the Andersson–Bergkvist model. The fracture resistance increases with the fiber volume fraction, and is independent of the elastic properties of the matrix, the crack length, and the cross-sectional diameter of the fibers.     

Effect of Mineral on Metallurgical Coke Solution Loss Reaction in Blast Furnace

Thecokesolutionlossreactionisoneofthemostimportanteffectsresultingincokepulverizinginblastfurnace .Thefactorswhichaffectreactionincludecokeporestructure ,micro crystalstructureonporewall ,thecontentandconstituentofminer als ,etc .Amongthesefactors ,theconstituentofmineralsisemphasizedallovertheworldinrecentyears .Buttheemphasisofmoststudieswasputontheeffectofalkalimetals (K ,Na)oncokesolutionlossreactionandtheeffectofotherelementswassel domreported[1-5] .Theeffectofthirteenmineralsoncokesolut…     

Effect of strain waveform on creep-fatigue life for Sn–8Zn–3Bi solder

This paper describes the creep‐fatigue life of Sn–8Zn–3Bi under push–pull loading. Creep‐fatigue tests were carried out using Sn–8Zn–3Bi specimens in fast–fast, fast–slow, slow–fast, slow–slow and hold–time strain waveforms. Creep‐fatigue lives in the slow–slow and hold‐time waveforms showed a small reduction from the fast–fast lives but those in the slow–fast and fast–slow waveforms showed a significant reduction from the fast–fast lives. Conventional creep‐fatigue life prediction methods were applied to the experimental data and the applicability of the methods was discussed. Creep‐fatigue characteristics of Sn–8Zn–3Bi were compared with those of Sn–3.5Ag and Sn–37Pb.     

Free-Edge and Ply Cracking Effect in Angle-Ply Laminated Composites Subjected to In-Plane Loads

This paper presents a semianalytical method for the prediction of interlaminar stresses and displacements near the free edges and ply cracks in general angle-ply laminates subjected to biaxial extensions and/or in plane shear deformation. The method is based on a state space representation of the three-dimensional equations of elasticity. Numerical solutions are obtained by using layer refinement in the through thickness direction and Fourier series expansion in the other directions. By this approach, an angle-ply laminate may be composed of an arbitrary number of monoclinic layers and each layer may have different material property and thickness. This method guarantees continuous fields of all interlaminar stresses across interfaces between material layers. Numerical results are compared with those obtained from other methods. It is found that the theory provides a satisfactory approximation to the stress singularities near the free edges and ply cracks. Numerical solutions for antisymmetric laminates under extension and general laminates under shearing are new in the literature and can be used as benchmarks for validating new models.