全文获取类型
收费全文 | 8124篇 |
免费 | 644篇 |
国内免费 | 447篇 |
专业分类
电工技术 | 163篇 |
综合类 | 437篇 |
化学工业 | 3225篇 |
金属工艺 | 844篇 |
机械仪表 | 277篇 |
建筑科学 | 199篇 |
矿业工程 | 113篇 |
能源动力 | 233篇 |
轻工业 | 447篇 |
水利工程 | 66篇 |
石油天然气 | 439篇 |
武器工业 | 43篇 |
无线电 | 520篇 |
一般工业技术 | 1033篇 |
冶金工业 | 435篇 |
原子能技术 | 262篇 |
自动化技术 | 479篇 |
出版年
2024年 | 21篇 |
2023年 | 134篇 |
2022年 | 198篇 |
2021年 | 216篇 |
2020年 | 252篇 |
2019年 | 253篇 |
2018年 | 189篇 |
2017年 | 254篇 |
2016年 | 311篇 |
2015年 | 284篇 |
2014年 | 356篇 |
2013年 | 441篇 |
2012年 | 456篇 |
2011年 | 511篇 |
2010年 | 472篇 |
2009年 | 436篇 |
2008年 | 402篇 |
2007年 | 512篇 |
2006年 | 472篇 |
2005年 | 379篇 |
2004年 | 329篇 |
2003年 | 340篇 |
2002年 | 346篇 |
2001年 | 320篇 |
2000年 | 274篇 |
1999年 | 229篇 |
1998年 | 155篇 |
1997年 | 129篇 |
1996年 | 102篇 |
1995年 | 98篇 |
1994年 | 53篇 |
1993年 | 44篇 |
1992年 | 37篇 |
1991年 | 37篇 |
1990年 | 28篇 |
1989年 | 15篇 |
1988年 | 27篇 |
1987年 | 22篇 |
1986年 | 16篇 |
1985年 | 14篇 |
1984年 | 10篇 |
1983年 | 8篇 |
1982年 | 3篇 |
1981年 | 8篇 |
1980年 | 4篇 |
1979年 | 4篇 |
1977年 | 3篇 |
1975年 | 2篇 |
1972年 | 2篇 |
1951年 | 6篇 |
排序方式: 共有9215条查询结果,搜索用时 0 毫秒
1.
Si3N4 ceramic was jointed to itself using a filler alloy of Cu76.5Pd8.5Ti15, and the mechanical properties of the jointwere measured and analyzed. By using a filler alloy of Cu76.5Pd8.5Ti15, the SisN4/SisN4 joints were obtained bybrazing at 1373~1473 K f 相似文献
2.
M. Kaiarov E. Rudnayov J. Koval
ík J. Dusza M. Hnatko P. ajgalík A. Merstallinger 《Materialwissenschaft und Werkstofftechnik》2003,34(4):338-342
In the presented work some properties of a recently developed Si3N4/SiC micro/nanocomposite have been investigated. The material was tested using a pin on disc configuration. Under unlubricated sliding conditions using Si3N4 pin at 50 % humidity, the friction coefficient was in the range of 0,6 ‐ 0,7. The reduction of humidity resulted in a lower coefficient of friction, in vacuum the coefficient of friction had a value of about 0,6. The wear resistance in vacuum was significantly lower then that in air. The wear patterns on the Si3N4+SiC disc revealed that mechanical fracture was the wear controlling mechanism. Creep tests were realized in four point bending configuration in the temperature interval 1200‐1400 °C at stresses 50,100 and 150 MPa and the minimal creep deformation rate was established for each stress level. The activation energy, established from the minimal creep deformation had a value of about 360 kJ/mol and the stress exponent values were in the range of 0.8‐1.28. From the achieved stress exponents it can be assumed that under the studied load/temperature conditions the diffusion creep was the most probable creep controlling mechanism. 相似文献
3.
A novel series of temperature‐sensitive poly[(N‐isopropylacrylamide)‐co‐(ethyl methacrylate)] (p(NIPAM‐co‐EMA)) microgels was prepared by the surfactant‐free radical polymerization of N‐isopropylacrylamide (NIPAM) with ethyl methacrylate (EMA). The shape, size dispersity and volume‐phase transition behavior of the microgels were investigated by transmission electron microscopy (TEM), ultraviolet–visible (UV–Vis) spectroscopy, dynamic light scattering (DLS) and differential scanning calorimetry (DSC). The transmission electron micrographs and DLS results showed that microgels with narrow distributions were prepared. It was shown from UV–Vis, DLS and DSC measurements that the volume‐phase transition temperature (VPTT) of the p(NIPAM‐co‐EMA) microgels decreased with increasing incorporation of EMA, but the temperature‐sensitivity was impaired when more EMA was incorporated, causing the volume‐phase transition of the microgels to become more continuous. It is noteworthy that incorporation of moderate amounts of EMA could not only lower the VPTT but also enhance the temperature‐sensitivity of the microgels. The reason for this phenomenon could be attributed to changes in the complicated interactions between the various molecules. Copyright © 2004 Society of Chemical Industry 相似文献
4.
