LDD方法在提高电路工作电压中的应用研究

研究了利用轻掺杂漏结构来制作高电源电压器件的工艺方法。分析了ＬＤＤ结构参数对器件击穿特性的影响，并结合实验结果对Ｎ＾－区的注入剂量，长度及引入的串联电阻进行了优化设计。     

减压渣油与FCC油浆共炭化的化学组成变化

考察了齐鲁石化胜利炼油厂催化油浆（FCC）和胜利减压渣油（VR）在490℃，0.8MPa下不同混合比的原料和不同反应时间的中间产物的HS、TS、PS、P及其1h中间产物的HS和TS的^1H-NMR。数据结果反映了体系的反应速度。掺入FCC油浆抑制了VR的反应活性，降低了体系的反应速度，增加了基质的溶解度；1h中间产物的组成结构更接近于原料及反应体系的反应性和基质的溶解度；1h中间产物的芳香度越高，取代基越少，侧链越短，基质对VR中的活性反应组分在炭化早期生成的高度缩合物质的溶解度越大。     

Comparison of activities in selective catalytic reduction of NOx by C3H8 over Co/MFI, Fe/MFI, and H/MFI zeolite catalysts

The Co/MFI(SiO₂/Al₂O₃ = 30) were prepared by a precipitation method with NaOCl in alkali solutions exhibited high activities to N₂ at 250 °C for the selective catalytic reduction (SCR) of NO_x. These catalysts showed two UV–vis bands at 700 and 400 nm, indicating the presence of octahedral Co(III) as well as tetrahedral Co(II). The high SCR activity over such Co(III, II)/MFI(30) seems to come from Co(III)---O moieties. The Co(II)MFI(30) catalysts prepared from Co(II)Cl₂ exhibited low SCR activities due to the presence of tetrahedral Co(II) ions in MFI. Less CO formation occurred over Co/MFI catalysts. The Fe/MFI(30) catalyst exhibited high activity due to the presence of some Fe---O species in MFI but more amount of CO were produced during SCR. H/MFI(30) catalyst exhibited a good SCR activity. However, more amount of carbonaceous deposits were produced on it. The correlation between acid concentration and SCR activity was discussed over H/MFIs.     

Imaging the domain pattern of the canted magnetization state in Co/Pt multilayer films

The exact magnetization pattern of magnetic films close to a spin-reorientation transition is difficult to analyze due to the intrinsically three-dimensional (3d) variation of the orientation of the local magnetization. We present a technique how this can be performed, based on the analysis of high quality 2d polarization maps from a single scanning electron microscope with polarization analysis (SEMPA) measurement with tilted sample. The key tool is the statistical distribution of all occurring polarization doublets, visualized in a 2d histogram plot. From the shape of the distribution the type of transition—canted-phase, or coexisting phases—can be inferred. For the canted-phase state, the canting angle can be accurately determined from geometrical considerations. With help of the histogram the image data can be analyzed and the three components of the magnetization can be calculated for most points of the image. For a Co/Pt multilayer film we found a cone state. The magnetization forms a complex pattern consisting of out-of-plane domains while the in-plane magnetization shows a maze pattern.     

低掺杂浓度Nd:YVO4激光器的输出特性研究

在对Nd:YVO_4晶体的掺杂浓度和晶体长度对激光器性能的影响进行了分析后,报道了利用掺杂浓度为0.3at％,通光长度为10mm的Nd:YVO_4晶体作为增益介质,带光纤耦合的激光二极管端面抽运的Nd:YVO_4激光器。在抽运功率为27.365W时,获得了14.85W的TEM_(00)模输出,光一光转换效率为60.49％,斜效率达64.5％。     

镨掺杂分布对1.3μm光纤放大器特性影响

对掺氟化镨玻璃光纤放大器的小信号增益，用广义的高斯近似公式可获得精确的分析表达。文中研究了限制光纤芯层中央部分的镨掺杂对光纤放大器特性的影响，结果发现限制镨掺杂分布能改进光纤放大器的工作效率，且截止波长比芯层全部均匀掺镨的光纤更长。     

镍代钴矿用硬质合金的新进展

概述了镍代钴矿用硬质合金的国内外进展情况．     

溶胶–凝胶法制备ATO-SiO_2抗静电复合薄膜的特性研究

采用两步溶胶–凝胶法制备出 ATO(掺锑氧化锡)-SiO_2复合抗静电薄膜。通过 DTA-TG、XRD、SEM 对 薄膜的结构和形貌进行了表征,结果表明:抗静电复合薄膜表面均匀致密。薄膜中 SiO_2为无定形结构,ATO 的衍射峰 与 SnO_2一致。研究了 SnO_2的含量对薄膜导电性能、结合强度和透过率的影响,发现随 SnO_2含量增加 ?(SnO_2/ SiO_2)从 5 至 12.5,薄膜的表面电阻降低(从 1010ù/□降低到 108ù/□),薄膜的结合强度下降,薄膜的透过率降低(从 89.0%降至 84.2%),结合三方面性能,得出最佳 SnO_2的配比为:?(SnO_2/ SiO_2)=10。     

Production of silver‐doped analcime by isomorphous substitution technique

BACKGROUND: Metal‐exchanged zeolites have been reported to have significant limitations on cayalytic activity, such as counterbalancing the negative framework charges and limitation of active space. Alternative methods of incorporating silver ions into the framework of zeolites are therefore necessary. This paper reports on a technique for producing silver doped analcime by isomorphous substitution of silver ion into the framework of analcime. The amount of aluminium in the gel composition was reduced by a factor of 5%, 10% and 20% and an equivalent amount of silver was added to the gel and treated in a conventional manner for zeolite crystallisation. Some of the aluminium in the reaction gel was replaced with the silver. The silver‐doped analcime samples where characterised by X‐ray diffraction (XRD), scanning electron microscopy (SEM), energy dispersive X‐rays (EDX), Fourier transform infrared (FTIR) spectroscopy and inductively coupled plasma‐atomic emission spectroscopy (ICP‐AES) analysis. RESULTS: The amount of silver ions loaded for each reduction of aluminium as determined by EDX were found to be (w/w) 0.29%, 1.41% and 2.10%, respectively. XRD pattern SEM images of the silver‐doped analcime showed the presence of zeolite P in addition to analcime. CONCLUSION: Silver‐doped analcime was successfully produced with different silver loadings and may exhibit higher anti‐microbial activities than silver‐exchanged counterparts. Copyright © 2008 Society of Chemical Industry