通信局房供电系统的谐波治理

本文在理论分析谐波产生及危害的基础上,针对某一通信局房,确定最终谐波治理方案并取得较好的治理效果,供同行在设计时参考。     

SECANT-FUZZY LINEAR REGRESSION METHOD FOR HARMONIC COMPONENTS ESTIMATION IN A POWER SYSTEM

In order to avoid unnecessary damage of electrical equipments and installations,high quality power should be delivered to the end user and strict control on frequency should be made, Therefore, it is important to estimate the power system's harmonic components with higher accuracy. This paper presents a new approach for estimating harmonic component in a power system using secant - fuzzy linear regression method. In this approach the non - sinusoidal voltage or current waveform is written as I linear function. The coefficient of this function is assumed to be fuzzy number with a membership function that has center and spread value. The time dependent quantity is written as Taylor series with two different time dependent quantities. The objective is to use the sample obtained from the transmission line to find the power system harmonic components and frequencies. We used an experimental voltage signal from a sub power station as a numerical test.     

First Harmonic (2f) Characterisation of Resonant Frequency and Q-Factor of Micromechanical Transducers

In this paper, the response to the first harmonic component (2f) of the electrostatic force in single terminal driven electrostatic comb-drive and parallel-plate drive was used as a signal to extract device parameters, namely, the Q-factor and resonant frequency instead of the fundamental (1f) resonance response. It is shown that the difficulty in motional measurement due to electrical cross-talk (parasitics) using 1f measurement can be overcome with a higher signal-to-noise ratio of the 2f signal. Both atmospheric (low-Q) and reduced pressure environment were investigated using off-chip electronics and lock-in amplifier. The measurements were done on the electrostatic comb-drive and capacitive parallel plate sensing plates that form the two core modules of a yaw rate sensor (dual-axis resonator). The effects of AC and DC bias voltages on the measured response have been investigated. Experimental amplitude and phase response data have been analysed using the Lorentzian curve-fit, Resonance Curve Area (RCA) method, the half-power bandwidth method (3 dB) and the Nyquist plot for data fitting and determination of the Q-factor and resonance frequency.     

Analysis and Optimization of Noise in Bipolar RF Harmonic Mixers

A noise analysis of bipolar harmonic mixers (BHM) used for direct-conversion receivers is presented in this paper. Analytical and simulated results for the transfer function of the mixer are presented. Simple analytical expressions describing noise contribution from all sources are derived. Estimation of flicker noise quite agrees with harmonic-balance simulation results. Based on the derived expressions, total time average noise power spectral density (PSD) at the output is compared with simulation results. For the recommended regions of operation, error is less than 20%. The overall BHM noise figure (NF) is calculated and optimized based on a simple extracted formula. Errors introduced by analysis remain within a 1.5-dB margin with respect to simulation results. The validity of analysis for high frequencies is justified. The effect of flicker noise coefficient on the overall mixer NF is compared for different available processes.     

PWM开关变换器统一建模法与谐波分析法的应用

介绍了PWM开关功率变换器电路的统一建模方法，并将谐波分析方法应用于电路分析中，理论和实例表明，这种方法容易得到电路变量的基波解和各次谐波解，以及电路的传递函数，具有容易理解和准确度较高的优点。     

The costs and benefits of tonal centers for chord processing.

Harmonic priming studies have shown that a musical context, with its established tonal center, influences target chord processing. This study investigated costs and benefits of priming tonal centers for target processing by adding a baseline condition (sequences without a specific tonal center). Results confirmed harmonic priming, with faster processing for related than for unrelated and less related targets (tonic chord, out-of-key chord, subdominant chord). Comparing targets in baseline contexts with targets in sequences with well-established tonal centers revealed a benefit of processing for related targets but a cost of processing for unrelated and less related targets. Findings are discussed in terms of tonal knowledge activation and suggest that an activated tonal center gives rise to strong expectations for the tonic. (PsycINFO Database Record (c) 2010 APA, all rights reserved)     

纵向零序电压保护新方案及其应用

由于结构设计的原因，综合性能较好的一些保护方案如横差保护和不完全纵差保护等将不能应用于大型超临界汽轮发电机。文中重点讨论了纵向零序电压保护方案的改进及其在应用中的问题。研究表明，发电机发生匝间短路故障时3次谐波电势减小，而机组外部故障时发电机3次谐波电势增大。因此，为了提高纵向零序电压保护方案的性能，可以根据故障时3次谐波电压增量的特性作为选取制动量的依据，从而提高保护性能。亦即:当3次谐波电压表现为负增量时，制动量取为0或接近0;而当3次谐波电压表现为正增量时，以该增量值作为制动量。此外，对匝间保护纵向零序电压元件增加一个小延时是可行的，它可以提高保护躲暂态3次谐波影响的能力。仿真计算表明，比例制动式纵向零序电压保护能可靠区分内外部故障，符合大型超临界汽轮发电机的保护要求。     

电站并联运行的不对称非线性振荡

本文给出一个结构不完全对称并联电网的等价定理,它把双输入双输出非线性耦合的微分方程组等价为单输入单输出的非线性微分方程,然后用渐近方法和谐波线性化方法求其一次近似解,得到一些新的物理性质,有助于合理选择电网结构,以提高其结构稳定性.     

河口海岸水文信息处理系统

应用Visual Basic6.0应用程序、Microsoft Access数据库和FORTRAN语言开发的河口海岸水文信息处理系统，具有水文现场资料整编功能、利用分潮优化技术的潮汐调和分析及预报功能，且计算工作量相对较小，预报精度高。     

三门峡大坝温度观测资料分析

三门峡水利枢纽大坝为混凝土重力坝,原设计选择其溢流坝和安装场坝为重点观测坝段,因此,在施工中埋设了各种观测仪器1000多支。经对1958～1988年气温、坝体混凝土温度、基岩温度及水库水温观测资料分析表明:三门峡大坝温度变化规律虽与一般重力坝不同,但它却比较全面地反映了防洪与径流发电具体运用的特性。