采油树平板闸阀柔性密封圈结构优化设计

为了提高采油树平板闸阀密封圈的密封性能,在泛塞封的基础上,设计一种密封圈本体唇边开有锯齿状凸起的新型柔性密封结构;运用有限元分析方法模拟密封圈的工作状况,分析柔性密封结构特性参数对密封圈密封性能的影响,获得不同柔性密封圈结构参数下密封面间接触应力分布规律,并对新型密封结构进行优化。结果表明:密封面间最大接触应力随唇边锯齿数量、唇边夹角度数的增大而增大,随唇谷夹角度数的增大而减小;新型密封结构选择锯齿数量为3、唇边夹角为20°、唇谷夹角为30°的特性参数时,其最大接触应力比常规Y形密封圈提高了15倍;新型柔性密封结构的密封圈与阀杆、阀盖壁面间接触应力比常规Y形密封圈有显著提高,提高了密封圈的密封性能。     

Bio‐Based,Self‐Condensed Polyols

A new method for the synthesis of high‐molar‐mass (MM), bio‐based polyols for elastic polyurethanes is developed. This process is based on the self‐condensation of low MM polyols (M_n ≈ 1000) and vacuum removal of the resulting glycerol. Self‐condensation products are hyperbranched estolide polyols with average MMs close to 3000 and hydroxyl numbers in the range of 40–95 mg KOH g^?1. Three polyols, one with primary and two with secondary hydroxyls and different functionalities, are studied. The transesterification proceeded much faster with primary hydroxyls, leading to high‐viscosity products. The effect of functionality and reactivity of starting polyols on properties is discussed. Practical applications: The process is useful for upgrading the existing natural oil‐based polyols to higher MM, lower OH number and variable‐functionality polyols, for expanding application in the urethane field. The process is simple, involving just an oil‐based polyol, a catalyst, and heating under vacuum.     

Autonomously Self‐Reporting Hard Coatings: Tracking the Temporal Oxidation Behavior of TiN by In Situ Sheet Resistance Measurements

Monitoring the structural health and integrity of coated components is of vital importance to increase their lifetime and the overall sustainability of the targeted applications. Here, the temporal oxidation behavior of TiN thin films is tracked using in situ sheet resistance measurements. Based on correlative film morphology, structure, and local composition data, it is evident that observed resistance changes are caused by oxidation of TiN. Thickness measurements of the remaining TiN under the oxide layer are in very good agreement with thicknesses deduced from in situ sheet resistance measurements. Hence, the in situ measured sheet resistance is an autonomous self‐reporting property useful for tracking the temporal oxidation behavior of TiN coatings.     

Can Tolerant Diatom Taxa be Used for Effective Assessments of Human Pressure?

Because lately the low bioindicative value of tolerant species from different taxonomic groups is often questioned, in this study, we hypothesized that tolerant diatoms may be used for effective temporal assessments of human pressure. We tested this on the lowland Bzura River in central Poland, on 156 diatom samples (DSs) from two study periods of 1972 with extremely severe point‐source water pollution and of 2002–2004, where the complex wastewater management in the river catchment improved water quality considerably. Out of the total 295 diatom species recorded in the samples, only 133 tolerant ones were included in the study. Patterns in their abundance were recognized with a Kohonen artificial neural network (self‐organizing map, SOM), whereas the species significantly associated with each SOM cluster of diatom samples were identified with the indicator value (IndVal) index and the Monte Carlo test. If the hypothesis tested was not supported, the assignation of DSs to the SOM clusters would be random. However, the separation of DSs from 1972 and 2002–2004 was almost perfect because the number of exceptions was as low as 4.5%. In addition, the relatively high number (64 out of 133) of tolerant species significantly associated with any SOM cluster (and respective environmental conditions at sites from which samples assigned to it come) supports the hypothesis tested. This means that almost half of the studied species are not evenly distributed in particular clusters as might be expected for highly tolerant species. The study proves that the abundances of many diatom species, currently classified as tolerant, carry quite precise information on the differences in the quality of the environment, and indicates those tolerant diatom species whose bioindicative potential may be highest. Copyright © 2014 John Wiley & Sons, Ltd.     