单微乳液中制备Ag/TS-1及丙烯气相环氧化 总被引:2,自引:0,他引:2
采用N2H4还原含AgNO3的单微乳液制备了Ag/TS-1催化剂。TEM表征结果表明,Ag高度分散于TS-1之上。以H2、O2存在下的丙烯气相环氧化为探针反应,考察了Ag/TS-1的催化性能。结果表明,采用Ag/TS-1为催化剂,Ag的负载量为1%(质量分数,下同),823 K焙烧后,373 K下反应30 min时,丙烯转化率为1.69%,环氧丙烷(Propylene oxide,PO)选择性为93.2%。当Ag的负载量超过2%时,反应过程中生成大量的热,造成PO的选择性下降。采用Ag的负载量为8%的Ag/TS-1催化剂,消除热效应后,丙烯的转化率为2.46%.PO的选择性为79.2%。 相似文献
5.
The effect of rare earth oxides Y203 or Ce02 on sintering properties of Si3N4 ceramics was studied and the mechanism of assisting action during sintering was analyzed. The results in dicate that the best sintering properties appear in Si3N4 ceramics with 5% Y203 or 8% CeO2. Secondary crystallites are formed at grain boundaries after heat treatment,which decreases the amount of glass phase and contributes to the improvement of high-temperature mechanical properties of silicon nitride. 相似文献
6.
VK Tzitzios V Georgakilas TN Angelidis 《Journal of chemical technology and biotechnology (Oxford, Oxfordshire : 1986)》2005,80(6):699-704
A study of nitrous oxide (N2O) reduction with methane (CH4) and propene (C3H6) in the presence of oxygen (5%) over Ag/Al2O3, Rh/Al2O3 and Ag–Rh/Al2O3 catalysts, with Ag and Rh loadings of 5 wt% and 0.05 wt% respectively, has been performed. From the results, it was observed that the Ag–Rh bimetallic catalyst was the most active for both nitrous oxide removal (more than 95%) and hydrocarbon oxidation. This high activity seems to be connected with a synergistic effect between Ag and Rh. The findings from X‐ray diffraction and X‐ray photoelectron spectroscopy studies showed also, that there were no strong interactions (eg alloying) between Ag and Rh. Copyright © 2005 Society of Chemical Industry 相似文献
7.
设{Z,(W)}是定义在概率空间上的独立的随机变量序列,Z(W)具有方差为期望E(Zn)=0.本文证明了对任意算数序列{bn}及任意的存在充分大的整数N>0使当N'>N″>N时.有此不等式在随机级数研究中有重要作用. 相似文献
8.
Preparation and Properties of Sintering Additives Coated Si3N4 from Heterogeneous Nucleation Processing 总被引:1,自引:0,他引:1
The sintering additives such as Al2O3 and /or Y2O3 were coated on the surfaces of Si3N4 particles via heterogeneous nucleation processing using a buffered pH solution as the precipitation reagent .They nucleated and grew only on the surfaces of Si3N4 and did not form sol particles in solution by TEM observation .The isoelectric point(IEP) of coated Si3N4 was different from that of as-received Si3N4.The IEP of Al(OH)3-coated Si3N4 occurred at pH8.4, which is close to that of alumina .When Al(OH)3-coated Si3N4 particles were coated with Y(OH)3,the IEP of coated Si3N4 powder shifted from pH8.4 to pH9.2 ,similar to that of yttria.In addition ,the rheological data showed that Al2O3 and /or Y2O3 coated Si3N4 suspension is nearly Newtonian and that added Si3N4 suspension shows a shear rate thinning behavior. 相似文献
9.
10.
J.-P. Croisille 《Computing》2006,78(4):329-353
We introduce a new box-scheme, called ``hermitian box-scheme' on the model of the one-dimensional Poisson problem. The scheme
combines features of the box-scheme of Keller, [20], [13], with the hermitian approximation of the gradient on a compact stencil,
which is characteristic of compact schemes, [9], [21]. The resulting scheme is proved to be 4th order accurate for the primitive
unknown u and its gradient p. The proved convergence rate is 1.5 for (u,p) in the discrete L
2 norm. The connection with a non standard mixed finite element method is given. Finally, numerical results are displayed on
pertinent 1-D elliptic problems with high contrasts in the ellipticity, showing in practice convergence rates ranging from
1 to 2.5 in the discrete H
1 norm.
This work has been performed with the support of the GDR MOMAS, (ANDRA, CEA, EDF, BRGM and CNRS): Modélisation pour le stockage des déchets radioactifs. The author thanks especially A. Bourgeat for his encouragements and his interest in this work. 相似文献