A Lanczos-based method for structural dynamic reanalysis problems

In this paper, a new solution method for the modified eigenvalue problem with specific application to structural dynamic reanalysis is presented. The method, which is based on the block Lanczos algorithm, is developed for multiple low rank modifications to a system and calculates a few selected eigenpairs. Given the solution to the original system Ax = λx, procedures are developed for the modified standard eigenvalue Problem (A + ΔA)x? = λ x?, where

• 1 ΔA = Σ_jBS_jB^T, where S_j = S ∈ ?^{p × p}, p ? n and B ∈ ?^{n × p} is constant for all the perturbations S_j.
• 2 ΔA = Σ_iΣ_j B_iS_jB_i^T, where B_i ∈ ?^{n × p} may vary with the pertubations S_j.

The procedures are then extended for the reciprocal and generalized eigenvalue problems so that they are directly applicable to the structural dynamic reanalysis problem. Numerical examples are given to demonstrate the applications of the method.     

Reversible inactivation of purified leukocyte integrin CR3 (CD11b/CD18, alpha m beta 2) by removal of divalent cations from a cryptic site

Integrins exhibit reversible changes in their ability to bind ligands and these changes enable transient cell adhesion. We recently showed that leukocyte integrin CR3 (complement receptor type three, CD11b/CD18, alpha m beta 2) may be purified in a form that is either capable or incapable of binding soluble, monomeric ligand and that "inactive" CR3 may be rendered capable of binding ligand by addition of an anti-CR3 mAb known as KIM-127 (Cai and Wright, JBC. 270: 14358, 1995). Here, we demonstrate that active CR3 may be rendered inactive by treatment of immobilized receptor with EDTA. EDTA-treated CR3 failed to bind ligand even in the presence of mM Ca2+ and Mg2+, suggesting that EDTA-treatment caused a change in the receptor that is not readily reversed. EDTA-treated receptor did, however, bind ligand upon addition of KIM-127 plus Mg2+ with an affinity (17.8 +/- 4.5 nM) similar to untreated, active receptor (12.5 +/- 4.7 nM). EDTA-treated CR3 thus exhibits the properties of inactive CR3, in which the ligand binding site is cryptic but subject to exposure by KIM-127. A candidate for the cryptic ligand binding site is the I-domain, a Mg2+-binding region in the alpha chain of CR3. We found that monomeric C3bi binds directly to recombinant I-domain in a Mg(2+)-dependent fashion with an affinity of 300 +/- 113 nM. These results thus suggest that CR3 may be inactivated by removing tightly bound divalent cation from a cryptic site in CR3.     

High-pH inclined stress corrosion cracking in Australian and Canadian gas pipeline X65 steels

High-pH stress corrosion cracking is a form of environmental degradation of gas pipeline steels. The crack path is intergranular by nature and typically perpendicular to the maximum applied (hoop) stress (i.e. perpendicular to the pipe outer surface). Some unusual instances of cracks have been observed in Canadian and Australian X65 pipes, where cracks grow away from the perpendicular for considerable distances. This paper presents a comparative study in terms of crack morphology, mechanical properties and crystallographic texture for these Australian and Canadian pipe steels. It is shown that the crack morphologies are quite similar, the main difference being the angle at which the cracks propagate into the material. This difference could be explained by the different through-wall texture and grain aspect ratio measured in the two materials. The interdependency of crack tip plasticity, crack tip electrochemistry and anisotropy in microstructural texture seems to heavily affect the resulting inclined crack path.     

Engineering TCP transmission and retransmission mechanisms for wireless networks

Transmission Control Protocol (TCP) provides mechanisms for reliable data communications. Although it works well in wired networks, it fails to offer satisfactory performance in lossy and wireless environments. And in the multi-hop wireless infrastructure, packet delivery suffers high cumulative loss rate if traveling over multiple wireless hops. The Selective acknowledgment (SACK) is one header option that might be used to combat segment corruptions in air channels. In this paper, an alternative set of flow control mechanisms is proposed to handle high packet loss rate in a wireless medium. Using a measurement-based mechanism, sustainable segment delivery is achievable through a novel size-reduction method. Multiple segment retransmission mechanisms are introduced to reduce successive timeout events. One single byte loss is sufficient to waste all other bytes in a file received at a destination. That is, a good TCP flow control mechanism should provide a high successful file transmission completion rate, and this is set as our design goal. Through thorough simulations, our proposed multi-segment retransmission designs perform with higher successful file transfer rate and fewer timeout events than NewReno and SACK under a wide range of packet loss probabilities.     

Fault diagnosis of car assembly line based on fuzzy wavelet kernel support vector classifier machine and modified genetic algorithm

This paper presents a new version of fuzzy wavelet support vector classifier machine to diagnosing the nonlinear fuzzy fault system with multi-dimensional input variables. Since there exist problems of finite samples and uncertain data in complex fuzzy fault system, the input and output variables are described as fuzzy numbers. Then by integrating the fuzzy theory, wavelet analysis theory and v-support vector classifier machine, fuzzy wavelet v-support vector classifier machine (FWv-SVCM) is proposed. To seek the optimal parameters of FWv-SVCM, genetic algorithm (GA) is also applied to optimize unknown parameters of FWv-SVCM. A diagnosing method based on FWv-SVCM and GA is put forward. The results of the application in car assembly line diagnosis confirm the feasibility and the validity of the diagnosing method. Compared with the traditional model and other SVCM methods, FWv-SVCM method requires fewer samples and has better diagnosing precision.     

The role of electronic pocket dictionaries as an English learning tool among Chinese students

This study addressed the role of electronic pocket dictionaries as a language learning tool among university students in Hong Kong and Taiwan. The target groups included engineering and humanities students at both undergraduate and graduate level. Speed of reference was found to be the main motivator for using an electronic pocket dictionary. Next, the functionality used was found to be connected to the language proficiency of the learner. Finally, multimedia content was ranked least important. The results of this study have implications for the design of electronic dictionaries and for the teaching of second languages with electronic dictionaries. In particular, device developers should focus on improving the accessing speed and pay less attention to multimedia functionality. Educators should ensure that the device functionality matches the language proficiency level of the students.     

Visualising Errors in Animal Pedigree Genotype Data

Genetic analysis of a breeding animal population involves determining the inheritance pattern of genotypes for multiple genetic markers across the individuals in the population pedigree structure. However, experimental pedigree genotype data invariably contains errors in both the pedigree structure and in the associated individual genotypes, introducing inconsistencies into the dataset, rendering them useless for further analysis. The resolution of these errors requires consideration of genotype inheritance patterns in the context of the pedigree structure. Existing pedigree visualisations are typically more suited to human pedigrees and are less suitable for large complex animal pedigrees which may exhibit cross generational inbreeding. Similarly, table‐based viewers of genotype marker data can highlight where errors become apparent but lack the functionality and interactive visual feedback to allow users to locate the origin of errors within the pedigree. In this paper, we detail a design study steered by biologists who work with pedigree data, and describe successive iterations through approaches and prototypes for viewing genotyping errors in the context of a displayed pedigree. We describe how each approach performs with real pedigree genotype data and why eventually we deemed them unsuitable. Finally, a novel prototype visualisation for pedigrees, which we term the ‘sandwich view’, is detailed and we demonstrate how the approach effectively communicates errors in the pedigree context, supporting the biologist in the error identification task.