Formation of high-density scintillation ceramic from LuAG:Ce + Lu2O3 powders obtained by co-precipitation method

The results of formation of the high density effective scintillation ceramics consisting of two compounds of the cubic symmetry, LuAG:Ce and Lu₂O₃ (LuAG:Ce + Lu₂O₃), are described. Powders of a novel material LuAG:Ce + Lu₂O₃ were synthesized by co-precipitation method. The introduction of Lu₂O₃ into LuAG:Ce was shown to increase the density of the ceramics obtained and modify its scintillation properties.     

Electroluminescent zinc sulphide devices produced by sol-gel processing

Zinc sulphide thin film electroluminescent devices doped with Mn or Tb have been produced on p-type Si substrates using a process in which doped zinc oxide films are deposited by a sol-gel drain coating method from a solution of zinc acetate containing a manganese or terbium dopant. The films are then converted to ZnS by heating them in an atmosphere containing hydrogen sulphide which replaces the oxygyn with sulphur. The composition, crystalline structure and optical properties of films have shown that complete conversion from the oxide to the sulphide takes place. The luminescent characteristics of the devices so produced have been measured as a function of the doping concentrations, film thickness, insulator thickness and driving voltage and frequency. It has been found that yellow or green luminescence can be obtained using Mn or Tb doping respectively.     

Ionoluminescence decay measured with single ions

A new ion beam analysis-based, single ion technique called the time to first photon has been developed to measure the decay of the luminescence signal of phosphors. Such measurements are currently needed to study luminescence decay mechanisms following high-density excitations and to identify strongly luminescent phosphor coatings with short lifetimes for ion photon emission microscopy (IPEM). The samples for this technique consist of thin phosphor layers placed or coated on the surface of PIN diodes. Single ions from an accelerator strike this sample and simultaneously create ion beam induced luminescence (IBIL) from the phosphor that is measured by a single-photon-detector, and an ion beam induced charge collection (IBICC) signal in the PIN diode. In this case, the IBICC signal provides the start pulse and the IBIL signal the stop pulse to a time to amplitude converter. It is straightforward to show that this approach also measures a signal proportional to activity versus time with an accuracy of 5% as long as the number of detected photons per ion is less than 0.1, which usually requires the use of absorbers for the IBIL detector or electronic discrimination for the IBIL signals. Details of the new analysis are given together with examples of luminescence decay measurements of several ceramic phosphors being considered to coat IPEM samples. IPEM is currently being developed at Sandia National Laboratory (SNL), the University of North Texas in Denton, and the Universities and INFN of Padova and Torino.     

Obtaining Characteristic 4f–4f Luminescence from Rare Earth Organic Chelates

We report a study of a series of heavy rare earth tris‐8‐hydroxyquinolines (REQ₃s), using UV‐visible absorption spectroscopy, infrared absorption spectroscopy, and photoluminescence (PL) measurements. We show that the heavy REQ₃s are all chemically similar to each other and to aluminium tris‐8‐hydroxyquinoline, at least in terms of the ligand behavior. Characteristic rare earth 4f–4f luminescence is only observed for ErQ₃ and YbQ₃ due to the relatively low energy of the ligand triplet state. We show that a triplet transfer mechanism cannot be responsible for the observed Yb 4f–4f luminescence observed in YbQ₃. Instead, an internal chemiluminescent process is shown to be energetically favorable. The thin film PL spectra of all the heavy REQ₃s are dominated by triplet emission, except for that of ErQ₃, for which transfer to the Er³⁺ ion represents an efficient alternative. The PL spectra of powder samples, which would be expected to consist of approximately equal amounts of both isomers, are dominated by singlet emission. This is in contrast to the results from the thin films, and suggests that the isomer which predominates in the thin films has a much higher intersystem crossing rate than the other isomer.     

Perylene derivative sensitized multi-walled carbon nanotube thin film

Perylene-sensitized multi-walled carbon nanotubes (PV-MWNT) have been prepared by a π-stacking between nanotubes and perylene derivatives, N,N′-diphenyl glyoxaline-3,4,9,10-perylene tetracarboxylic acid diacidamide (PV). The resultant nanocomposites have been characterized by transmission electron microscope (TEM), UV-vis absorption, photoluminescence (PL) and photocurrent spectra. Long range ordering can be observed in the form of PV-MWNT via π-stacking by TEM. Red-shift in the optical spectra consisting of the UV-vis absorption and PL spectra with the attraction of PV on the surface of the MWNTs were observed. The evident quenching in PL spectra of PV-MWNT was ascribed to the absorption and transfer of recombination energy by MWNT. Photosensitivity spectra demonstrated an increasing photocurrent in the ultraviolet region and a broadening photosensitivity in the red spectral region for solar cells based on PV-MWNT.     

[Zn(BDC)(H2O)2]n: a novel blue luminescent coordination polymer constructed from BDC-bridged 1-D chains via interchain hydrogen bonds (BDC = 1,4-benzenedicarboxylate)

A novel coordination polymer [Zn(BDC)(H₂O)₂]_n 1 (where BDC = 1,4-benzenedicarboxylate), has been synthesized and characterized by X-ray diffraction. 1 crystallizes in the monoclinic space group C2/c, a=15.09(2) Å, b=5.058(7) Å, c=12.196(16) Å, β=103.62(2)°, , Z=4. The most striking feature of 1 is that it consists of a high-dimensional network structure constructed from BDC-bridged 1-D chains via interchain hydrogen bonds. The coordination sphere of the zinc(II) ion is a distorted tetrahedron completed by four oxygen atoms from two water molecules and two BDC ligands. BDC adopts the bis-monodentated (syn–anti) coordination mode linking two adjacent zinc(II) ions. 1 shows strong blue photoluminescence as the result of the fluorescence from the intraligand emission excited state.     

Luminescent properties of Sr2MgSi2O7 and Ca2MgSi2O7 long lasting phosphors activated by Eu, Dy

Long lasting afterglow phosphors Sr₂MgSi₂O₇:Eu,Dy and Ca₂MgSi₂O₇:Eu,Dy were prepared by solid-state reaction method. It is revealed by the results that both phosphors show two emission peaks that are caused by the different emitting centers Eu²⁺ held in the host lattice. Wavelength shift was observed due to the slight differences in the structure parameters of the two hosts. Investigation on afterglow property shows that Sr₂MgSi₂O₇:Eu,Dy phosphor held a better afterglow property than Ca₂MgSi₂O₇:Eu,Dy phosphor. Thermal simulated luminescence study indicates that the long afterglow is generated by a higher trap concentration formed by the co-doped rare earth ions within the host.