Thermal and transport properties of as-grown Ni-rich TiNi shape memory alloys

Electrical resistivity, Seebeck coefficient, specific heat and thermal conductivity measurements on the Ti_50−xNi_50+x (x = 0.0–1.6 at.%) shape memory alloys are performed to investigate their thermal and transport properties. In this study, anomalous features are observed in both cooling and heating cycles in all measured physical properties of the slightly Ni-rich TiNi alloys (x ≤ 1.0), corresponds to the transformation between the B19′ martensite and B2 austenite phases. Besides, the transition temperature is found to decrease gradually with increasing Ni content, and the driving force for the transition is also found to diminish slowly with the addition of excess Ni, as revealed by specific heat measurements. While the signature of martensitic transformation vanishes for the Ni-rich TiNi alloys with x ≥ 1.3, the characteristics of strain glass transition start to appear. The Seebeck coefficients of these TiNi alloys were found to be positive, suggesting the hole-type carriers dominate the thermoelectric transport. From the high-temperature Seebeck coefficients, the estimated value of Fermi energy ranges from ∼1.5 eV (Ti_48.4Ni_51.6) to ∼2.1 eV (Ti₅₀Ni₅₀), indicating the metallic nature of these alloys. In addition, the thermal conductivity of the slightly Ni-rich TiNi alloys with x ≤ 1.0 shows a distinct anomalous feature at the B19′ → B2 transition, likely due to the variation in lattice thermal conductivity.     

Theoretical study of a thermoelectric-assisted vapor compression cycle for air-source heat pump applications

This paper proposes a thermoelectric-assisted vapor compression cycle (TVCC) for applications in air-source heat pump systems which could enhance the heating capacity of the system. Performances of TVCC are calculated and then compared with that of basic vapor compression cycle (BVCC). The simulation results show that when coefficients of performance (COPs) of the two cycles are almost equal, the TVCC under maximum COP condition of the thermoelectric modules still performs better than BVCC by 13.0% in heating capacity through selecting the appropriate intermediate temperature. In addition, the TVCC can also achieve an improvement of 16.4%–21.7% in both the heating COP and capacity when compared with the BVCC with an assistant electric heater that is provided with the equivalent power input of thermoelectric heat exchanger. Thus, the TVCC could be beneficial to the applications in small heat pumps if there is always need for auxiliary electric heat.     

Charge transport and recombination in heterostructure organic light emitting transistors

Light-emitting field effect transistors (LEFETs) are a class of organic optoelectronic device capable of simultaneously delivering the electrical switching characteristics of a transistor and the light emission of a diode. We report on the temperature dependence of the charge transport and emissive properties in a model organic heterostructure LEFET system from 300 K to 135 K. We study parameters such as carrier mobility, brightness, and external quantum efficiency (EQE), and observe clear thermally activated behaviour for transport and injection. Overall, the EQE increases with decreasing temperature and conversely the brightness decreases. These contrary effects can be explained by a higher recombination efficiency occurring at lower temperatures, and this insight delivers new knowledge concerning the optimisation of both the transport and emissive properties in LEFETs.     

Ionic transport in amorphous anodic titania stabilised by incorporation of silicon species

Incorporation of silicon species from an alloy substrate into anodic titania is shown to stabilise the structure of the film, facilitating investigation of the ionic transport processes in amorphous titania grown at high efficiency. Thus, an amorphous anodic film developed on a sputtering-deposited Ti-6 at.%Si alloy formed to 100 V in phosphoric acid electrolyte in contrast to a partially crystalline film developed on relatively pure titanium at <20 V. Silicon species, which are immobile and act as marker species in the growing film, are present in the inner 58% of the film thickness. Evidently, the film material forms simultaneously at the film/electrolyte and alloy/film interfaces by co-operative transport of cations and anions, as is usual in amorphous anodic oxides. The phosphate anions incorporated from the electrolyte migrate inward at 0.34 times the rate of O²⁻ ions and hence are present in the outer 62% of the film thickness.     

铁路冷藏运输运价分析

本文对各种运输方式易腐货物的运价进行了比较分析,对铁路冷藏运输的现行运价和保本运价进行了讨论,提出了铁路冷藏运输运价改革的若干建议,可供铁路进行冷藏运输改革参考。     

20世纪的泥沙运动力学

在20世纪，泥沙运动力学的研究取得了不少突出的成绩，但与其他学科同时期的进展相比，发展还是比较缓慢的。按取得的进展来看，20世纪可分为两个阶段；在上半叶，有6项突破性进展，逐步积累，到1950年，Einstein集大成，提出了第1 个泥沙运动力学理论体系。在下半叶，进入了百家争鸣的时代，一些研究者提出了自己的泥沙运动理论体系，作者列举了8个有代表性的理论体系。受计算机时代的影响，从20世纪70年 代开始出现了根据大量实测资料，利用计算机进行回归分析而得出的阻力和输沙率公式，而不拘泥于发展新的理论。与此同时，一些与实际偏离较远的理论逐渐被淘汰。在21世纪，要搜集系统完整的资料，特别是近底层的资料，并拓宽研究领域到环境，生态等学科。     