Study on the self‐assembly property of type I collagen prepared from tilapia (Oreochromis niloticus) skin by different extraction methods

Type I collagen was prepared from tilapia (Oreochromis niloticus) skin by acetic acid and pepsin process at 4 °C, respectively (ASC and PSC), and hot‐water method separately at 25, 35 and 45 °C (C‐25, C‐35 and C‐45). Their structure and self‐assembly property were discussed. SDS‐PAGE patterns suggested that pepsin hydrolysis and the 35 and 45 °C extraction produced collagen with much reduced proportions of α‐ and β‐chains. Fourier transform infrared spectroscopy spectra revealed that pepsin hydrolysis did not change the conformation of collagen, but higher extraction temperature did. Self‐assembly curves and atomic force microscopy (AFM) observations showed that only ASC, PSC and C‐25 could self‐assemble into fibrils with D‐periodicity, but the reconstruction rate of C‐25 was lower. Besides, PSC had relatively higher resolution ratio compared with others. Overall, pepsin‐extracted collagen displayed higher solubility and better fibril‐forming capacity, having the potential of applying in biomaterials and food‐packaging materials.     

Self‐assembled centimetre‐sized rods obtained in the oxidation of o‐phenylenediamine and aniline

Morphologically well‐defined rods of approximately 1 cm in length are effectively and economically obtained by mixing ortho‐phenylenediamine (30 mmol L^?1) with ammonium persulfate (12.5 mmol L^?1) in an acidic solution (0.37 mol L^?1 HCl) at room temperature with and without the presence of 50 mmol L^?1 aniline. These self‐assembled, morphologically uniform products can be potentially scaled up and used as morphological templates to fabricate well‐defined structures of other materials such as conducting polymers. The products were characterized using Raman, UV‐visible, high‐resolution NMR (¹H and ¹³C) and mass spectroscopies, X‐ray diffraction, scanning electron microscopy and elemental analysis. Apart from certain differences in visual appearance and in X‐ray diffractograms, other analytical data suggest that there are no structural changes upon addition of aniline into the reaction mixture. NMR and mass spectra imply that all syntheses carried out either with or without aniline result in a mixture of two products, attributed to 2,3‐phenazinediamine and 3‐aminophenazin‐2‐ol. A formation mechanism based on hydrogen bonding and π–π stacking has been proposed. © 2015 Society of Chemical Industry     

Remote Steering of Self‐Propelling Microcircuits by Modulated Electric Field

The principles and design of “active” self‐propelling particles that can convert energy, move directionally on their own, and perform a certain function is an emerging multidisciplinary research field, with high potential for future technologies. A simple and effective technique is presented for on‐demand steering of self‐propelling microdiodes that move electroosmotically on water surface, while supplied with energy by an external alternating (AC) field. It is demonstrated how one can control remotely the direction of diode locomotion by electronically modifying the applied AC signal. The swimming diodes change their direction of motion when a wave asymmetry (equivalent to a DC offset) is introduced into the signal. The data analysis shows that the ability to control and reverse the direction of motion is a result of the electrostatic torque between the asymmetrically polarized diodes and the ionic charges redistributed in the vessel. This novel principle of electrical signal‐coded steering of active functional devices, such as diodes and microcircuits, can find applications in motile sensors, MEMs, and microrobotics.     

A Thermodynamics Model for the Emergence of a Stripe‐like Binary SAM on a Nanoparticle Surface

It has been under debate if a self‐assembled monolayer (SAM) with two immiscible ligands of different chain lengths and/or bulkiness can form a stripe‐like pattern on a nanoparticle (NP) surface. The entropic gain upon such pattern formation due to difference in chain lengths and/or bulkiness has been proposed as the driving force in literature. Using atomistic discrete molecular dynamics simulations it is shown that stripe‐like pattern could indeed emerge, but only for a subset of binary SAM systems. In addition to entropic contributions, the formation of a striped pattern also strongly depends upon interligand interactions governed by the physicochemical properties of the ligand constituents. Due to the interplay between entropy and enthalpy, a binary SAM system can be categorized into three different types depending on whether and under what condition a striped pattern can emerge. The results help clarify the ongoing debate and our proposed principle can aid in the engineering of novel binary SAMs on a NP surface.