DC/DC电源中的电磁干扰及其对策

概述了电磁干扰(EMI)和电磁兼容(EMC)的基本知识，对DC／DC电源中的电磁干扰进行了综合分析，并给出了各自的解决方案。     

隔河岩水电站大坝廊道排水系统自动化改造

隔河岩水电站大坝廊道排水控制系统存在设备备品、备件不足,技术落后,系统软件工作不稳定等问题,不能按库坝管理要求对排水量进行监控,严重影响廊道排水系统的可靠性。为此,对该系统进行了综合自动化改造,采用TCP6IP通讯,PLC直接上网,异种CPU热备冗余等技术,提高了整个系统的运行可靠性,满足了“无人值班”的要求。     

串行及并行A/D转换器在高速数据采集中的采样差别性分析

串行和并行接口模式是A/D转换器诸多分类中的一种,但却是应用中器件选择的一个重要指标.在同样的转换分辨率及转换速度的前提下,不同的接口方式不但影响了电路结构,更重要的是将在高速数据采集的过程中对采样周期产生较大影响.本文通过12位串行ADC ADS7822和并行ADC ADS774与AT89C51的接口电路,给出二者采样时间的差异性.     

基于FPGA的ASI信号接收与发送的实现

提出了一种用FPGA芯片代替Cypress公司的CY78933和CY78923芯片来实现ASI信号接收与发送的方案，详细阐述了DVB—ASI接口的硬件组成与FPGA实现，该接口符合DVB—ASI的接口规范，可实现270Mbps的信号传输，已经得到实际运用。     

有线电视新型业务发布架构研究

本文对现有的有线电视业务发布系统进行了介绍,指出了现有系统的特点,并结合现有系统的分析提出了一种新型的业务发布架构：基于UCL标引的大规模并行数据广播系统.该系统源自李幼平院士的第五传媒的思想,即结合互联网（第四传媒）和电视广播网（第三传媒）的优点,取数字广播作信道,采用“细水长流”的小通道把网站内容整体推送到家,并以先进、廉价的存储技术整合“两大传媒”,通过家庭机顶盒内“镜像存储”自由取用.它继承前两种传媒的长处,又避免了各自短处,是一种全新的文化工具.这应是未来业务发布系统的方向.     

基于FPGA的CAVLC编解码器设计与实现

H．264标准在基本档次和扩展档次中采用CAVLC熵编码，完成对变换系数残差块的编码。提出一种基于FPGA的H．264标准的CAVLC编解码器，程序代码用verilog硬件描述语言编写，并在QuartusⅡ中进行了仿真验证，可以实现对每个残差块数据的编解码并将其按照宏块光栅扫描的顺序输出到存储器，因此适合于嵌入在最终的码流中。仿真结果表明此CAVLC编解码器达到H．264标准中基本档次和扩展档次level3．0的性能要求。     

基于EAP/RADIUS的WLAN认证和密钥分配协议

研究了无线局域网的认证机制,描述了EAP/RADIUS协议在IEEE802.1x标准中的消息封装格式,针对基于端口访问控制协议的缺陷,提出一种新的应用于WLAN的认证和密钥分配方案,并设计详细协议流程.该协议基于EAP/RADIUS认证框架,使用服务令牌将认证和授权结合起来,授权校验的同时进行密钥分配,完善了WLAN的访问控制机制.     

1/f noise in large-area Hg<Subscript>1−x</Subscript>Cd<Subscript>x</Subscript>Te photodiodes

The 1/f noise in photovoltaic (PV) molecular-beam epitaxy (MBE)-grown Hg_1−xCd_xTe double-layer planar heterostructure (DLPH) large-area detectors is a critical noise component with the potential to limit sensitivity of the cross-track infrared sounder (CrIS) instrument. Therefore, an understanding of the origins and mechanisms of noise currents in these PV detectors is of great importance. Excess low-frequency noise has been measured on a number of 1000-μm-diameter active-area detectors of varying “quality” (i.e., having a wide range of I-V characteristics at 78 K). The 1/f noise was measured as a function of cut-off wavelength under illuminated conditions. For short-wave infrared (SWIR) detectors at 98 K, minimal 1/f noise was measured when the total current was dominated by diffusion with white noise spectral density in the mid-10⁻¹⁵A/Hz^1/2 range. For SWIR detectors dominated by other than diffusion current, the ratio, α, of the noise current in unit bandwidth i_n(f = 1 Hz, V_d = −60 mV, and Δf = 1 Hz) to dark current I_d(V_d = −60 mV) was α_SW-d = i_n/I_d ∼ 1 × 10⁻³. The SWIR detectors measured at 0 mV under illuminated conditions had median α_SW-P = i_n/I_ph ∼ 7 × 10⁻⁶. For mid-wave infrared (MWIR) detectors, α_MW-d = i_n/I_d ∼ 2 × 10⁻⁴, due to tunneling current contributions to the 1/f noise. Measurements on forty-nine 1000-μm-diameter MWIR detectors under illuminated conditions at 98 K and −60 mV bias resulted in α_MW-P = i_n/I_ph = 4.16 ± 1.69 × 10⁻⁶. A significant point to note is that the photo-induced noise spectra are nearly identical at 0 mV and 100 mV reverse bias, with a noise-current-to-photocurrent ratio, α_MW-P, in the mid 10⁻⁶ range. For long-wave infrared (LWIR) detectors measured at 78 K, the ratio, α_LW-d = i_n/I_d ∼ 6 × 10⁻⁶, for the best performers. The majority of the LWIR detectors exhibited α_LW-d on the order of 2 × 10⁻⁵. The photo-induced 1/f noise had α_LW-P = i_n/I_ph ∼ 5 × 10⁻⁶. The value of the noise-current-to-dark-current ratio, α appears to increase with increasing bandgap. It is not clear if this is due to different current mechanisms impacting 1/f noise performance. Measurements on detectors of different bandgaps are needed at temperatures where diffusion current is the dominant current. Excess low-frequency noise measurements made as a function of detector reverse bias indicate 1/f noise may result primarily from the dominant current mechanism at each particular bias. The 1/f noise was not a direct function of the applied bias.     

脉冲激光诱导Zn/InP掺杂过程中温度分布的解析计算

在实验的基础上 ,分析脉冲激光诱导半导体InP掺杂Zn过程 ,利用简化的一维模型 ,在第三类边界条件下 ,给出一种较直观的脉冲激光辐照有限厚双层材料Zn/InP的温度分布解析形式     

光传送网中的关键光器件

光器件是光传送网的基础单元之一，本主要综述光传送网中的关键光器件：光源与光探测器、光波分复用/解复用器、光放大器、色度色散与偏振模补偿器及光开关等。比较了各种光器件的主要技术方案，特别针对的是已实用化的技术方案。最后讨论了光器件的尺寸小型化、微型化以及多功能集成等发展趋势，介绍了光器件的集成方式如：传统分立光器件的集成，平面光波导集成，以及混合集成等。