Analysis of protein transport through the golgi in a reconstituted cell-free system

The processes which transport membrane proteins between compartments of the Golgi apparatus have been reconstituted in vitro using isolated Golgi fractions. This cell-free system allows a detailed analysis of protein transport not possible in intact cells. Transport of the membrane glycoprotein (G protein) of vesicular stomatitis virus (VSV) is measured from a “donor” to an “acceptor” Golgi fraction. The donor Golgi fraction is prepared from VSV-infected Chinese hamster ovary (CHO) mutant cells deficient in the glycosylation enzyme N-acetylglucosamine transferase I. “Acceptor” is prepared from uninfected wild-type CHO cells. Transport is measured by the addition of N-acetylglucosamine to G protein, which can occur only upon movement of G protein from donor to acceptor. Transport requires physiological pH and osmolarity, is dependent on nucleotide triphosphates, and is mediated by proteins both from cytosol and on the Golgi membranes. Protein movement is inhibited by the non-hydrolyzable GTP analogue, GTPγS. The process of transport proceeds through the budding, pinching off, targeting, and fusion of transport vesicles. In this system these vesicles are initially coated with a non-clathrin coat and are targeted with this coat intact. Several of the proteins which mediate transport have been characterized, and isolated to homogeneity. The successful development of this assay has led to the formulation of cell free assays for protein transport between other compartments. Comparison of these systems indicates that some common mechanisms of vesicular movement are used in transport between a variety of membrane compartments.     

Role of Ponded Turbidity Currents in Reservoir Trap Efficiency

The capacity to store water in a reservoir declines as it traps sediment. A river entering a reservoir forms a prograding delta. Coarse sediment (e.g., sand) deposits in the fluvial topset and avalanching foreset of the delta, and is typically trapped with an efficiency near 100%. The trap efficiency of fine sediment (e.g., mud), on the other hand, may be below 100%, because some of this sediment may pass out of the reservoir without settling out. Here, a model of trap efficiency of mud is developed in terms of the mechanics of a turbidity current that plunges on the foreset. The dam causes a sustained turbidity current to reflect and form a muddy pond bounded upstream by a hydraulic jump. If the interface of this muddy pond rises above any vent or overflow point at the dam, the trap efficiency of mud drops below 100%. A model of the coevolution of topset, foreset, and bottomset in a reservoir that captures the dynamics of the internal muddy pond is presented. Numerical implementation, comparison against an experiment, and application to a field-scale case provide the basis for a physical understanding of the processes that determine reservoir trap efficiency.     

Critical Shear Stress of Bimodal Sediment in Sand-Gravel Rivers

A new model for the critical shear stress and the transport of graded sediment is presented. The model is based on the size distribution of the bed surface and can be used to compute sediment transport rates in numerical simulations with an active layer model. This model makes a distinction between unimodal and bimodal sediments. It is assumed that all size fractions of unimodal sediments have the same critical shear stress while there is selective transport for the gravel fractions of bimodal sediments. A recently published laboratory transport data set is used to calibrate our model.     

Synthesis of 2,7‐Carbazolenevinylene‐Based Copolymers and Characterization of Their Photovoltaic Properties

New electroactive and photoactive conjugated copolymers consisting of alternating 2,7‐carbazole and oligothiophene moieties linked by vinylene groups have been developed. Different oligothiophene units have been introduced to study the relationship between the polymer structure and the electronic properties. The resulting copolymers are characterized by UV‐vis spectroscopy, size‐exclusion chromatography, and thermal and electrochemical analyses. Bulk heterojunction photovoltaic cells from different copolymers and a soluble fullerene derivative, [6,6]‐phenyl‐C₆₁ butyric acid methyl ester, have been fabricated, and promising preliminary results are obtained. For instance, non‐optimized devices using poly(N‐(4‐octyloxyphenyl)‐2,7‐carbazolenevinylene‐alt‐3″,4″‐dihexyl‐2,2′;5′,2″;5″,2″′;5″′,2″″‐quinquethiophenevinylene 1″,1″‐dioxide) as an absorbing and hole‐carrier semiconductor exhibit power conversion efficiency up to 0.8 % under air mass (AM) 1.5 illumination. These features make 2,7‐carbazolenevinylene‐based and related polymers attractive candidates for solar‐cell applications.